journal article·2009-06

Application of two-dimensional XRD for the characterization of the microstructure of self-leveling compounds

Severin Seifert, Juergen Neubauer, Friedlinde Goetz-Neunhoeffer, Hubert Motzet

Powder Diffraction· Volume 24· Issue 2
Publisher page

Abstract

The two-dimensional XRD (GADDS) was used to characterize the microstructure of an applied self-leveling compound (SLC). A calcium aluminate cement based SLC was prepared on two different substrates (water absorbent and nonwater absorbent) to determine the vertical distribution of the crystalline phases. The application of the GADDS enables the detection of the phase composition of the hydrating mortar in horizontal slices. Thus the analysis could be carried out in position-sensitive mode at three different areas: near the bottom, in the center, and at the top of the mortar. For investigation of SLCs from the very early hydration stage up to 10 h of hydration, a custom-made in situ sample holder for the measurements was designed and constructed. The combination of the GADDS and the custom-made in situ sample holder provides the possibility to characterize additionally the time-dependent phase composition within the SLC. The nonabsorbent substrate has no effect on the hydration of the binder phases but the absorbent substrate influences the formation of ettringite. In the top layer of the SLC the ettringite content is reduced during the first hours of hydration. The absorbing forces of the substrate lead to migration of the mix water to the substrate. This lack of water results in the reduced formation of ettringite.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Geophysical Methods and Applications · Concrete and Cement Materials Research · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (10)

Show source-provided references
1. Motzet H. (2007). “The performance of gypsum based self levelling compounds,” Proceedings of the First International Drymix Conference idmmc one, Nuremberg, Germany, pp. 26–32.
2. Neubauer J. , Goetz-Neunhoeffer F. , Holland U. , and Schmitt D. (2004). “In situ XRD investigation of OPC hydration,” Proceedings of the 26th International Conference on Cement Microscopy, San Antonio, TX, USA.
3. Anderberg · 2007
4. Die europäische Trockenmörtelindustrie (Teil 1): The European dry-mix mortar industry (Part 1)
5. Harbron R. (2001). “A general description of flow-applied floor screeds—an important application for complex formulations based on CAC,” Proceedings of the International Conference on Calcium Aluminate Cements 2001, Edinburgh, United Kingdom, pp. 597–604.
6. Fundamentals of two-dimensional x-ray diffraction (XRD2)
7. X-ray optics for two-dimensional diffraction
8. De Gasparo A. (2006). “Fractionation behavior of organic additives and resulting microstructural evolution of mixed-binder based flooring compounds,” Ph.D. thesis, University of Bern.
9. Herwegh M. , Zurbriggen R. , Scrivener K. , De Gasparo A. , Kighelman J. , and Jenni A. (2006). “A comparison between tile adhesive mortars (CTA) and self-leveling compounds (SLC): What can we learn about the role of polymers in thin-bed mortars?,” Proceedings of the 16th IBAUSIL, Weimar, paper 2-1059-2-1066.
10. 10.1016/j.cemconres.2004.06.03910.1016/j.cemconres.2004.06.039 ↗