Nanoscopic dynamic mechanical analysis of resin–infiltrated dentine, under in vitro chewing and bruxism events
Source abstract
Abstract
The aim of this study was to evaluate the induced changes in mechanical behavior and bonding capability of resin-infiltrated dentine interfaces, after application of mechanical stimuli. Dentine surfaces were subjected to partial demineralization through 37% phosphoric acid etching followed by the application of an etch-and-rinse dentine adhesive, Single Bond (3M/ESPE). Bonded interfaces were stored in simulated body fluid during 24h, and then tested or submitted to the mechanical loading challenge. Different loading waveforms were applied: No cycling (I), 24h cycled in sine (II) or square (III) waves, sustained loading held for 24h (IV) or sustained loading held for 72h (V). Microtensile bond strength (MTBS) was assessed for the different groups. Debonded dentine surfaces were studied by field emission scanning electron microscopy (FESEM). At the resin-dentine interface, both the hybrid layer (HL) and the bottom of the hybrid layer (BHL), and both peritubular and intertubular were evaluated using a nanoindenter in scanning mode. The load and displacement responses were used to perform the nano-Dynamic Mechanical analysis and to estimate the complex and storage modulus. Dye assisted Confocal Microscopy Evaluation was used to assess sealing ability. Load cycling increased the percentage of adhesive failures in all groups. Specimens load cycled in held 24h attained the highest complex and storage moduli at HL and BHL. The storage modulus was maximum in specimens load cycled in held 24h at peritubular dentine, and the lowest values were attained at intertubular dentine. The storage modulus increased in all mechanical tests, at peritubular dentine. An absence of micropermeability and nanoleakage after loading in sine and square waveforms were encountered. Porosity of the resin-dentine interface was observed when specimens were load cycled in held 72h. Areas of combined sealing and permeability were discovered at the interface of specimens load cycled in held 24h. Crack-bridging images appeared in samples load cycled with sine waveform, after FESEM examination.
Source: europepmc · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Dental materials and restorations · Endodontics and Root Canal Treatments · Dental Erosion and Treatment
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (49)
Show source-provided references
1. Speed-dependent control of cyclic open–close movements of the human jaw with an external force counteracting closing10.1177/00220345990780040801 ↗
2. Nanoscale damping characteristics of boron nitride nanotubes and carbon nanotubes reinforced polymer composites10.1021/am4038678 ↗
3. Nanoindentation: Application to dental hard tissue investigations10.1557/jmr.2006.0257 ↗
4. Evaluation of a new modulus mapping technique to investigate microstructural features of human teeth10.1016/j.jbiomech.2003.12.012 ↗
5. Biomechanical perspective on the remineralization of dentin10.1159/000201593 ↗
6. Dynamic nanoindentation of some polyolefins10.1002/pen.20596 ↗
7. Characterization of the elastic and viscoelastic properties of dentin by a nanoindentation creep test10.1016/j.jbiomech.2015.01.034 ↗
8. A critical review of the durability of adhesion to tooth tissue:methods and results10.1177/154405910508400204 ↗
9. Viscoelastic properties of bovine knee joint articular cartilage: dependency on thickness and loading frequency10.1186/1471-2474-15-205 ↗
10. Characterisation of resin–dentine interfaces by compressive cyclic loading10.1016/j.biomaterials.2004.07.003 ↗
11. Strength characteristics of toughened ceramics containing contact-induced small surface cracks10.1016/S0921-5093(02)00396-9 ↗
12. High-cycle fatigue life extension of glass fiber/polymer composites with carbon nanotubes10.1007/s11595-009-2167-4 ↗
