journal article·1968-06

Some Mechanical Properties of Resorcinol-Formaldehyde Latex (RFL) Tire Cord Adhesive

G. Raumann

Textile Research Journal· Volume 38· Issue 6
Publisher page

Abstract

Films of resorcinol-formaldehyde latex (RFL) films were made by casting on mercury. The tensile stress-strain curves and tensile and bending moduli were determined for films with different heat-curing conditions and different resin/latex ratios. The heat treatments (240° for 30 min conditions were more severe than in normal hot-dipping and vulcanizing) showed no significant change on the mechanical properties of the films. Changes in the latex/resin ratio produced gradual (not sudden or stepwise) changes in the mechanical properties. The dynamic Young's modulus and loss factor for a standard formulation film from -20°C to +120°C showed small changes, indicating a one-phase system of resin and latex. This evidence was supported by microscopic and electron microscopic evidence. Standard RFL film was shown to be a tough material of adequate extensibility (16%) and a modulus (2.3 × 10 6 g. cm -2 ) Intermediate between that of rubber skim stock and nylon tire cord. Its mechanical loss factor shows that it does not contribute unduly to the heat generated in a tire.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Polymer composites and self-healing · Asphalt Pavement Performance Evaluation · Advanced Polymer Synthesis and Characterization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Chemstrand Research Center, Inc., Durham, North Carolina 27702, U. S. A.

References (3)

Show source-provided references
1. Butterworth, G. A. M., Davis, S. J., and Platt, (to be published).
2. Wilson, M.W. · Textile Res. J · 1951 · 21 · 4710.1177/004051755102100110 ↗
3. Dlugosz, J. · 1962