Source abstract
Abstract
Interfacing a lithium metal electrode with a designed thin-film coating offers promise in gaining control over plating and stripping instabilities during cycling, especially by inhibiting the growth of dendrites. This work introduces a coating comprised of hybrid particle brushes synthesized by grafting poly(poly[ethylene glycol] methyl ether methacrylate) from silica nanoparticles via surface-initiated atom transfer radical polymerization (SI-ATRP). Particle brushes in tetrahydrofuran solutions were drop cast on lithium metal and cycled in pouch cells with ether-based liquid electrolyte at 1 mA cm –2 and 1 mAh cm –2, which were then evaluated with synchrotron X-ray microcomputed tomography to understand corresponding lithium morphologies. The coatings that achieved the longest cycle life (average of 275 cycles) avoided dendrites and densified the cycled lithium in both early and late stages of cycling. Post-mortem analysis of the failed cells compared the bare Li and coating-protected Li systems. Grafting densities (0.21 to 0.72 chains nm –2 ) of the particle brushes were optimized and enabled coatings to exhibit ionic conductivities similar to the liquid electrolyte system with slightly higher Arrhenius activation energies. Mechanical behaviors (modulus: 30 to 80 kPa; creep strain rate: approximately 10 –4 s –1 ) did not play a dominant role in improvement, suggesting that tuning the particle brush architecture mainly prevents dendrites through resulting ionic transport effects and more regulated plating/stripping behavior.
Source: openalex_inverted_index · Quality: baseline
Affiliations
Department of Mechanical Engineering, Tufts University, Medford, Massachusetts 02155, United States
Department of Chemistry, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213, United States
Department of Chemical & Biomolecular Engineering, University of California Irvine; National Fuel Cell Research Center, Irvine, California 92697, United States
Ionic Materials, Inc., Woburn, Massachusetts 01801, United States
Department of Chemical & Biological Engineering, Tufts University, Medford, Massachusetts 02155, United States
Funding
Basic Energy Sciences · Division of Materials Research