Microstructural heterogeneity in rate-dependent plasticity of multiphase titanium alloys
Source abstract
Abstract
Polycrystalline rate-dependent plasticity is found to originate from heterogeneous slip system/phase rate response. Micro-mechanism under low stress and low temperature (T < 0.3Tm) has been shown to be different from conventional rate sensitivity expectations. Hence the constitutive framework developed is dependent on the crystallographic orientation, properly capturing micro-scale anisotropic rate behaviour. The intrinsic rate anisotropy of the HCP α prism and basal and BCC β phase slip systems in Ti-6242, recently determined from micro-pillar and crystal plasticity modelling, have been utilised to investigate the structural strain rate sensitivities of colonies, polycrystals, bimodal and basket weave microstructures. The rate sensitivity of colony structures is dominated by the HCP α phase behaviour, at least for alloys containing up to ∼20% volume fraction β phase, and is largely independent of β-lath orientation. The apparent anisotropy of a1, a2 and a3 basal resolved shear stresses in Ti-6242 colonies is shown to originate from the local crystal stress states established as opposed to the α−β interfaces. Texture and α−β morphology are shown to affect rate dependence and to corroborate that the basal rate sensitivity is stronger than that for prism slip in Ti-6242. Morphological effects are shown to affect rate dependence but not strongly, but the number of HCP α phase variants in basketweave structures is found to have a significant effect with higher numbers of variants leading to lower strain rate sensitivities. This is potentially important in designing alloys to resist cold dwell fatigue.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Titanium Alloys Microstructure and Properties · Microstructure and mechanical properties · Metallurgy and Material Forming
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (76)
Show source-provided references
1. Incorporation of twinning into a crystal plasticity finite element model: evolution of lattice strains and texture in Zircaloy-210.1016/j.ijplas.2011.04.005 ↗
2. New perspectives in plasticity theory: dislocation nucleation, waves, and partial continuity of plastic strain rate10.1177/1081286507086903 ↗
3. Creep of titanium at room temperature
4. Micromechanical modeling of hardening mechanisms in commercially pure α-titanium in tensile condition10.1016/j.ijplas.2015.09.008 ↗
5. A rationalization of stress-strain behavior of two-ductile phase alloys10.1007/BF02645919 ↗
6. Mechanistic models for the activation volume and rate sensitivity in metals with nanocrystalline grains and nano-scale twins10.1016/j.actamat.2005.03.047 ↗
7. A review of dwell sensitive fatigue in titanium alloys: the role of microstructure, texture and operating conditions10.1016/S0142-1123(03)00145-2 ↗
8. Creep studies of Ti-6242-Si alloy
9. Cross-slipping process and the stress-orientation dependence in pure copper10.1016/0001-6160(79)90170-6 ↗
10. Caillard · 2003
11. Effect of rate sensitivity on slip system activity and lattice rotation10.1016/0001-6160(88)90298-2 ↗
12. Creep behavior of Ti-6242: the effect of microstructure and silicon content
13. Effect of interstitial solutes on the strength and ductility of titanium10.1016/0079-6425(81)90001-3 ↗
14. On the rate-controlling mechanism for plastic flow of Mg crystals at low temperatures10.1016/0001-6160(61)90230-9 ↗
15. Activation energy for deformation of metals at low temperatures10.1016/0001-6160(60)90097-3 ↗
16. Dieter · 1986
17. Donachie · 2000
18. Lengthscale-dependent, elastically anisotropic, physically-based hcp crystal plasticity: application to cold-dwell fatigue in Ti alloys10.1016/j.ijplas.2006.10.013 ↗
19. The thermally activated deformation of crystalline materials10.1002/pssb.19690340102 ↗
20. Creep-fatigue interactions in Ti-6 Al-4 V at ambient temperatures
21. Optimising mechanical properties in alpha+ beta titanium alloys10.1016/S0921-5093(97)00784-3 ↗
22. Viscosity, plasticity, and diffusion as examples of absolute reaction rates10.1063/1.1749836 ↗
23. Stress relaxation in copper and alpha-brasses at low temperatures
24. Creep and stress relaxation in alpha-brass at low temperatures10.1080/14786436108243315 ↗
25. Stress relaxation in magnesium at low temperatures10.1002/pssb.19630030805 ↗
26. Thermodynamic analysis of dislocation glide controlled by dispersed local obstacles10.1016/0025-5416(69)90026-3 ↗
27. Anisotropy in the plastic flow properties of single-crystal α titanium determined from micro-cantilever beams10.1016/j.actamat.2009.07.064 ↗
28. Orientation dependence of cyclic deformation in high purity titanium single crystals10.1016/0921-5093(94)90352-2 ↗
29. Stress relaxation and the plastic deformation of solids10.1002/pssb.19640060108 ↗
30. The effect of orientation on the yielding and flow of molybdenum single crystals10.1002/pssb.19660150214 ↗
