A non-destructive method to infer the bulk lifetime in high-quality silicon wafers
Source abstract
Abstract
The bulk lifetime (τ bulk ) of high-quality silicon wafers is becoming ever more important as the efficiency of the solar cells increases (i.e. >27 %). As such there is a growing necessity to measure τ bulk directly. In this work, we showcase a non-destructive technique to infer τ bulk of high-quality wafers, termed the Charge Decoupling Method. This method is very simple and only requires atomic layer deposited (ALD) aluminium oxide (Al 2 O 3 )—or any other highly charged film (e.g. >10 12 q cm −2 )—and corona charging. By measuring the decay in the effective lifetime as the net negative charge decreases—due to the sequential deposition of positive corona charges—we can quantify the shape of the curve—analogous to the fill factor for a solar cell—and from this, determine the injection-dependent τ bulk and surface recombination velocity S . To experimentally verify the method, we apply the charge decoupling method to Al 2 O 3 passivated Czochralski-grown 5 Ω cm, n -type, 150 μm thick silicon wafers. From this we obtain a τ bulk of ∼30 ms and a corresponding S of 0.2 cm −1 at an injection level of ∼10 15 cm −3 . Mathematically, we demonstrate that the charge decoupling method depends solely on the ratio of surface to bulk recombination and thus does not depend on the doping type, resistivity, charge density, wafer thickness, interface defect density and the injection-dependent bulk lifetime. • We showcase a method to infer the bulk lifetime of high-quality silicon wafers, termed the Charge Decoupling Method (CDM). • The method only requires a non-leaky dielectric layer and corona charging. • We measure a bulk lifetime of ∼30 ms (at Δ n = 10 15 cm −3 ) on Cz, 5 Ω cm, n -type, 150 μm thick silicon wafers. • Mathematically, we demonstrate that CDM depends solely on the ratio of surface to bulk recombination. • The CDM method can be used without calibrating the corona charger from time to deposited charge.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · solar cell performance optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (27)
Show source-provided references
1. Field-effect passivation of the SiO2/Si interface10.1063/1.370784 ↗
2. Corona charge in SiO2: Kinetics and surface passivation for high efficiency silicon solar cells10.1016/j.egypro.2016.07.090 ↗
3. Long term stability of c-Si surface passivation using corona charged SiO210.1016/j.apsusc.2017.03.204 ↗
4. The study of thermal silicon dioxide electrets formed by corona discharge and rapid-thermal annealing10.1063/1.3559260 ↗
5. Dielectric surface passivation for silicon solar cells: a review
6. Surface passivation of crystalline silicon solar cells: present and future10.1016/j.solmat.2018.06.047 ↗
7. On effective surface recombination parameters10.1063/1.4886595 ↗
8. Atomic level termination for passivation and functionalisation of silicon surfaces10.1039/D0NR03860A ↗
9. Electronic characteristics of ultra-thin passivation layers for silicon photovoltaics10.1002/admi.202201339 ↗
10. Activation of Al2O3 surface passivation of silicon: separating bulk and surface effects10.1016/j.apsusc.2023.158786 ↗
11. Inter-laboratory study of eddy-current measurement of excess-carrier recombination lifetime10.1109/JPHOTOV.2013.2284375 ↗
12. A mass spectrometric study of ions extracted from point to plane DC corona discharge fed by carbon dioxide at atmospheric pressure10.1016/j.ijms.2008.05.016 ↗
13. Noise and the Kelvin method10.1063/1.1142494 ↗
14. Determination of Si-SiO2 interface recombination parameters using a gate-controlled point-junction diode under illumination10.1109/16.2441 ↗
15. Impact of illumination level and oxide parameters on shockley–read–hall recombination at the Si‐SiO2 interface10.1063/1.350782 ↗
16. Modeling Recombination at the Si–Al2O3 Interface10.1109/JPHOTOV.2013.2247464 ↗
17. Reassessment of the intrinsic bulk recombination in crystalline silicon10.1016/j.solmat.2021.111467 ↗
18. Statistics of the recombinations of holes and electrons10.1103/PhysRev.87.835 ↗
19. Green · 1981 · 274
20. Improved quantitative description of auger recombination in crystalline silicon10.1103/PhysRevB.86.165202 ↗
21. Unusually low surface-recombination velocity on silicon and germanium surfaces10.1103/PhysRevLett.57.249 ↗
22. Superacid-treated silicon surfaces: extending the limit of carrier lifetime for photovoltaic applications10.1109/JPHOTOV.2017.2751511 ↗
23. Superacid-derived surface passivation for measurement of ultra-long lifetimes in silicon photovoltaic materials10.1016/j.solmat.2018.03.028 ↗
24. Temporary surface passivation for characterisation of bulk defects in silicon: a review10.1002/pssr.201700243 ↗
25. Thermal activation and deactivation of grown-in defects limiting the lifetime of float-zone silicon10.1002/pssr.201600080 ↗
26. Permanent annihilation of thermally activated defects which limit the lifetime of float-zone silicon10.1002/pssa.201600360 ↗
27. Accounting for the dependence of coil sensitivity on sample thickness and lift-off in inductively coupled photoconductance measurements10.1109/JPHOTOV.2019.2942484 ↗