journal article·2026-04-17Open access

Ablation Resistance and Spray-Ability of Nano-Magnesium Silicate Reinforced Sprayable Silicone-Based Thermal Insulation Materials

Junjie Hu, Yanbin Chen, Tingting Ge, Shuang Wu, Qianqiu Wu, Lifen Li, Yage Chen, Yifu Zhang, Yang Li

Nanomaterials· Volume 16· Issue 8

Abstract

In order to satisfy the requirement for lightweight, highly reliable sprayable silicone rubber insulation material (SASI) in next-generation spacecraft, and to achieve a synergistic balance among the sprayability, mechanical properties and ablation resistance of SASI, this paper describes the preparation of nanostructured magnesium silicate (n-MS) via a hydrothermal method and systematically investigates its effects on the sprayability, mechanical properties and ablation resistance of sprayable SASI. The findings suggest that when the n-MS loading is set at 15 parts, the linear ablation rate and mass ablation rate of the SASI under oxy-acetylene conditions are as low as 0.10 mm/s and 0.07 g/s, respectively, representing reductions of 41.8% and 67.1% compared to the unmodified samples. Building upon this enhancement in ablation resistance, the tensile strength was also increased by 3.70 MPa, representing a 19.3% increase. It is crucial to note that during the spraying process, the viscosity of the silicone rubber system remained within a narrow range of 540–550 mPa·s following the addition of this filler. This finding indicates that the introduction of n-MS had no significant adverse effect on the spraying process. In summary, n-MS has been demonstrated to enhance the mechanical strength and ablation resistance of silicone rubber materials while maintaining adequate spray coating performance. In comparison with conventional filled silicone rubbers, the sprayable silicone rubber insulating material developed in this study provides a new material basis for the future lightweight and intelligent development of aerospace engines.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Silicone and Siloxane Chemistry · Aerogels and thermal insulation · Polymer Nanocomposites and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

National Key Laboratory of Aerospace Chemical Power, Xiangyang 441003, China

Hubei Institute of Aerospace Chemotechnology, Xiangyang 441003, China

College of Chemistry and Molecular Sciences, Wuhan University, Wuhan 430072, China

Funding

Major Science and Technology Project of Hubei Province

References (39)