31. An analysis of the thermodynamics of dislocation glide10.1002/pssb.19690350116 ↗
32. Temperature dependence of yield stress, deformation mode and deformation structure in single crystals of TiAl (Ti-56 at% Al)10.1080/01418619708205149 ↗
33. Texture dependent strain rate sensitivity of ultrafine-grained aluminum films10.1016/j.scriptamat.2015.12.003 ↗
34. A nanoindentation investigation of local strain rate sensitivity in dual-phase Ti alloys10.1016/j.jallcom.2016.02.146 ↗
35. Local strain rate sensitivity of single α phase within a dual-phase Ti alloy10.1016/j.actamat.2016.01.057 ↗
36. Thermodynamics and kinetics of slip
37. Strain-rate sensitivity and microstructural evolution in a Mg–Al–Zn alloy10.1016/j.scriptamat.2010.06.047 ↗
38. Effects of microstructure variability on intrinsic fatigue resistance of nickel-base superalloys–a computational micromechanics approach10.1007/s10704-005-3149-y ↗
39. Creep of precipitation-hardened nickel-base alloy single crystals at high temperatures10.1007/BF02649637 ↗
40. Influence of processing on microstructure and mechanical properties of (alpha+beta) titanium alloys10.1016/S0921-5093(97)00778-8 ↗
41. Lütjering · 2007
42. May · 2010
43. A three-dimensional crystal plasticity model for duplex Ti–6Al–4V10.1016/j.ijplas.2006.11.006 ↗
44. Mechanical properties of nanocrystalline materials10.1016/j.pmatsci.2005.08.003 ↗
45. Microstructure, creep, and tensile deformation in Ti-6Al-2Nb-1Ta-0.8 Mo10.1007/BF02646658 ↗
46. Phenonomenological and microstructural analysis of room temperature creep in titanium alloys10.1016/S1359-6454(99)00426-7 ↗
47. A comprehensive unit cell model: a study of coupled effects in piezoelectric 1–3 composites10.1016/S0020-7683(99)00224-3 ↗
48. A comparative study on dwell fatigue of Ti-6Al-2Sn-4Zr-xMo (x= 2 to 6) alloys on a microstructure-normalized basis10.1007/s11661-014-2541-5 ↗
49. Primary creep in single crystal superalloys: origins, mechanisms and effects10.1016/j.actamat.2006.09.026 ↗
50. Yielding and plastic flow in single crystals of tungsten
51. Deformation mechanisms and microtensile behavior of single colony Ti–6242Si10.1016/S0921-5093(01)01024-3 ↗
52. Anisotropy in the room-temperature deformation of alpha-beta colonies in titanium alloys: role of the alpha-beta interface10.1080/1478643032000158305 ↗
53. The temperature dependence of the critical shear stress and of work-hardening of metal crystals10.1080/14786440708520489 ↗
54. Crystallography of fracture facets in a near-alpha titanium alloy10.1007/s11661-006-0144-5 ↗
55. Orientation dependence of the strain-rate sensitivity and thermally activated flow in iron single crystals10.1016/0001-6160(70)90058-1 ↗
56. Mechanisms of primary creep in alpha/beta titanium alloys at lower temperatures10.1016/S0921-5093(97)00322-5 ↗
57. Room temperature deformation and mechanisms of slip transmission in oriented single-colony crystals of an alpha/beta titanium alloy10.1016/S1359-6454(98)00364-4 ↗
58. Thermally-activated deformation of BCC metals and alloys10.1016/0079-6425(92)90004-Q ↗
59. The effect of stacking fault energy on low temperature creep in pure metals10.1080/14786435808237010 ↗
60. Orientation and temperature dependence of yield stress and slip geometry of Ti3Al and Ti3Al-V single crystals10.1016/0956-7151(93)90162-L ↗
61. Overall behaviour of heterogeneous elastoviscoplastic materials: effect of microstructural modelling10.1016/S0167-6636(00)00019-3 ↗
62. Creep behaviour of Ti-6Al-2Sn-4Zr-2Mo: II. Mechanisms of deformation10.1016/S1359-6454(02)00280-X ↗
63. Temperature-dependent strain rate sensitivity and activation volume of nanocrystalline Ni10.1016/j.actamat.2006.02.013 ↗
64. Creep deformation of ice10.1146/annurev.ea.11.050183.001243 ↗
65. Strain rate effects in the ultrafine grain and nanocrystalline regimes—influence on some constitutive responses10.1007/s10853-006-0700-9 ↗
66. Thermomechanical processing of beta titanium alloys - an overview10.1016/S0921-5093(97)00783-1 ↗
67. Thermomechanical processing of alpha titanium alloys - an overview10.1016/S0921-5093(98)01155-1 ↗
68. Welsch · 1993
69. Deformation behavior of HCP Ti-Al alloy single crystals10.1007/s11661-002-0153-y ↗
70. Williams · 2006
71. On rate-dependent polycrystal deformation: the temperature sensitivity of cold dwell fatigue10.1098/rspa.2015.0214 ↗
72. On the formation of adiabatic shear bands in textured HCP polycrystals10.1016/j.ijplas.2015.12.004 ↗
73. Determination of Ti-6242 alpha and beta slip properties using micro-pillar test and computational crystal plasticity10.1016/j.jmps.2016.06.007 ↗
74. Intrinsic anisotropy of strain rate sensitivity in single crystal alpha titanium10.1016/j.actamat.2016.07.044 ↗
75. Dwell fatigue in two Ti alloys: an integrated crystal plasticity and discrete dislocation study10.1016/j.jmps.2016.08.008 ↗
76. Interfacial plasticity governs strain rate sensitivity and ductility in nanostructured metals10.1073/pnas.0611097104 ↗