journal article·1991-05-01

Dry Etching of GaAs , AlGaAs , and GaSb Using Electron Cyclotron Resonance and Radio Frequency CH 4 / H 2 / Ar or C 2 H 6 / H 2 / Ar Discharges

S. J. Pearton, U. K. Chakrabarti, A. P. Perley, W. S. Hobson, M. Geva

Publisher page

Abstract

A comparison is made of the dry etching characteristics of , , and in or discharges excited by combined electron cyclotron resonance and radio frequency (RF) power. For a given set of conditions the etching is approximately 50% faster than with plasmas. Similarly, the addition of 150 W of microwave power to a given RF discharge enhances the etch rates of all three semiconductors by about a factor of two. The etch rates increase linearly with both RF and microwave power level, and smooth surface morphologies are obtained for microwave powers of 200 W or less. Above this power level, all three materials show roughened surfaces. The etched surfaces show slightly higher carbon concentrations than control sections. The use of as a replacement for either methane or ethane has no advantage in terms of enhancing the etch rates. Damage introduction depths up to 1000 Å are measured for high bias hydrogen or argon discharges by using multiquantum well structures as a probe of the presence of optically active defects.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Semiconductor materials and devices · Plasma Diagnostics and Applications · Electrostatic Discharge in Electronics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

AT&T Bell Laboratories, Murray Hill, New Jersey 07974

AT&T Bell Laboratories, Solid State Technology Center, Breinigsville, Pennsylvania 18031

References

Reference metadata was not supplied for this record.