Unified equivalent circuit of dielectric permittivity and porous coating formalisms for EIS probing of thick industrial grade coatings
Source abstract
Abstract
The equivalent circuit Re(Q1[R1(Q2R2)]) was fitted to the impedance spectra of the two water based and the two solvent based industrial coating systems measured during long term exposure to 3.5 % NaCl. The initial states of the samples were the intact state and the salt cabinet aged state. The elements of Re(Q1[R1(Q2R2)]) were ascribed physical meaning within the dielectric permittivity and EIS porous coating formalisms. A real capacitor behavior of a coating was simulated by a lossless capacitor in series with a resistance and the distributed time- constant behavior was simulated by a set of parallel circuits representing either space related or frequency related heterogeneity of the system. The equivalent circuit parameters and the impedance modulus at 0.1 Hz reflected various degrees of coatings sensitivity to environmental conditions that correlated with the harshness and length of exposure. The additional parameters suggested for rating of the coating barrier properties were tan delta, equal to the resistive to capacitive current ratio, and its response to various cathodic offset potentials indicating the retention or loss of wet adhesion. The compromised barrier property of one of the water based coatings was deduced from a continuously decreasing low-frequency impedance and the appearance of the low frequency tan deltapeak that increased upon cathodic polarization. These observations were linked to blistering, adhesion strength decrease, corrosion of the substrate revealed after the adhesion test, cratering defects at the coating surface and pronounced rust leaching at the sample edges and welds that were lacking the stripe coats.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Corrosion Behavior and Inhibition · Concrete Corrosion and Durability · Smart Materials for Construction
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (47)
Show source-provided references
1. Advances in corrosion protection by organic coatings: what we know and what we would like to know10.1016/j.porgcoat.2016.04.030 ↗
2. EIS and organic coatings performance: revisiting some key points10.1016/j.electacta.2020.136725 ↗
3. EIS studies of coated metals in accelerated exposure10.1016/S0300-9440(02)00222-9 ↗
4. Validation of coated infrastructure examination by electrochemical impedance spectroscopy
5. Interpretation of EIS data from accelerated exposure of coated metals based on modeling of coating physical properties10.1016/j.electacta.2005.12.047 ↗
6. Analysis of the non-ideal capacitive behavior for high impedance organic coatings10.1016/j.porgcoat.2014.02.008 ↗
7. Monitoring the early stage of degradation of epoxy-coated steel for ballast tank by electrochemical impedance spectroscopy10.2320/matertrans.M2017243 ↗
8. A study of the effects of filler particles on the degradation mechanisms of powder epoxy novolac coating systems under corrosion and erosion10.1016/j.porgcoat.2018.04.026 ↗
9. Quantification of protective properties of the coating/corrosion product/steel interface by integration of transmission line model with EIS results10.1007/s11998-014-9627-2 ↗
10. Impedance sensor for the early failure diagnosis of organic coatings10.1007/s11998-018-0072-5 ↗
11. Field-Programmable Gate Array-Based Coating Impedance Detector for Rapid Evaluation of Early Degradation of Protective Coatings
12. A Novel Non-Destructive Sensing Technology for On-Site Corrosion Failure Evaluation of Coatings10.1109/ACCESS.2017.2777532 ↗
13. Tokutake · Prog. Org. Coat. · 2015 · 87 · 6910.1016/j.porgcoat.2015.05.004 ↗
14. Electrochemical impedance and electrical resistance sensors for the evaluation of anticorrosive coating degradation10.1515/corrrev-2016-0055 ↗
15. Gel-Electrolyte EIS setup used for probing of IR Dried/Cured industrial coatings10.1016/j.porgcoat.2019.105331 ↗
16. Application of electrochemical impedance spectroscopy to study the degradation of polymer-coated metals10.1016/0300-9440(95)00581-1 ↗
17. Mass transport in blistering of coating steel
18. Electrochemical impedance spectroscopy of epoxy-vinyl coating in aqueous medium analyzed by dipolar relaxation of polymer10.1149/1.1512667 ↗
19. Thermal activation of impedance measurements on an epoxy coating for the corrosion protection: 1. Dielectric spectroscopy response in the dry state10.1016/j.electacta.2019.02.035 ↗
20. Thermal activation of impedance measurements on an epoxy coating for the corrosion protection: 2. electrochemical impedance spectroscopy study10.1016/j.electacta.2019.03.007 ↗
21. Electrical conductivity studies in hydrogels10.1016/S0167-2738(97)00074-X ↗
22. Composite Materials Damage Modeling Based on Dielectric Properties
23. 2003 · 61
24. The influence of Water absorption on dielectric properties of cycloaliphatic epoxy resin
25. Dielectric relaxation properties of the polymer coating during its exposition to water10.1016/S0254-0584(00)00214-5 ↗
26. Dielectric properties and interfacial adhesion of jute, Kenaf and E-Glass fabrics reinforcing epoxy composites10.1002/pc.25001 ↗
27. Quality assessment of adhesive bond based on dielectric properties
28. Quiang · 2017
29. Electrode polarization vs. Maxwell-Wagner-Sillars interfacial polarization in dielectric spectra of materials: characteristic frequencies and scaling laws10.1063/1.4919877 ↗
30. Influence of a metal–polymer interfacial interaction on dielectric relaxation properties of polyurethane10.1016/S0032-3861(99)00055-5 ↗
31. Application of dielectric relaxation spectroscopy to study metal/polymer interfacial interaction10.1080/00150199908226139 ↗
32. Characterisation of organic coatings in sour media and influence of polymer structure on corrosion performance10.1016/S0300-9440(00)00094-1 ↗
33. Correlating electrochemical impedance with hierarchical structure for porous carbon-based supercapacitors using a truncated transmission line model10.1016/j.electacta.2018.07.190 ↗
34. Technical Note: Concerning the Conversion of the Constant Phase Element Parameter Y0 into a Capacitance10.5006/1.3280607 ↗
35. The effect of water absorption on the dielectric properties of epoxy nanocomposites10.1109/T-DEI.2008.4446741 ↗
36. Vaishampayan · 2009
37. Evaluation of thick organic coatings degradation in seawater using cathodic protection and thermally accelerated tests10.1016/j.porgcoat.2004.09.007 ↗
38. Effectiveness of non-Fickian diffusion model on the water uptake determination of different organic coatings10.1016/j.porgcoat.2019.06.052 ↗
39. On the role of water, temperature, and glass transition in the corrosion protection behavior of epoxy coatings for underground pipelines10.1007/s11998-015-9705-0 ↗
40. DMA, EIS and thermal fatigue of organic coatings10.1016/j.electacta.2019.06.066 ↗
41. Effect of mechanical stresses on marine organic coating ageing approached by EIS measurements10.1016/j.porgcoat.2011.04.014 ↗
42. Effect of mechanical stress on kinetics of degradation of marine coatings10.1016/j.porgcoat.2008.05.001 ↗
43. Evaluation of thick organic coatings degradation in seawater using cathodic protection and thermally accelerated tests10.1016/j.porgcoat.2004.09.007 ↗
44. Determination of effective capacitance and film thickness from constant-phase-element parameters10.1016/j.electacta.2009.10.065 ↗
45. Deshmukh · 2017 · 237
46. A bulk and localised electrochemical assessment of epoxy-phenolic coating degradation10.1016/j.porgcoat.2016.04.042 ↗
47. Evaluation of epoxy coating for ballast tanks under thermal cycling by electrochemical impedance spectroscopy10.2355/isijinternational.ISIJINT-2016-228 ↗