Using materials quality factor BΔΕ∗ for design of thermoelectric materials with multiple bands
Source abstract
Abstract
Abstract The quality factor B involving carrier mobility, state density effective mass, and lattice thermal conductivity has always been regarded as the guidance for the thermoelectric materials design. However, the traditional quality factor considers a single band and neglects the influence of band gap and the sub-band, whose edge energy is 5 kBT lower than valence band maximum for the p-type or higher than conduction band minimum for n-type semiconductor. In this work, we took into account the band gap and second band based on the three-parabolic-band model and derived an advanced quality factor B Δ E ∗ , which is better proportional to the peak ZT values of many compounds with multiple bands. A specific example is also validated based on this quality factor that a highest B Δ E ∗ appears when x = 0.8 for (Yb0.9Mg0.1)MgxZn2-xSb2, leading to the highest ZT value at this composition.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Thermal Radiation and Cooling Technologies · Thermal properties of materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (48)
Show source-provided references
1. Thermoelectric cooling and power generation10.1126/science.285.5428.703 ↗
2. Recent progress towards high performance of tin chalcogenide thermoelectric materials10.1039/C7TA09941J ↗
3. Zintl-phase Eu2ZnSb2: a promising thermoelectric material with ultralow thermal conductivity10.1073/pnas.1819157116 ↗
4. Seeking new, highly effective thermoelectrics10.1126/science.aaz9426 ↗
5. alpha-CsCu5Se3: discovery of a low-cost bulk selenide with high thermoelectric performance10.1021/jacs.0c00062 ↗
6. Convergence of electronic bands for high performance bulk thermoelectrics10.1038/nature09996 ↗
7. Rationalizing phonon dispersion for lattice thermal conductivity of solids10.1093/nsr/nwy097 ↗
8. The thermoelectric figure of merit and its relation to thermoelectric generators
9. Thermoelectric figure of merit of a one-dimensional conductor10.1103/PhysRevB.47.16631 ↗
10. The effect of quantum well structures on the thermoelectric figure of merit10.1103/PhysRevB.47.12727 ↗
11. Thermoelectric figure of merit of two band semiconductors10.1063/1.1728842 ↗
12. Material descriptors for predicting thermoelectric performance10.1039/C4EE03157A ↗
13. New insight into the material parameter B to understand the enhanced thermoelectric performance of Mg2Sn1-x-yGexSby10.1039/C5EE02600H ↗
14. Enhanced thermoelectric property originating from additional carrier pocket in skutterudite compounds
15. Band sharpening and band alignment enable high quality factor to enhance thermoelectric performance in n-Type PbS10.1021/jacs.0c00306 ↗
16. All-scale hierarchically structured p-type PbSe alloys with high thermoelectric performance enabled by improved band degeneracy10.1021/jacs.9b00967 ↗
17. High performance Na-doped PbTe-PbS thermoelectric materials: electronic density of states modification and shape-controlled nanostructures10.1021/ja206380h ↗
18. Realizing high thermoelectric properties of SnTe via synergistic band engineering and structure engineering10.1016/j.nanoen.2019.104056 ↗
19. Rare earth doping and effective band-convergence in SnTe for improved thermoelectric performance10.1063/1.5055250 ↗
20. Convergence of conduction bands as a means of enhancing thermoelectric performance of n-type Mg2Si1-xSnx solid solutions10.1103/PhysRevLett.108.166601 ↗
21. Designing high-performance layered thermoelectric materials through orbital engineering10.1038/ncomms10892 ↗
22. Band engineering and rational design of high-performance thermoelectric materials by first-principles
23. Carrier distribution in multi-band materials and its effect on thermoelectric properties
24. The maximum possible conversion efficiency of silicon - germanium thermoelectric generators10.1063/1.349385 ↗
25. Achieving band convergence by tuning the bonding ionicity in n-type Mg3Sb210.1002/jcc.25822 ↗
26. Large reduction of thermal conductivity leading to enhanced thermoelectric performance in p-type Mg3Bi2–YbMg2Bi2 solid solutions10.1039/C8TC05424J ↗
27. Thermoelectric properties of Bi-based Zintl compounds Ca1−xYbxMg2Bi210.1039/C6TA00507A ↗
28. Enhancement of thermoelectric performance of phase pure Zintl compounds Ca1-xYbxZn2Sb2, Ca1-xEuxZn2Sb2, and Eu1-xYbxZn2Sb2 by mechanical alloying and hot pressing10.1016/j.nanoen.2016.04.023 ↗
29. Higher thermoelectric performance of Zintl phases (Eu0.5Yb0.5)(1-x)CaxMg2Bi2 by band engineering and strain fluctuation10.1073/pnas.1608794113 ↗
30. Balancing the anionic framework polarity for enhanced thermoelectric performance in YbMg2Sb2 Zintl compounds
31. Promising Zintl-phase thermoelectric compound SrAgSb10.1021/acs.chemmater.0c02317 ↗
32. Suppressing the bipolar contribution to the thermoelectric properties of Mg2Si0.4Sn0.6 by Ge substitution10.1063/1.4918311 ↗
33. Thermoelectric properties of YbCd2Sb2 doped by Mg10.1016/j.jallcom.2016.04.118 ↗
34. All-scale hierarchical thermoelectrics: MgTe in PbTe facilitates valence band convergence and suppresses bipolar thermal transport for high performance10.1039/c3ee42187b ↗
35. A dual role by incorporation of magnesium in YbZn(2)Sb(2) Zintl phase for enhanced thermoelectric performance10.1002/aenm.202001229 ↗
36. Mg3Sb2-based Zintl compound: a non-toxic, inexpensive and abundant thermoelectric material for power generation10.1039/c3ra40457a ↗
37. Synthesis and properties of CaCd2Sb2 and EuCd2Sb210.1016/j.intermet.2009.07.011 ↗
38. High temperature transport properties of BaZn2Sn210.1016/j.jallcom.2014.10.090 ↗
39. Limits of cation solubility in AMg(2)Sb(2) (A = Mg, Ca, Sr, Ba) alloys10.3390/ma12040586 ↗
40. Thermoelectric properties of Yb(x)Eu(1-x)Cd2Sb210.1063/1.3501370 ↗
41. Thermoelectric properties of Eu(Zn1-xCdx)2Sb210.1039/B916346H ↗
42. Enhanced thermoelectric figure of merit of Zintl phase YbCd2-xMnxSb2 by chemical substitution10.1002/ejic.201100282 ↗
43. Single parabolic band transport in p-type EuZn2Sb2 thermoelectrics10.1039/C7TA08869H ↗
44. Observation of valence band crossing: the thermoelectric properties of CaZn2Sb2–CaMg2Sb2 solid solution10.1039/C8TA02250J ↗
45. Recent progress and future challenges on thermoelectric Zintl materials10.1016/j.mtphys.2017.06.003 ↗
46. First-principles study on doping and temperature dependence of thermoelectric property of Bi2S3 thermoelectric material10.1016/j.materresbull.2013.02.004 ↗
47. Achieving high thermoelectric quality factor toward high figure of merit in GeTe
48. Tailoring the phase transition temperature to achieve high-performance cubic GeTe-based thermoelectrics10.1039/D0TA06013E ↗