Heat transfer analysis in a thermal barrier coating using a small-scale kerosene burner
Source abstract
Abstract
This study presents an experimental methodology to characterize heat transfer and effective thermal conductivity in thermal barrier coatings (TBCs) under combustor relevant conditions, using a small-scale kerosene-burner. APS YSZ with two porosity levels (cold and hot) and GZO coatings were investigated under steady flames, with power levels from 10 to 25 kW and equivalence ratios ( ) between 0.6 and 1.0. Backside temperatures were measured using Type K thermocouples, while a multispectral camera was used to retrieve surface temperature and apparent‑ emissivity through the flame. A water-cooled Gardon gauge enabled separation of radiative and total heat fluxes. For flame temperatures ranging from 1050 to 1450 °C, radiative heat transfer was found to contribute 48–69% of the total heat load.Steady-state one-dimensional energy-balance and thermal-resistance models were coupled to the measurements to evaluate the effective thermal conductivity of the TBCs. The pristine YSZ-cold, YSZ-hot and GZO coatings exhibited mean conductivities of respectively , and W/(m⋅K), consistent with the influence of porosity. To quantify the effect of CMAS deposits infiltration through the coating, the samples were contaminated using two types of powders, namely CMFAS, a FeOx-enriched CMAS, and AFRL. CMFAS contamination increased the conductivity of the contaminated YSZ layers to W/(m⋅K)(YSZ-cold, +41%) and W/(m⋅K) (YSZ-hot, +9.5%) and caused in-test failure of GZO. Cross-sectional SEM/EDS measurements indicated complete infiltration for the more porous coating, while infiltration was limited to the first 150 µm for the denser coating. AFRL contamination was mostly limited to the upper part of the TBC layer and had a small impact on its effective thermal conductivity (< 10%). Near-IR transmission measurements further showed increases of 5-15% after contamination, consistent with the increase in thermal conductivity. Overall, the methodology demonstrates that small-scale combustors can be used to extract thermo-optical properties of TBCs under realistic operating conditions as well as the effect of CMAS infiltration.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High-Temperature Coating Behaviors · Heat and Mass Transfer in Porous Media · Combustion and flame dynamics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. Advances on strategies for searching for next generation thermal barrier coating materials10.1016/j.jmst.2018.11.016 ↗
2. Matarazzo · 2011 · 12
3. Overview of thermal barrier coatings in diesel engines10.1007/BF02646312 ↗
4. Thermal-barrier coatings for more efficient gas-turbine engines10.1557/mrs.2012.232 ↗
5. Thermal barrier coating materials10.1016/S1369-7021(05)70934-2 ↗
6. EB-PVD thermal barrier coatings for Aeroengines and gas turbines10.1002/1527-2648(200104)3:4<193::AID-ADEM193>3.0.CO;2-U ↗
7. Infrared-optical properties and heat transfer coefficients of semitransparent thermal barrier coatings10.1016/j.surfcoat.2008.09.033 ↗
8. Analysis of thermal radiation effects on temperatures in turbine engine thermal barrier coatings10.1016/S0921-5093(97)00845-9 ↗
9. Impact of radiation on the wall heat load at a test bench gas turbine combustion chamber: measurements and cfd simulation
10. Application of thermal barrier coatings in diesel engines: a review10.5923/j.ep.20120201.02 ↗
11. The effects of thermal barrier coatings on diesel engine emissions10.1115/1.2817108 ↗
12. Wall heat flux measurements for a kerosene-fueled supersonic combustor10.1061/(ASCE)AS.1943-5525.0001076 ↗
13. Overall cooling effectiveness of effusion cooled and thermal barrier coated swirl stabilized liquid fueled combustor liner in reacting flow conditions with infrared thermography
14. Mechanisms of cracking and delamination within thick thermal barrier systems in aero-engines subject to calcium-magnesium-alumino-silicate (CMAS) penetration10.1016/j.msea.2008.01.006 ↗
15. Blanchard · 2023
16. Effects of growth stress in finite-deformation thermally grown oxide on failure mechanism of thermal barrier coatings10.1016/j.mechmat.2017.08.011 ↗
17. Thermochemical interaction of thermal barrier coatings with molten CaO–MgO–Al2 O3 –SiO2 (CMAS) deposits10.1111/j.1551-2916.2006.01209.x ↗
18. A new test facility for investigating the interaction between swirl flow and wall cooling films in combustors
19. Composite aircraft engine fire walls: a small-scale experimental testbed to study thermomechanical degradation under fire
20. Scaling methodology of the FAA burner for pre-qualification fire tests of aircraft engine panels
21. “OMEGABOND OB-600.” OMEGA. [Online]. Available: https://assets.omega.com/manuals/M1239.pdf.
22. Thermocouple response in fires, part 1: considerations in flame temperature measurements by a thermocouple10.1177/0734904110386187 ↗
23. Surface temperature and emissivity assessment in an enclosed cavity at high temperature using IR thermography10.1016/j.infrared.2025.105815 ↗
24. Goodwin · 2024
25. The ignition, oxidation, and combustion of kerosene: a review of experimental and kinetic modeling10.1016/j.pecs.2005.10.003 ↗
26. Electrical resistivity measured by millisecond pulse heating in comparison with thermal conductivity of the superalloy inconel 625 at elevated temperature10.1007/s10765-019-2490-8 ↗
27. Thermal-conductivity apparatus for steady-state, comparative measurement of ceramic coatings10.6028/jres.105.050 ↗
28. The effect of grain size, porosity and yttria content on the thermal conductivity of nanocrystalline zirconia10.1016/S1359-6462(98)00290-5 ↗
29. Trice · 2011
30. Effect of melting state on the thermal shock resistance and thermal conductivity of APS ZrO2–7.5wt.% Y2O3 coatings10.1016/j.surfcoat.2015.03.011 ↗
31. Thermal diffusivity characterization of bond-coat materials used for thermal barrier coatings10.1007/s10973-016-5785-z ↗
32. Ceramic materials for thermal barrier coatings10.1016/S0955-2219(03)00129-8 ↗
33. The effects of fuel sooting tendency and the flow on flame radiation in luminous turbulent jet flames10.1080/00102209208951854 ↗
34. The impact of radiative heat transfer in combustion processes and its modeling – with a focus on turbulent flames10.1016/j.fuel.2020.118555 ↗
35. Multilayer thermal barrier coating (TBC) architectures utilizing rare earth doped YSZ and rare earth pyrochlores10.1016/j.surfcoat.2014.03.049 ↗
36. Effect of the starting microstructure on the thermal properties of as-sprayed and thermally exposed plasma-sprayed YSZ coatings10.1111/j.1551-2916.2009.02953.x ↗
37. Infiltration-inhibiting reaction of gadolinium Zirconate thermal barrier coatings with CMAS melts10.1111/j.1551-2916.2007.02175.x ↗
38. Plasma sprayed gadolinium zirconate thermal barrier coatings that are resistant to damage by molten Ca–Mg–Al–silicate glass10.1016/j.surfcoat.2012.03.051 ↗