journal article·2015-04

Ceramic Nano-particle/Substrate Interface Bonding Formation Derived from Dynamic Mechanical Force at Room Temperature: HRTEM Examination

Hai-Long Yao, Guan-Jun Yang, Sheng-Qiang Fan, Cheng-Xin Li, Chang-Jiu Li

Publisher page

Abstract

The bonding of TiO nano-particle/substrate is a critical factor influencing the performance of dye-sensitized solar cells. In order to reveal the bonding properties at TiO nano-particle/substrate interface, high-resolution transmission electron microscopy (HRTEM) analysis was adopted to TiO coatings prepared by three different approaches. In the HRTEM analysis, the effective bonding mode is allowed to distinguish from the false image overlapping. Results show that large areas of effective bonding between nano-TiO particles and the substrate surface formed in the room temperature cold sprayed coating and mechanically pressed coating, while only limited interface areas with the effective bonding were observed in the coating deposited by non-pressed method. These results confirm that both high impact pressure during the room temperature cold spraying and mechanical pressure contribute to the bonding formation at the particle/substrate interface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Bone Tissue Engineering Materials · TiO2 Photocatalysis and Solar Cells

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. B. O’Regan and M. Gratzel, A Low-Cost, High-Efficiency Solar Cell Based on Dye-Sensitized Colloidal TiO2 Films, Nature, 1991, 353(6346), p 737-74010.1038/353737a0 ↗
2. J.Y. Wang, T.J. Zhang, D.F. Wang, R.K. Pan, Q.Q. Wang, and H.M. Xia, Improved Morphology and Photovoltaic Performance in TiO2 Nanorod Arrays Based Dye Sensitized Solar Cells by Using a Seed Layer, J. Alloys Compd., 2013, 551, p 82-8710.1016/j.jallcom.2012.09.113 ↗
3. C.J. Raj, S.N. Karthick, A.D. Savariraj, K.V. Hemalatha, P. Song-Ki, H.J. Kim, and K. Prabakar, Electrochemical Properties of TiO2 Encapsulated ZnO Nanorod Aggregates Dye Sensitized Solar Cells, J. Alloys Compd., 2012, 537, p 159-16410.1016/j.jallcom.2012.05.012 ↗
4. K.M. Lee, V. Suryanarayanan, J.H. Huang, K.R.J. Thomas, J.T. Lin, and K.C. Ho, Enhancing the Performance of Dye-Sensitized Solar Cells Based on an Organic Dye by Incorporating TiO2 Nanotube in a TiO2 Nanoparticle Film, Electrochim. Acta, 2009, 54(16), p 4123-413010.1016/j.electacta.2009.02.052 ↗
5. S.Y. Dai, W.Q. Liu, D.X. Kou, and L.H. Hu, The Kinetics of Electron Transfer Across the Multi-point Contact Interface Through Simplifying the Complex Structure in Dye-Sensitized Solar Cell, Chem. Phys. Lett., 2011, 513(1-3), p 145-14810.1016/j.cplett.2011.07.070 ↗
6. J. Ferber and J. Luther, Modeling of Photovoltage and Photocurrent in dye-Sensitized Titanium Dioxide Solar Cells, J. Phys. Chem. B, 2001, 105(21), p 4895-490310.1021/jp002928j ↗
7. S. Ruhle and T. Dittrich, Investigation of the Electric Field in TiO2/FTO Junctions Used in Dye-Sensitized Solar Cells by Photocurrent Transients, J. Phys. Chem. B, 2005, 109(19), p 9522-952610.1021/jp046211y ↗
