Anticorrosion behavior of superhydrophobic particles reinforced epoxy coatings for long-time in the high salinity liquid
Source abstract
Abstract
Abstract The low cost and excellent properties make Al2O3 particles a great potential in developing advanced epoxy composites. However, it’s a big challenge to disperse the particles into epoxy matrixes in molecular-level. In this work, superhydrophobic Al2O3 particles, which was dispersed with mechanical method, were developed as reinforced particles for epoxy coating to develop the anti-corrosion under long-time exposure to solution of seawater salinity. The silane functionalized Al2O3 (SF-Al2O3) particles exhibited a water contact angle of 156.5°. Electrochemical testing including open circuit potential, impedance and phase angle measurements showed that SF-Al2O3 epoxy has better corrosion resistance in high salinity solution than original epoxy, while the unfunctionalized Al2O3 (UF-Al2O3) coating got failure after 36 days (d) of immersion. Scanning electron microscope analysis revealed a very good condition of the SF-Al2O3 epoxy coating after 144 d of immersion. It is clearly observed that silane-modified particles were very effective on the anti-corrosion protection property of composites in high salinity solution. There may be profound implication to design organic coatings reinforced by particles using simple mechanical stirring method.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Surface Modification and Superhydrophobicity · High voltage insulation and dielectric phenomena · Corrosion Behavior and Inhibition
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (51)
Show source-provided references
1. Solid particle erosion of epoxy matrix composites reinforced by Al2O3 spheres10.1016/j.triboint.2019.04.010 ↗
2. Evaluation of corrosion protection properties of additives for waterborne epoxy coatings on steel10.1016/S0300-9440(02)00016-4 ↗
3. A study on the anticorrosion performance of epoxy nanocomposite coatings containing epoxy-silane treated nano-silica on mild steel substrate10.1016/j.jiec.2014.08.008 ↗
4. Tribological properties of epoxy/rubber nanocomposites10.1016/j.triboint.2008.03.001 ↗
5. Some reflections on the past and future of erosion10.1016/0043-1648(95)07188-1 ↗
6. Corrosion performance of epoxy coatings containing silane treated ZrO2 nanoparticles on mild steel in 3.5% NaCl solution10.1016/j.corsci.2010.09.026 ↗
7. Epoxy nanocomposites with high mechanical and tribological performance10.1016/S0266-3538(03)00115-5 ↗
8. Reducing the water absorption in epoxy coatings by silane monomer incorporation10.1016/j.corsci.2006.02.005 ↗
9. Anticorrosive coatings: a review10.1007/s11998-008-9144-2 ↗
10. Enhanced barrier properties of epoxy coating containing CaCO3 microparticles modified with cerium nitrate10.1016/j.porgcoat.2020.105660 ↗
11. Epoxy-Based nanocomposite coating reinforced by a zeolite complex: its anticorrosion properties on mild steel in 3.5 wt% NaCl media10.1016/j.porgcoat.2019.105254 ↗
12. Improved adhesion, heat resistance, anticorrosion properties of epoxy resins/POSS/methyl phenyl silicone coatings10.1016/j.porgcoat.2019.06.017 ↗
13. Properties of nano-Fe3O4 incorporated epoxy coatings from Cure Index perspective10.1016/j.porgcoat.2019.04.034 ↗
14. Application insights of Schiff base metal complex/SiO2 hybrid epoxy nanocomposite for steel surface coating: correlation the protective behavior and mechanical properties with material loading10.1016/j.porgcoat.2019.105226 ↗
15. Preparation of Ce-MOF@TEOS to enhance the anti-corrosion properties of epoxy coatings10.1016/j.porgcoat.2019.06.015 ↗
16. Mode-I interlaminar fracture behaviour of nanoparticle modified epoxy/basalt fibre-reinforced laminates10.1016/j.polymertesting.2012.10.012 ↗
17. Thermomechanical response and toughening mechanisms of a carbon nano bead reinforced epoxy composite10.1016/j.matchemphys.2015.09.038 ↗
18. Enhanced interfacial interaction and excellent performance of silica/epoxy group-functionalized styrene-butadiene rubber (SBR) nanocomposites without any coupling agent10.1016/j.compositesb.2017.02.021 ↗
19. Toughening by nanostructure10.1016/j.polymer.2008.07.048 ↗
20. Microwave absorption properties of polypyrrole-SrFe12O19-TiO2-epoxy resin nanocomposites: optimization using response surface methodology10.1016/j.apsusc.2016.04.108 ↗
