journal article·2019-01-24

Elastic Lubricious Effect of Solidlike Boundary Films in Oil-Starvation Lubrication

Jiao Xu, Jingyan Nian, Peng Wang, Zhiguang Guo, Weimin Liu

Publisher page

Abstract

Herein, a boundary lubrication (BL) mechanism based on the carbon-based tribofilms formed via Ni(Cu)-catalytic dehydrogenation of hydrocarbon oils was queried by performing standard ball-on-disk tribotests on magnetron-sputtered WN, Ni, and W–N–Ni coatings in the oil-starvation condition. The experimental results indicate that both the bare GCr15 steel substrate and the sputtered W–N–Ni/MoN–Cu coatings exhibited comparable fine antiwear performance with friction coefficients below 0.09; however, no clues regarding the formation of the effectiveness of the graphite-like tribofilms on the contact surfaces were found, no matter whether the tested coatings were composited in amorphous or nanocrystallized structures. An understanding of the antiwear mechanism was achieved by conducting a nonequilibrium molecular dynamics (NEMD) simulation of the confined shearing process, taking 1-decene chains as a model of the poly-α-olefin 10 base oil. It was found that as the normal load increases from 0.14 to 9.2 GPa, the “sandwiched” sheared oil molecules undergo a liquid-to-solidlike phase transition at a threshold pressure of approximately 0.54 GPa, above which the solidified oil film responds as an elastic protective layer between rigid walls and provides lower friction coefficients and energy dissipation than those of laminar shear motion. The main reasons are the elastic compliance of solidlike oil molecules and the occurrence of boundary slippage on the liquid–wall interface. The comparison of NEMD simulation among confined sheared boundary films of nonhydrogenated diamond-like carbon (DLC), hydrogen-terminated DLC, laminar fluid layers, and solidified oil films further reveals that it is the flexibility of C–C backbones as well as the elastic compliance of terminal C–H bonds that play a dominant role in the low-friction behavior of solidlike oil films in oil-starvation lubrication. Moreover, the simulation results indicate that the temperature increment of the confined sheared 1-decene under 0.14–9.2 GPa loads is generally below 20 K, which is far below the active temperature of 1-decene’s catalytic dehydrogenation and pyrolysis reaction. These results support that in a steady state BL with low friction coefficients at room temperature, the formation of lubricious tribofilms via catalytic dissociation of alkanes can hardly be triggered due to the limited temperature increment, even when the catalysts of Ni/Cu are composited in the sliding surfaces.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Lubricants and Their Additives · Adhesion, Friction, and Surface Interactions · Diamond and Carbon-based Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000, People’s Republic of China

Center of Materials Science and Optoelectronics Engineering, University of Chinese Academy of Science, Beijing 100049, China

Funding

National Natural Science Foundation of China · The National Key Research and Development Program of China · State Key Laboratory of Tribology, Tsinghua University

References (48)

Show source-provided references
1. 10.1016/0043-1648(69)90017-910.1016/0043-1648(69)90017-9 ↗
2. 10.1115/1.345319710.1115/1.3453197 ↗
3. 10.1126/science.250.4982.79210.1126/science.250.4982.792 ↗
4. Schipper D. J. · 1995
5. 10.1016/s0022-5096(98)00068-410.1016/s0022-5096(98)00068-4 ↗
6. 10.1021/jp982150q10.1021/jp982150q ↗
7. 10.1038/3868610.1038/38686 ↗
8. 10.1115/1.153819410.1115/1.1538194 ↗
9. 10.1016/0043-1648(95)06799-x10.1016/0043-1648(95)06799-x ↗
10. 10.1080/1040200910898202610.1080/10402009108982026 ↗
11. 10.1016/j.triboint.2009.12.05910.1016/j.triboint.2009.12.059 ↗
12. 10.1063/1.45906710.1063/1.459067 ↗
13. 10.1038/nature1894810.1038/nature18948 ↗
14. 10.1007/s11249-014-0347-710.1007/s11249-014-0347-7 ↗
15. 10.1007/s11249-015-0505-610.1007/s11249-015-0505-6 ↗
16. 10.1007/s00542-014-2166-z10.1007/s00542-014-2166-z ↗
17. 10.1007/s11249-013-0224-910.1007/s11249-013-0224-9 ↗
18. 10.1115/1.402658910.1115/1.4026589 ↗
19. 10.1115/1.402888110.1115/1.4028881 ↗
20. 10.1016/j.triboint.2014.08.00410.1016/j.triboint.2014.08.004 ↗
21. 10.1016/j.wear.2008.12.07210.1016/j.wear.2008.12.072 ↗
22. 10.1021/jp980939v10.1021/jp980939v ↗
23. 10.1021/jp903505610.1021/jp9035056 ↗
24. 10.1016/j.wear.2013.01.05210.1016/j.wear.2013.01.052 ↗
25. 10.1021/jp004368u10.1021/jp004368u ↗
26. 10.1021/jp210743910.1021/jp2107439 ↗
27. 10.1021/ef400143z10.1021/ef400143z ↗
28. 10.1021/la400698310.1021/la4006983 ↗
29. 10.1021/jp408109610.1021/jp4081096 ↗
30. 10.1021/jp402139h10.1021/jp402139h ↗
31. 10.1063/1.174008210.1063/1.1740082 ↗
32. 10.1143/jpsj.12.57010.1143/jpsj.12.570 ↗
33. 10.1080/0026897980948219510.1080/00268979809482195 ↗
34. 10.1115/1.273643310.1115/1.2736433 ↗
35. 10.1115/1.290890810.1115/1.2908908 ↗
36. 10.3390/ma908065110.3390/ma9080651 ↗
37. 10.1021/acs.langmuir.6b0058610.1021/acs.langmuir.6b00586 ↗
38. 10.1103/physrevlett.79.70510.1103/physrevlett.79.705 ↗
39. 10.1080/0569819600897238110.1080/05698196008972381 ↗
40. 10.1098/rspa.1974.004610.1098/rspa.1974.0046 ↗
41. 10.1243/pime_proc_1967_182_029_0210.1243/pime_proc_1967_182_029_02 ↗
42. 10.1080/0010751700820441010.1080/00107517008204410 ↗
43. 10.1002/ls.12610.1002/ls.126 ↗
44. 10.1007/s11249-013-0113-210.1007/s11249-013-0113-2 ↗
45. 10.1023/a:102194283013210.1023/a:1021942830132 ↗
46. 10.1021/jp207065n10.1021/jp207065n ↗
47. 10.1021/jp904871t10.1021/jp904871t ↗
48. 10.1021/cr500243610.1021/cr5002436 ↗