8. S. Ruhle and D. Cahen, Electron Tunneling at the TiO2/Substrate Interface Can Determine Dye-Sensitized Solar Cell Performance, J. Phys. Chem. B, 2004, 108(46), p 17946-1795110.1021/jp047686s ↗
9. D. Zhao, T.Y. Peng, L.L. Lu, P. Cai, P. Jiang, and Z.Q. Bian, Effect of Annealing Temperature on the Photoelectrochemical Properties of Dye-Sensitized Solar Cells Made with Mesoporous TiO2 Nanoparticles, J. Phys. Chem. C, 2008, 112(22), p 8486-849410.1021/jp800127x ↗
10. C.P. Hsu, K.M. Lee, J.T.W. Huang, C.Y. Lin, C.H. Lee, L.P. Wang, S.Y. Tsai, and K.C. Ho, EIS Analysis on Low Temperature Fabrication of TiO2 Porous Films for Dye-Sensitized Solar Cells, Electrochim. Acta, 2008, 53(25), p 7514-752210.1016/j.electacta.2008.01.104 ↗
11. S. Mori, K. Sunahara, Y. Fukai, T. Kanzaki, Y. Wada, and S. Yanagida, Electron Transport and Recombination in Dye-Sensitized TiO2 Solar Cells Fabricated Without Sintering Process, J. Phys. Chem. C, 2008, 112(51), p 20505-2050910.1021/jp8065629 ↗
12. G. Boschloo, J. Lindstrom, E. Magnusson, A. Holmberg, and A. Hagfeldt, Optimization of Dye-Sensitized Solar Cells Prepared by Compression Method, J. Photochem. Photobiol. A, 2002, 148(1-3), p 11-1510.1016/S1010-6030(02)00072-2 ↗
13. A. Hagfeldt, G. Boschloo, H. Lindstrom, E. Figgemeier, A. Holmberg, V. Aranyos, E. Magnusson, and L. Malmqvist, A System Approach to Molecular Solar Cells, Coordin. Chem. Rev., 2004, 248(13-14), p 1501-150910.1016/j.ccr.2004.04.012 ↗
14. X.C. Zhao, H. Lin, X. Li, and J.B. Li, The Effect of Compression on Electron Transport and Recombination in Plastic TiO2 Photoanodes, Electrochim. Acta, 2011, 56(18), p 6401-640510.1016/j.electacta.2011.05.015 ↗
15. T. Yamaguchi, N. Tobe, D. Matsumoto, and H. Arakawa, Highly Efficient Plastic Substrate Dye-Sensitized Solar Cells Using a Compression Method for Preparation of TiO2 Photoelectrodes, Chem. Commun., 2007, 45, p 4767-476910.1039/b709911h ↗
16. H. Lindstrom, A. Holmberg, E. Magnusson, L. Malmqvist, and A. Hagfeldt, A New Method to Make Dye-Sensitized Nanocrystalline Solar Cells at Room Temperature, J. Photochem. Photobiol. A, 2001, 145(1-2), p 107-11210.1016/S1010-6030(01)00564-0 ↗
17. S.Q. Fan, G.J. Yang, C.J. Li, G.J. Liu, C.X. Li, and L.Z. Zhang, Characterization of Microstructure of Nano-TiO2 Coating Deposited by Vacuum Cold Spraying, J. Therm. Spray Technol., 2006, 15(4), p 513-51710.1361/105996306X146901 ↗
18. G.J. Yang, C.J. Li, K.X. Liao, X.L. He, S. Li, and S.Q. Fan, Influence of Gas Flow During Room Temperature Cold Spraying of Nano-porous TiO2 Film by Using Strengthened Nanostructured Powder on Performance of Dye-Sensitized Solar Cell, Thin Solid Films, 2011, 519(15), p 4709-471310.1016/j.tsf.2011.01.021 ↗
19. H.L. Yao, G.J. Yang, S. Li, X.L. He, S.Q. Fan, C.X. Li, and C.J. Li, Synergistic Effects of High Temperature and Impact Compaction on the Nano-TiO2 Film for the Significant Improvement of Photovoltaic Performance of Flexible Dye-Sensitized Solar Cells, Electrochim. Acta, 2013, 87, p 940-94710.1016/j.electacta.2012.09.055 ↗
