SRM 482: Revisited After 30 Years
Source abstract
Abstract
Abstract The National Institute of Standards and Technology’s (NIST) Standard Reference Material (SRM) 482 was issued by The National Bureau of Standards (NBS) in 1969 i has been continuously available to the public for over 30 years [1]. The standard cons of a set of 6 wires. Each wire is approximately 0.5 mm in diameter and 5 cm long. Tl wires represent different compositions within the binary copper-gold alloy system. Included in the set are the two end member compositions, pure copper and pure gold, along with 4 alloys of nominal composition: Au80-Cu20, Au60-Cu40, Au40-Cu60 an< Au20-Cu80. SRM 482 was produced specifically for the purpose of microanalysis usi the electron probe microanalyzer (EPMA). Recent metallographic preparation of these wires revealed the presence of surface blemishes on some of the prepared wires (Figure la). Two of the authors from differei affiliations recently prepared cross-sections of SRM wires from separately purchased sets. Each was unaware of the procedures used by the other.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Electron and X-Ray Spectroscopy Techniques · Advanced Materials Characterization Techniques · Surface and Thin Film Phenomena
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
National Institute of Standards and Technology , Gaithersburg, MD, 20899
Elan Pharmaceuticals , King of Prussia, PA, 19406
Lehigh University, Dept of Materials Science and Engineering , Bethlehem, PA, 18015
References (4)
Show source-provided references
1. 10.1007/978-1-4684-8676-6_310.1007/978-1-4684-8676-6_3 ↗
2. Certificate of Analysis: Standard Reference Material 482 (1969).
3. Heinrich, K. F. J. , et al.: NBS Special Publication 260-28 (1971).
4. Metallography and Microstructures: ASM Handbook · 1985 · 9 · 399