The transmission of acoustic emission across large-scale turbine rotors
Source abstract
Abstract
Abstract Seal and blade-tip rubbing in turbo machinery can often result in costly rotor damage. Acoustic emission analysis at the bearings has previously been cited as a viable non-destructive monitoring technique by which the onset of such rotor–stator contacts can be detected in large-scale turbines [Aerospace Conf., IEEE Proc. 6 (2000) 79; Electr. Engng Jpn 110 (2000)]. These studies suggested that the stress waves or acoustic emissions produced during the frictional rub process can propagate across the turbine surface and across the bearing interfaces to be detectable by the sensor attached to the bearing housing. However, results from the actual large-scale turbine units have been scarce. This paper presents a fundamental/pre-requisite study on the transmissibility of acoustic emission (AE) signatures across very large-scale turbine rotors. It is concluded that the actual AE attenuation incurred does not inherently exclude the detection of seal and blade rubbing in turbines. However, its success is highly dependent on advanced signal processing.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Machine Fault Diagnosis Techniques · Engineering Diagnostics and Reliability · Gear and Bearing Dynamics Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (15)
Show source-provided references
1. Bagnoli S, Capitani R, Citti P. Comparison of accelerometer and acoustic emission signals as diagnostic tools in assessing bearing. Proceedings of Second International Conference on Condition Monitoring, London, UK; May 1988. p. 117–25.
2. Stress wave analysis of turbine engine faults
3. Cotgrove RM, Wood MI. Opportunities for advanced sensors for condition monitoring of gas turbines. IEE conference on Opportunities and Advances in International Power Generation (Conf. Publ. No. 419); March 1996 p. 119.10.1049/cp:19960131 ↗
4. Dornfeld D, Handy C. Slip detection using acoustic emission signal analysis. Proceedings of IEEE International Conference on Robotics and Automation; 1987. p. 1868.10.1109/ROBOT.1987.1087812 ↗
5. Acoustic emission signal classification in condition monitoring using the Kolmogorov–Smirnov statistic
6. Hawman MW, Galinaitis WS. Acoustic emission monitoring of rolling-element bearings. Proceeding of the IEEE 1988 Ultrasonics Symposium. p 885–9.10.1109/ULTSYM.1988.49503 ↗
7. Jiaa CL, Dornfeld D. Experimental studies of sliding friction and wear via acoustic emission signal analysis. Wear;139(2):403–24.10.1016/0043-1648(90)90059-J ↗
8. Kaiser. PhD Thesis, Technische Hochschule Munich; 1950.
9. Fault detection and diagnosis of rotating machinery10.1109/41.873208 ↗
10. Condition monitoring of slow-speed rotating machinery using stress waves: part1 and part 2
11. Rotor-stationary element rub-related vibration phenomena in rotating machinery: literature survey10.1177/058310248902100303 ↗
12. The application of vibration signature analysis and acoustic emission source location to on-line condition monitoring of anti-friction bearings10.1016/0301-679X(79)90001-X ↗
13. Rotating machinery diagnosis with acoustic emission techniques
14. A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings10.1016/S0301-679X(99)00077-8 ↗
15. Defect detection of rolling element bearings by acoustic emission method