journal article·2018-01

Powder roll-compaction process for controlling grain orientation texture and size in spark plasma sintered carbides

Sagar Patel, Mathew Kuttolamadom

Materials Letters· Volume 211
Publisher page

Abstract

Abstract The objective of this work is to develop and evaluate a powder roll-compaction procedure for fabricating cemented carbides that enables control over its surface/sub-surface grain orientation texture and grain size. The primary motivation for this work is to gain the ability to impart spatial material (property) gradients in bulk hard materials and composites for the realization of bio-inspired designs of material-systems. For this study, measured mixtures of tungsten carbide (WC) and cobalt (Co) powders were subjected to pressurized roll-compaction operations to create (malleable) thin sheets, which were then stacked and spark plasma sintered to obtain bulk cemented WC-Co specimens. When using this procedure, it was observed through XRD results that the basal plane orientation texture was increased by about 21%, and that transitions in layer-by-layer carbide grain sizes could be reliably achieved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced materials and composites · Orthopaedic implants and arthroplasty · Powder Metallurgy Techniques and Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (14)

Show source-provided references
1. D.A. Tirrell, Biomaterials: Important Areas for Future Investment – A National Science Foundation Sponsored Workshop, NSF Headquarters, Arlington, VA, June 19–20, 2012.
2. Patel · 2016
3. S.D. Patel, M.A. Kuttolamadom, Grain Texture Manipulation & its Effect on the Tribological Response of Carbides (Extended Abstract), STLE Annual Meeting & Exhibition, 2016, Las Vegas, NV, 2016.
4. Morphology of WC grains in WC–Co alloys10.1016/j.msea.2007.09.019 ↗
5. Mannesson · 2011
6. Hardness of hexagonal tungsten carbide crystals as a function of orientation10.1016/j.actamat.2012.07.056 ↗
7. Orientation-dependent hardness and nanoindentation-induced deformation mechanisms of WC crystals10.1016/j.actamat.2014.09.048 ↗
8. Modeling the influence of orientation texture on the strength of WC-Co composites10.1111/j.1551-2916.2006.01381.x ↗
9. Preparation and properties of WC–Co textured components10.1179/mst.1991.7.5.472 ↗
10. Preparation of textured zinc oxide ceramics by extrusion and spark plasma sintering10.1179/174367606X115931 ↗
11. Fabrication of orientation-controlled bismuth-layer-structured ferroelectric ceramics by rolling-extended method and their piezoelectric properties10.2109/jcersj2.116.1304 ↗
12. Evolution of textured Ca0.85(LiCe)0.075Bi4Ti4O15 ceramics via templated grain growth using a rolling-extended method
13. Fabrication of grain-oriented MgO ceramics by the rolling-extended method10.2109/jcersj2.118.927 ↗
14. Study on parameter optimisation for field-assisted sintering of fully-dense, near-nano WC–12Co10.1016/j.ijrmhm.2014.04.009 ↗