Texture Gradient in a Rectangular Extruded Al60Mg40 Metal Matrix Composite
Source abstract
Abstract
By applying cold extrusion, an elemental metal powder composite Al60Mg40 was prepared. The texture gradient was measured over the cross-section of the extrusion profile using synchrotron radiation while the bulk texture was obtained by neutron diffraction. The aluminum phase shows a typical texture component of plane-strain deformation in the middle part of the sample and a uniaxial deformation texture at the surface. In the central region of the extruded bar, the (0002) Mg pole figure shows a split along the extrusion direction (±ED), which also has been observed in rare-earth containing magnesium alloys. These two poles twist towards the transverse direction on moving towards the surface of the extruded bar; one pole moves to +TD and the other one to −TD. The angle of twist increases towards the TD surface.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Institute of Materials Science and Engineering, TU Clausthal, 38678 Clausthal-Zellerfeld, Germany
Helmholtz-Zentrum Geesthacht, Max-Planck-Straße 1, 21502 Geesthacht, Germany
Helmholtz-Zentrum Geesthacht, German Engineering Materials Science Center outstation at Desy, Notkestraße 85, 22607 Hamburg, Germany
Funding
Deutsche Forschungsgemeinschaft
References (37)
Show source-provided references
1. Correlation of microstructure and type II superconductivity of a heavily cold rolled Cu-20mass%Nb10.1016/1359-6454(95)00239-1 ↗
2. The dependence of the texture and microstructures in two-phase composites on the yield stresses of the components
3. Characterization of strength and microstructure in deformation processed Al-Mg composites10.1023/A:1004772526480 ↗
4. Kai, X. (2003). Microstructure and Strength of a Deformation Processed Al-20%Sn Metal-Metal Composite. [Ph.D. Thesis, Iowa State University].
5. Experimental textures of Al-Pb, Al-Cu, and Fe-Cu metal-metal composites10.1016/0921-5093(94)91052-9 ↗
6. Textur-Untersuchungen an Drähten I
7. On through thickness crystallographic texture gradient in Al-Li-Cu-Zr alloy10.1007/BF02649289 ↗
8. Über die Textur hartgezogener Drähte
9. Fiber textures of extruded aluminum alloy rod10.2320/matertrans1960.5.235 ↗
10. Investigation of texture gradients of semi-finished products by neutrons10.4028/www.scientific.net/MSF.702-703.499 ↗
11. Advantages of neutron diffraction in texture analysis10.1155/TSM.10.265 ↗
12. Kainer, K.U. (2009). Texture gradient in a bonelike extrusion profile of MgZe10. Proceedings of the 8th International Conference on Magnesium Alloys and their Applications, Wiley-VCH.
13. Schwarzer, R. (1998). Texture Analysis at GKSS Research Center (Instrumentation and Application). Book Texture and Anisotropy of Polycrystals, TTP Transtech Publications.
14. Comparison of texture evolution between different thickness layers in cold roled Al-Mg alloy10.1016/j.matchar.2011.10.007 ↗
15. Correlating r-value and through thickness texture in Al–Mg–Si alloy10.1016/j.jallcom.2014.09.038 ↗
16. Through-Thickness Texture Gradient in an annealed Al-Mg alloy sheet10.1007/s11661-005-1016-0 ↗
17. Ondracek, G. (1985). Verbundwerkstoffe Phasenverbindung und mechanische Eigenschaften Band 1. Book Verbundwerkstoffe Technologie und Prüfung, ERIK TONEN.
18. Measurement and simulation of extrusion textures in Al-Mg composites
19. Yi, S. (2005). Investigation on the Deformation Behavior and the Texture Evolution in Magnesium Wrought Alloy AZ31. [Ph.D. Thesis, TU Clausthal].
20. Bunge, H.J. (1993). Texture Analysis in Materials Science, Cuvillier Verlag. [3rd ed.].
21. Two-Dimensional Detector Software: From Real Detector to Idealised Image or Two-Theta Scan10.1080/08957959608201408 ↗
22. Identification of unexpected hydrides in Mg–20 wt% Dy alloy by high-brilliance synchrotron radiation10.1107/S0021889811053088 ↗
23. Mechanism of deformation and development of rolling textures in polycrystalline F.C.C. metals10.1016/0001-6160(88)90173-3 ↗
24. Brokmeier, H.-G. (2017). Hot rectangular extrusion textures of six Mg-alloys via neutron diffraction. Adv. Eng. Mater.10.1002/adem.201700234 ↗
25. Effect of rare earth additions on microstructure and texture development of magnesium alloy sheets10.1016/j.scriptamat.2009.12.033 ↗
26. Texture analysis in hexagonal materials10.1016/S0254-0584(03)00168-8 ↗
27. Texture and phase development in Al-40at% Ni Composites
28. Cyclic Textures in Aluminium wires
29. Influence of extrusion process parameters on the mechanical properties of Al-Li-Extrusions10.1051/jphyscol:1987322 ↗
30. Crystallographic texture gradients in the aluminum 8090 matrix alloy and 8090 particulate composites10.1016/0921-5093(94)90303-4 ↗
31. Zhong, Z.Y., Brokmeier, H.-G., Maawad, E., and Schell, N. (2014, January 24–29). Texture Dependent Lattice Strains and Texture Gradient in Al7020. Proceedings of the 17th International Conference on Textures of Materials (ICOTOM17), Dresden, Germany.10.1088/1757-899X/82/1/012100 ↗
32. Explaining texture weakening and improved formability in magnesium rare earth alloys10.1179/1743284714Y.0000000632 ↗
33. Plastic anisotropy and the role of non-basal slip in magnesium alloy AZ31B10.1016/j.ijplas.2004.05.018 ↗
34. The recrystallization and texture of magnesium–zinc–cerium alloys10.1016/j.scriptamat.2008.05.021 ↗
35. Application of texture simulation to understanding mechanical behavior of Mg and solid solution alloys conatining Li or Y10.1016/S1359-6454(01)00297-X ↗
36. The origin and enhancement of <0001>{112¯0} texture during heat treatment of rolled AZ31B magnesium alloys10.1016/j.actamat.2015.04.043 ↗
37. Effect of sheet thickness on the microstructural evolution of an Mg AZ61 alloy during large strain hot rolling10.1016/j.scriptamat.2003.11.015 ↗