Stiffness and hardness gradients obtained by laser surface melting of an aged β-Ti alloy
Source abstract
Abstract
Abstract Components with variable stiffness have been attracting interest because of their potential for use in biomedical implants. Here, a β-titanium alloy aged under different conditions was subjected to laser surface melting (LSM). The high cooling rate typical of LSM avoided α-phase precipitation in the fusion zone (FZ) and heat-affected zone (HAZ) as the α precipitates were solid-solutioned into the β phase, producing a surface layer with full β phase over the aged substrate and reduced stiffness and hardness. The decrease in stiffness occurred independently of the aging condition used while the decrease in hardness was greater for the sample aged at the lower temperature as this had finer precipitates. A route involving aging at this lower temperature and LSM is proposed for use when a graded material combining a less rigid surface with the original core stiffness and strength is required, as in orthopedic implants.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Titanium Alloys Microstructure and Properties · Additive Manufacturing Materials and Processes · Metal and Thin Film Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (14)
Show source-provided references
1. Problem of stress shielding and improvement to the hip implant designs: a review10.3923/jms.2007.460.467 ↗
2. Influence of the elastic modulus on the osseointegration of dental implants10.3390/ma12060980 ↗
3. Improving stress shielding following total hip arthroplasty by using a femoral stem made of β type Ti-33.6Nb-4Sn with a Young’s modulus gradation10.1016/j.jbiomech.2017.08.017 ↗
4. M. Niinomi, Low Modulus Titanium Alloys for Inhibiting Bone Atrophy, in: Biomater. Sci. Eng., InTech, 2011. doi:10.5772/2454910.5772/24549 ↗
5. Surface stiffness gradient in Ti parts obtained by laser surface alloying with Cu and Nb10.1016/j.surfcoat.2016.04.025 ↗
6. Femoral hip stem prosthesis made of graded elastic modulus metastable β Ti alloy10.1016/j.matdes.2014.11.040 ↗
7. Effect of laser remelting on microstructural evolution and mechanical properties of Ti-35Nb-2Ta-3Zr alloy10.1016/j.matlet.2019.06.105 ↗
8. Effects of laser surface melting on Ti-30Nb-2Sn sintered alloy10.1002/adem.201500640 ↗
9. Lütjering · 2007
10. An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments10.1557/JMR.1992.1564 ↗
11. Ballistic impact behaviour of β-CEZ Ti alloy against 7.62 mm armour piercing projectiles10.1016/j.ijimpeng.2012.11.002 ↗
12. Less-rigid coating in Ti obtained by laser surface alloying with Nb10.1016/j.surfcoat.2018.04.038 ↗
13. Aging response of the Young’s modulus and mechanical properties of Ti-29Nb-13Ta-4.6Zr for biomedical applications10.1007/s11661-003-0230-x ↗
14. Influence of ageing temperature and heating rate on the properties and microstructure of β Ti alloy, Ti-6Cr-5Mo-5V-4Al10.1016/j.msea.2011.10.040 ↗