20. H.W. Chen, C.Y. Hsu, J.G. Chen, K.M. Lee, C.C. Wang, K.C. Huang, and K.C. Ho, Plastic Dye-Sensitized Photo-supercapacitor Using Electrophoretic Deposition and Compression Methods, J. Power Sources, 2010, 195(18), p 6225-623110.1016/j.jpowsour.2010.01.009 ↗
21. M. Durr, A. Schmid, M. Obermaier, S. Rosselli, A. Yasuda, and G. Nelles, Low-Temperature Fabrication of Dye-Sensitized Solar Cells by Transfer of Composite Porous Layers, Nat. Mater., 2005, 4(8), p 607-61110.1038/nmat1433 ↗
22. L. Yang, L.Q. Wu, M.X. Wu, G. Xin, H. Lin, and T.L. Ma, High-Efficiency Flexible Dye-Sensitized Solar Cells Fabricated by a Novel Friction-Transfer Technique, Electrochem. Commun., 2010, 12(7), p 1000-100310.1016/j.elecom.2010.05.026 ↗
23. M. Manca, F. Malara, L. Martiradonna, L. De Marco, R. Giannuzzi, R. Cingolani, and G. Gigli, Charge Recombination Reduction in Dye-Sensitized Solar Cells by Means of an Electron Beam-Deposited TiO2 Buffer Layer Between Conductive Glass and Photoelectrode, Thin Solid Films, 2010, 518(23), p 7147-715110.1016/j.tsf.2010.07.047 ↗
24. J.R. Jennings, Y.R. Liu, F. Safari-Alamuti, and Q. Wang, Dependence of Dye-Sensitized Solar Cell Impedance on Photoelectrode Thickness, J. Phys. Chem. C, 2012, 116(1), p 1556-156210.1021/jp209721c ↗
25. H.C. Weerasinghe, P.M. Sirimanne, G.P. Simon, and Y.B. Cheng, Fabrication of Efficient Solar Cells on Plastic Substrates Using Binder-Free Ball Milled Titania Slurries, J. Photochem. Photobiol. A, 2009, 206(1), p 64-7010.1016/j.jphotochem.2009.05.013 ↗
26. H.C. Weerasinghe, G.V. Franks, J.D. Plessis, G.P. Simona, and Y.B. Cheng, Anomalous Rheological Behavior In Chemically Modified TiO2 Colloidal Pastes Prepared for Flexible Dye-Sensitized Solar Cells, J. Mater. Chem. A, 2010, 20, p 9954-996110.1039/c0jm02063j ↗
27. G.J. Yang, C.J. Li, S.Q. Fan, Y.Y. Wang, and C.X. Li, Influence of Annealing on Photocatalytic Performance and Adhesion of Room Temperature Cold-Sprayed Nanostructured TiO2 Coating, J. Therm. Spray Technol., 2007, 16(5-6), p 873-88010.1007/s11666-007-9109-5 ↗
28. X.L. He, G.J. Yang, C.J. Li, and C.X. Li, Influence of Accelerating Gas Flow Rate on the Particle Cohesion in Room-Temperature Cold-Sprayed Scattering Layer for Plastic-Based Dye-Sensitized Solar Cells, Appl. Surf. Sci., 2014, 288, p 416-42210.1016/j.apsusc.2013.10.049 ↗
29. P. de Almeida, J. van Deelen, C. Catry, H. Sneyers, T. Pataki, R. Andriessen, C. Van Roost, and J.M. Kroon, Microstructure Characterization of Titanium Dioxide Nanodispersions and Thin Films for Dye-Sensitized Solar Cell Devices, Appl. Phys. a-Mater., 2004, 79(7), p 1819-182810.1007/s00339-003-2242-1 ↗
30. G.J. Yang, C.J. Li, S.Q. Fan, and J.C. Gao, Influence of Pore Structure on Ion Diffusion Property in Porous TiO2 Coating and Photovoltaic Performance of Dye-Sensitized Solar Cells, Surf. Coat. Technol., 2011, 205(10), p 3205-321010.1016/j.surfcoat.2010.11.042 ↗
31. B.H. Liao, S.H. Chan, C.C. Lee, C.C. Kuo, S.H. Chen, and D. Chiang, FTO Films Deposited in Transition and Oxide Modes by Magnetron Sputtering Using Tin Metal Target, Appl. Opt., 2014, 53(4), p 148-15310.1364/AO.53.00A148 ↗
32. Z.L. Wang, Characterization of Nanophase Materials, Wiley-VCH Verlag GmbH, Weinheim, 2000, p 37-80