Show source-provided references
1. ZrO2-reinforced polymer-matrix composites used for thermal protection systems of ultra-high temperature aerospace propulsion10.1016/j.ast.2024.108906 ↗
2. Guan, Y., Zhao, W., Ba, Y., Wang, Z., and Yu, X. (2025). Enhanced Ablation Resistance of Silicone Composites in Oxygen-Rich High-Temperature Environment for Solid Fuel Ramjet Applications. Aerospace, 12.10.3390/aerospace12110961 ↗
3. Recent developments in elastomeric heat shielding materials for solid rocket motor casing application for future perspective10.1002/pat.4101 ↗
4. Hollow microsphere-reinforced ablative materials for thermal protection systems of solid rocket motors10.1016/j.actaastro.2024.05.038 ↗
5. Research status and development tendency of ablation resistance-flexibility-heat insulation lay materials
6. Study on Ablation Properties of Spray-Coated Silicone Rubber Thermal Insulation Materials
7. Study on Automatic Spraying Process of Two-Component Silicone Rubber Thermal Protection Coatings
8. In situ construction of fiber-supported micro-porous char structure to enhance anti-ablative performance of silicone rubber composites10.1002/pat.5301 ↗
9. Shear Ablation Behavior and Mechanism of Liquid Silicone Rubber Composites at Different Ablation Angles and Distances10.1021/acs.iecr.2c03003 ↗
10. Durga Prasad, K.A.K., Rakshita, M., Sharma, A.A., Pradhan, P.P., Uday Kumar, K., Rakesh Kumar, R., and Haranath, D. (2025). Enhanced blue emission and afterglow properties of Sr2MgSi2O7:Eu2+, Dy3+ phosphors for flexible transparent labels. J. Appl. Phys., 137.10.1063/5.0230526 ↗
11. Mechanical and Antibacterial Properties of Silicone Rubber Compounds Filled with Silver-Zirconium Phosphate Modified by Aluminate Coupling Agent10.1080/03602559.2017.1298796 ↗
12. High-temperature behavior of silicone rubber composite with boron oxide/calcium silicate10.1515/epoly-2022-0051 ↗
13. Long-chain alkyl polysiloxane modified magnesium silicate nanotubes and their enhancing effects on the properties of silicone rubber composites10.1016/j.colsurfa.2025.139155 ↗
14. Guo, J., Chen, X., and Zhang, Y. (2018). Improving the Mechanical and Electrical Properties of Ceramizable Silicone Rubber/Halloysite Composites and Their Ceramic Residues by Incorporation of Different Borates. Polymers, 10.10.3390/polym10040388 ↗
15. Study of vulcanization characteristic, mechanical, dynamic mechanical and thermal properties of silicone rubber, EPDM, and their hybrid clay nanocomposites10.1002/app.55590 ↗
16. Investigation of the thermal degradation kinetics of ceramifiable silicone rubber-based composite10.1007/s10973-023-12138-9 ↗
17. Ceramization mechanism of ZrB2—boron phenolic resin modified silicone rubber thermal protection system materials and the influence of oxygen in service environment10.1016/j.polymdegradstab.2025.111664 ↗
18. Investigation of silicone rubber composites reinforced with carbon nanotube, nanographite, their hybrid, and applications for flexible devices10.1002/vnl.21799 ↗
19. Synthesis and characterization of novel room temperature vulcanized (RTV) silicone rubbers using octa[(trimethoxysilyl)ethyl]-POSS as cross-linker10.1016/j.reactfunctpolym.2010.12.010 ↗
20. Synergistic reinforcement and flame retardancy in silicone rubber achieved by magnesium silicate nanotubes10.1016/j.ceramint.2026.01.110 ↗
21. Aksoy, Y.T. (2025). Nanofluids for Sustainable Heat Transfer Enhancement: Beyond Thermal Conductivity. Sustainability, 17.10.3390/su17178006 ↗
22. (2009). Rubber, Vulcanized or Thermoplastic—Determination of Tensile Stress-strain Properties (Standard No. GB/T 528-2009).
23. (1996). Ablative Material Ablation Test Method (Standard No. GJB 323A-1996).
24. Wang, B. (2019). Hydrothermal Synthesis and Tribological Properties of Magnesium Silicate Hydroxide Nanomaterial. [Ph.D. Thesis, Beijing Jiaotong University].
25. Properties of magnesium silicate hydrates (M-S-H)10.1016/j.cemconres.2015.10.003 ↗
26. Characterization of magnesium silicate hydrate (M-S-H)10.1016/j.cemconres.2018.09.007 ↗
27. Multifunctional Silica–Silicone Nanocomposite with Regenerative Superhydrophobic Capabilities10.1021/acsami.9b15445 ↗
28. Superhydrophobic and high-flashover-strength coating for HVDC insulating system10.1016/j.cej.2020.126476 ↗
29. Effect of Silica Structure on Rheological and Mechanical Properties of Addition-Type Liquid Silicone Rubber
30. Experimental study on enhanced heat transfer via nanoparticle depositions using TiO2-water nanofluid sprays10.1016/j.applthermaleng.2025.125450 ↗
31. Bak, I., Kim, J., Ruba, A.J., Ross, D.J., and Lee, K.S. (2025). Compression Response of Silicone-Based Composites with Integrated Multifunctional Fillers. Polymers, 17.10.3390/polym17040500 ↗
32. Mrówka, M., Woźniak, A., Prężyna, S., and Sławski, S. (2021). The Influence of Zinc Waste Filler on the Tribological and Mechanical Properties of Silicone-Based Composites. Polymers, 13.10.3390/polym13040585 ↗
33. Nano-Silica-Particles Filling Effect on Mechanical Properties of Silicone-Rubber Composites10.1002/app.56790 ↗
34. Effect of microstructural damage on the mechanical properties of silica nanoparticle-reinforced silicone rubber composites10.1016/j.engfracmech.2020.107195 ↗
35. Zhang, T., Zou, J., Wang, B., Wu, Z., Jia, Y., and Cheeseman, C.R. (2018). Characterization of Magnesium Silicate Hydrate (MSH) Gel Formed by Reacting MgO and Silica Fume. Materials, 11.10.3390/ma11060909 ↗
36. Flame retardancy of silicone-based materials10.1016/j.polymdegradstab.2008.11.019 ↗
37. Shan, H. (2024). Preparation and Properties of Sprayable Silicone Rubber-Based High-Efficiency Thermal Insulation and Protective Coatings. [Ph.D. Thesis, Wuhan University of Technology].
38. Novel ablation resistant additive (Li2Mn4)O(CO3)4·H2O and its application in silicone rubber10.1016/j.ceramint.2024.02.226 ↗
39. Study on flame retardancy of EPDM reinforced by ammonium polyphosphate10.1039/D4RA00733F ↗