13. Nanomechanics of the cartilage extracellular matrix10.1146/annurev-matsci-062910-100431 ↗
14. Viscoelastic properties of cell walls of single living plant cells determined by dynamic nanoindentation10.1093/jxb/err428 ↗
15. Über die Berührung fester elastischer Körpen (On the contact of rigid elastic solids)
16. An investigation of cuspal deformation and delayed recovery after occlusal loading10.1016/S0300-5712(01)00018-5 ↗
17. Micromechanics of the dentin/adhesive interface10.1002/jbm.1030 ↗
18. A micromechanics model of the elastic properties of human dentine10.1016/S0003-9969(99)00080-1 ↗
19. The mechanical properties of human dentin: a critical review and re-evaluation of the dental literature10.1177/154411130301400103 ↗
20. Bonding to dentin with a self-etching primer: the effect of smear layers10.1016/S0109-5641(00)00049-X ↗
21. Extreme damping in composite materials with negative-stiffness inclusions10.1038/35069035 ↗
22. Bruxism physiology and pathology: an overview for clinicians10.1111/j.1365-2842.2008.01881.x ↗
23. Macosko · 1994
24. The dentin substrate: structure and properties related to bonding10.1016/S0300-5712(96)00065-6 ↗
25. Micromechanical analysis of dentin/adhesive interface by the finite element method10.1002/jbm.b.30012 ↗
26. Parametric study of the effect of phase anisotropy on the micromechanical behaviour of dentin-adhesive interfaces10.1098/rsif.2005.0029 ↗
27. The hybrid layer: a resin–dentin composite
28. Nanci · 2008
29. Evaluation of thermal cycling and mechanical loading on bond strength of a self-etching primer system to dentin10.1016/S0109-5641(01)00048-3 ↗
30. Cementum crack formation by repeated loading in vitro10.1902/jop.2007.060328 ↗
31. Nocturnal bruxing events in healthy geriatric subjects10.1111/j.1365-2842.1990.tb01412.x ↗
32. An improved technique for determining hardness and elastic-modulus using load and displacement sensing indentation experiments10.1557/JMR.1992.1564 ↗
33. EDTA treatment improves resin–dentin bonds׳ resistance to degradation10.1177/154405910508400810 ↗
34. Polymer nanocarriers for dentin adhesion10.1177/0022034514551608 ↗
35. Pawley · 2006
36. Experimental etch-and-rinse adhesives doped with bioactive calcium silicate-based micro-fillers to generate therapeutic resin–dentin interfaces10.1016/j.dental.2013.04.001 ↗
37. Bioactive effects of a calcium/sodium phosphosilicate on the resin-dentine interface: a microtensile bond strength, scanning electron microscopy, and confocal microscopy study10.1111/j.1600-0722.2012.00974.x ↗
38. Effect of removal of surface collagen fibrils on resin–dentin bonding10.1016/S0109-5641(99)00052-4 ↗
39. Dentin caries: mineral structure, and properties10.1177/0022034508327552 ↗
40. A characterization of the mechanical behavior of resin–infiltrated dentin using nanoscopic Dynamic Mechanical Analysis10.1016/j.dental.2013.03.022 ↗
41. Importance of age on the dynamic mechanical behavior of intertubular and peritubular dentin10.1016/j.jmbbm.2014.11.021 ↗
42. Therapeutic effects of novel resin bonding systems containing bioactive glasses on mineral-depleted areas within the bonded-dentin interface10.1007/s10856-012-4606-6 ↗
43. Load cycling enhances bioactivity at the resin-dentin interface10.1016/j.dental.2014.02.009 ↗
44. Effect of in vitro chewing and bruxism events on remineralization, at the resin–dentin interface10.1016/j.jbiomech.2014.11.014 ↗
45. Effect of cyclic loading on the microtensile bond strengths of total-etch and self-etch adhesives10.2341/04-161 ↗
46. A Zn-doped etch-and-rinse adhesive may improve the mechanical properties and the integrity at the bonded-dentin interface10.1016/j.dental.2013.04.024 ↗
47. A ZnO-doped adhesive reduced collagen degradation favouring dentine remineralization10.1016/j.jdent.2012.05.007 ↗
48. Hybridization efficiency of the adhesive/dentin interface with wet bonding10.1177/154405910308200213 ↗
49. Collagen cross linking increases its biodegradation resistance in wet dentin bonding