journal article·2021-12-01Open access

Numerical study on the plastic deformation behavior of AZ31 magnesium alloy under different loading conditions

Yuyu Li, Bowen Yang, Tingzhuang Han, Zhibing Chu, Chun Xue, Qianhua Yang, Xiaodong Zhao, Hong Gao

Materials Research Express· Volume 8· Issue 12

Abstract

Abstract Based on the stress characteristics of the instantaneous cross-section deformation of the wall reducing section during the cold rolling of two-roll Pilger pipes, the rectangular samples with 0° and 90° to the extrusion direction (ED) were cut from the extruded AZ31 magnesium alloy bar for 3% pre-deformation test to simulate its stress state equivalently. The sample was then cut from the pre-deformed sample by wire cutting for secondary compression, and the sample that is not pre-deformed is selected. The mechanical behavior and texture evolution of AZ31 magnesium alloy under different loading conditions were respectively studied by EBSD experiment and VPSC simulation. Results show that the true stress–strain curve and texture evolution characteristics of AZ31 magnesium alloy during the secondary compression process are in good agreement with the prediction of the VPSC model. The secondary compression behavior can be effectively explained by the relative activity of the deformation modes. The pre-deformation in the ∥ED (⊥ED) direction is conducive to the shift of the pole density of the {0001} basal surface texture to the positive and negative directions of the ED (TD). The pre-deformed sample exhibits a higher yield strength than the non-pre-deformed sample in the same loading direction. The high ductility of magnesium alloys can be achieved by activating pyramidal 〈c + a〉 slippage.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (37)

Show source-provided references
1. Recent developments and applications on high-performance cast magnesium rare-earth alloys10.1016/j.jma.2020.06.021 ↗
2. Anisotropy, tension-compression asymmetry and texture evolution of a rare-earth-containing magnesium alloy sheet, ZEK100, at different strain rates and temperatures: Experiments and modeling10.1016/j.ijplas.2017.04.006 ↗
3. Recent research and developments on wrought magnesium alloys10.1016/j.jma.2017.09.001 ↗
4. On the evolution of microstructure, texture and corrosion behavior of a hot-rolled and annealed AZ31 alloy10.1016/j.matchemphys.2021.124598 ↗
5. Mechanical behavior and microstructural evolution in rolled Mg-3Al-1Zn-0.5Mn alloy under large strain simple shear10.1016/j.msea.2017.11.123 ↗
6. Combined effects of anisotropy and tension–compression asymmetry on the torsional response of AZ31 Mg10.1016/j.ijsolstr.2015.01.001 ↗
7. Enhancing compressive mechanical properties of rolled AZ31 Mg alloy plates by pre-compression10.1016/j.msea.2019.138686 ↗
8. Enhanced stretch formability of AZ31 magnesium alloy thin sheet by pre-crossed twinning lamellas induced static recrystallizations10.1016/j.jmatprotec.2017.11.052 ↗
9. Inhibitory effects of prefabricated crown on edge crack of rolled AZ31 magnesium alloy plate10.1016/j.jmatprotec.2017.01.034 ↗
10. Improving the room temperature stretch formability of a Mg alloy thin sheet by pre-twinning10.1016/j.msea.2015.12.070 ↗
11. Enhancing the strength of rolled ZK60 alloys via the combined use of twinning deformation and aging treatment10.1016/j.msea.2013.06.047 ↗
12. Improved mechanical properties of AZ31 magnesium alloy plates by pre-rolling followed by warm compression10.1016/j.msea.2014.09.066 ↗
13. The effects of pre-strain and subsequent annealing on the yielding behavior in a rolled magnesium alloy10.1007/s11665-014-1284-1 ↗
14. Mechanical response of AZ31B magnesium alloy: experimental characterization and material modeling considering proportional loading at room temperature10.1016/j.ijplas.2013.10.006 ↗
15. A crystal plasticity model for hexagonal close packed (HCP) crystals including twinning and de-twinning mechanisms10.1016/j.ijplas.2013.02.016 ↗
16. Modeling the deformation behavior of a rolled Mg alloy with the EVPSC-TDT model10.1016/j.msea.2016.11.027 ↗
17. In situ measurements of texture variations during a tensile loading of Mg-alloy AM20 using synchrotron X-ray radiation10.1016/j.scriptamat.2003.12.034 ↗
18. Characteristics of the contraction twins formed close to the fracture surface in Mg–3Al–1Zn alloy deformed in tension10.1016/j.scriptamat.2008.06.041 ↗
19. Twinning effects in a rod-textured AM30 magnesium alloy10.1016/j.ijplas.2011.08.001 ↗
20. An experimental and numerical study of texture change and twinning-induced hardening during tensile deformation of an AZ31 magnesium alloy rolled plate10.1016/j.msea.2012.11.018 ↗
21. Evolution of microstructure and texture during planar simple shear of magnesium alloy10.1016/j.scriptamat.2012.01.040 ↗
22. Numerical investigation of secondary deformation mechanisms on plastic deformation of az31 magnesium alloy using viscoplastic self-consistent model10.3390/met9010041 ↗
23. Texture-based forming limit prediction for Mg sheet alloys ZE10 and AZ3110.1016/j.ijmecsci.2016.08.013 ↗
24. Anisotropic and asymmetrical yielding and its distorted evolution: Modeling and applications10.1016/j.ijplas.2016.03.002 ↗
25. Colette, R. Modeling of deformation and rotation bands and of deformation induced grain boundaries in IF steel aggregate during large plane strain compression10.1016/j.ijplas.2003.11.014 ↗
26. Role of stacking fault energy on the deformation characteristics of copper alloys processed by plane strain compression10.1016/j.msea.2011.06.075 ↗
27. Yielding of magnesium: From single crystal to polycrystalline aggregates10.1016/j.ijplas.2007.07.009 ↗
28. Crystallographic analysis on the activation of multiple twins in rolled AZ31 Mg alloy sheets during uniaxial and plane strain compression10.1016/j.msea.2015.11.033 ↗
29. On the plastic deformation of polycrystals10.1016/0001-6160(61)90060-8 ↗
30. Tomé · 2012
31. Visco-plastic modeling of mechanical responses and texture evolution in extruded AZ31 magnesium alloy for various loading conditions10.1016/j.ijplas.2014.10.012 ↗
32. Modelling the role of slips and twins in magnesium alloys under cyclic shear10.1016/j.commatsci.2014.09.015 ↗
33. Plastic anisotropy and the role of non-basal slip in magnesium alloy AZ31B10.1016/j.ijplas.2004.05.018 ↗
34. Measurement and prediction of texture development during a rolling sequence of Zircaloy-4 tubes10.1016/0022-3115(95)00210-3 ↗
35. On dynamic deformation behavior of WE43 magnesium alloy sheet under shock loading conditions10.1016/j.matdes.2014.06.038 ↗
36. Large plasticity in magnesium mediated by pyramidal dislocations10.1126/science.aaw2843 ↗
37. Role of {10–12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy10.1016/j.actamat.2010.07.002 ↗