21. A mechanically robust and reversibly wettable benzoxazine/epoxy/mesoporous TiO2 coating for oil/water separation10.1016/j.apsusc.2019.145168 ↗
22. Reinforcement and toughening mechanisms in polymer nanocomposites - carbon nanotubes and aluminum oxide10.1016/j.compositesb.2015.01.019 ↗
23. Mechanisms leading to improved mechanical performance in nanoscale alumina filled epoxy10.1016/j.compscitech.2008.01.009 ↗
24. Synergistic effect of graphene oxide functionalized with SiO2 nanostructures in the epoxy nanocomposites10.1016/j.apsusc.2019.145046 ↗
25. Robust superhydrophobic surface with excellent adhesive properties based on benzoxazine/epoxy/mesoporous SiO210.1016/j.apsusc.2019.03.114 ↗
26. The effects of interfacial water and SiO2 surface wettability on the adhesion properties of SiO2 in epoxy nanocomposites10.1016/j.apsusc.2019.144151 ↗
27. Effect of nano-Al2O3 on adhesion strength of epoxy adhesive and steel10.1016/j.ijadhadh.2007.03.005 ↗
28. Studying the influence of nano-Al2O3 particles on the corrosion performance and hydrolytic degradation resistance of an epoxy/polyamide coating on AA-105010.1016/j.porgcoat.2014.04.017 ↗
29. Effect of Al2O3 particles on the adhesion, wear, and corrosion performance of epoxy coatings for protection of umbilical cables accessories for subsea oil and gas production systems10.1016/j.jmrt.2018.10.016 ↗
30. The effect of nanoalumina silanisation in tetraglycidylether epoxy adhesive10.1016/j.ijadhadh.2019.03.016 ↗
31. Studies on mechanical properties of epoxy composites filled with the grafted particles PGMA/Al2O310.1016/j.compscitech.2008.11.003 ↗
32. Mechanical reinforcement of unsaturated polyester by Al2O3 nanoparticles10.1016/S0167-577X(03)00512-3 ↗
33. Distinctive roles of silane coupling agents on the corrosion inhibition performance of graphene oxide in epoxy coatings10.1016/j.porgcoat.2017.05.008 ↗
34. Simple spray deposition of a hot water-repellent and oil-water separating superhydrophobic organic-inorganic hybrid coatings via methylsiloxane modification of hydrophilic nano-alumina10.1016/j.porgcoat.2018.08.020 ↗
35. Roles of silanes and silicones in forming superhydrophobic and superoleophobic materials10.1039/C6TA05441B ↗
36. Degradation of polydimethylsiloxane fluids in the environment - a review10.1016/S0045-6535(98)00548-7 ↗
37. Dynamic multi-phase partitioning of decamethylcyclopentasiloxane (D5) in river water10.1016/j.watres.2010.04.029 ↗
38. Exploring corrosion protection properties of solvent based epoxy-graphene oxide nanocomposite coatings on mild steel10.1016/j.corsci.2016.11.008 ↗
39. Enhancing corrosion resistance of epoxy coating on steel reinforcement by aminobenzoate intercalated layered double hydroxides10.1016/j.porgcoat.2019.05.023 ↗
40. Facile fabrication of hydrophobic polysiloxane coatings for protection of AZ31 magnesium alloy10.1007/s10853-019-03544-2 ↗
41. Reinforcing the corrosion protection property of epoxy coating by using graphene oxide-poly(urea-formaldehyde) composites10.1016/j.corsci.2017.04.019 ↗
42. Composite magnesium phosphate coatings for improved corrosion resistance of magnesium AZ31 alloy10.1016/j.corsci.2016.10.010 ↗
43. Corrosion protection of magnesium alloys by cerium, zirconium and niobium-based conversion coatings10.1016/j.corsci.2008.03.015 ↗
44. Self-healing ceria-modified coating for corrosion protection of AZ31 magnesium alloy10.1016/j.corsci.2018.06.013 ↗
45. Use of electrochemical impedance spectroscopy (EIS) for the evaluation of electrocoatings performances
46. Hybrid epoxy-silane coatings for improved corrosion protection of Mg alloy10.1016/j.corsci.2012.10.013 ↗
47. Scratch-resistant anti-corrosion sol-gel coating for the protection of AZ31 magnesium alloy via a low temperature sol-gel route10.1016/j.corsci.2010.04.002 ↗
48. Corrosion protection of aluminum-alloys and metal matrix composites by polymer-coatings10.1016/0010-938X(92)90176-4 ↗
49. Another approach in analysis of paint coatings with EIS measurement: phase angle at high frequencies10.1016/j.corsci.2006.03.012 ↗
50. The evaluation of coating performance by the variations of phase angles in middle and high frequency domains of EIS10.1016/j.corsci.2008.08.049 ↗
51. Siloxane-PMMA hybrid anti-corrosion coatings reinforced by lignin10.1016/j.surfcoat.2015.05.002 ↗