journal article·2016-02

Influence of Particle Velocity of Copper on Emitter Contact by Cold-Spray Method

Byungjun Kang, Kyung Dong Lee, Jong-gun Lee, Jae-Wook Choi, Sam S. Yoon, Yoonmook Kang, Hae-seok Lee, Donghwan Kim

Publisher page

Abstract

In this study, we investigated cold-sprayed copper as a front contact for crystalline silicon solar cells. Copper powder was deposited on a monocrystalline silicon wafer with variation of the particle velocity during deposition. The particle velocity was varied by varying the heating temperature from 250 to 400 °C using a gas pressure of 0.45 MPa. The particle velocities were calculated using empirical equations, and were found to increase with an increase in the carrier gas temperature. Grid patterns were formed on a phosphorus-doped n-type emitter of a p-type silicon substrate. The electrode thickness increased with increasing particle velocity. The electrical properties of the grids were evaluated using the transfer length method. The specific contact resistance of the n-type emitter was in the range of 2.6-26.4 mΩ-cm2. Damage to the p-n junction was investigated via minority carrier lifetime measurement of the substrate. The copper-silicon interface was evaluated using transmission electron microscopy. The contact properties were affected by the interface conditions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High-Temperature Coating Behaviors · Advanced ceramic materials synthesis · Particle Dynamics in Fluid Flows

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. M. Balucani, K. Kholostov, P. Nenzi, R. Crescenzi, D. Ciarniello, D. Bernardi, L. Serenelli, M. Izzi, and M. Tucci, New Selective Processing Technique for Solar Cells, Energy Proc., 2013, 43, p 54-6510.1016/j.egypro.2013.11.088 ↗
2. M.A. Green, High Efficiency Silicon Solar Cells, Seventh E.C. Photovoltaic Solar Energy Conference, A. Goetzberger, W. Palz and G. Willeke Eds., Springer Netherlands, 1987, p 681-687.10.1007/978-94-009-3817-5_121 ↗
3. N. Adhoum, L. Monser, N. Bellakhal, and J.-E. Belgaied, Treatment of Electroplating Wastewater Containing Cu2+, Zn2+ and Cr(VI) by Electrocoagulation, J. Hazard Mater., 2004, 112(3), p 207-21310.1016/j.jhazmat.2004.04.018 ↗
4. R. Dykhuizen and M. Smith, Gas Dynamic Principles of Cold Spray, J. Thermal Spray Technol., 1998, 7(2), p 205-21210.1361/105996398770350945 ↗
5. D.-Y. Kim, J.-J. Park, J.-G. Lee, D. Kim, S.J. Tark, S. Ahn, J.H. Yun, J. Gwak, K.H. Yoon, and S. Chandra, Cold Spray Deposition of Copper Electrodes on Silicon and Glass Substrates, J. Thermal Spray Technol., 2013, 22(7), p 1092-110210.1007/s11666-013-9953-4 ↗
6. J.G. Lee, D.Y. Kim, B. Kang, D. Kim, H. Song, J. Kim, W. Jung, D. Lee, S.S. Al-Deyab, S.C. James, and S.S. Yoon, Nickel-Copper Hybrid Electrodes Self-Adhered onto a Silicon Wafer by Supersonic Cold-Spray, Acta Mater., 2015, 93, p 156-16310.1016/j.actamat.2015.04.012 ↗
7. J.G. Lee, D.Y. Kim, B. Kang, D. Kim, S.S. Al-Deyab, S.C. James, and S.S. Yoon, Thin Film Metallization by Supersonic Spraying of Copper and Nickel Nanoparticles on a Silicon Substrate, Comput. Mater. Sci., 2015, 108, p 114-12010.1016/j.commatsci.2015.06.016 ↗
8. H. Assadi, F. Gärtner, T. Stoltenhoff, and H. Kreye, Bonding Mechanism in Cold Gas Spraying, Acta Mater., 2003, 51(15), p 4379-439410.1016/S1359-6454(03)00274-X ↗
9. M. Grujicic, J. Saylor, D. Beasley, W. DeRosset, and D. Helfritch, Computational Analysis of the Interfacial Bonding Between Feed-Powder Particles and the Substrate in the Cold-Gas Dynamic-Spray Process, Appl. Surf. Sci., 2003, 219(3), p 211-22710.1016/S0169-4332(03)00643-3 ↗
10. H. Singh, T. Sidhu, and S. Kalsi, Cold Spray Technology: Future of Coating Deposition Processes, Fract. Struct. Integr., 2012, 22, p 69-8410.3221/IGF-ESIS.22.08 ↗
11. G. Schubert, Thick film Metallisation of Crystalline Silicon Solar cells, University of Konstanz, PhD Thesis, 2006
12. P. Papet, O. Nichiporuk, A. Kaminski, Y. Rozier, J. Kraiem, J.-F. Lelievre, A. Chaumartin, A. Fave, and M. Lemiti, Pyramidal Texturing of Silicon Solar Cell with TMAH Chemical Anisotropic Etching, Sol. Energy Mater. Sol. Cells, 2006, 90(15), p 2319-232810.1016/j.solmat.2006.03.005 ↗
13. H. Park, J.S. Lee, S. Kwon, S. Yoon, and D. Kim, Effect of Surface Morphology on Screen Printed Solar Cells, Curr. Appl. Phys., 2010, 10(1), p 113-11810.1016/j.cap.2009.05.005 ↗
14. S. Kim, S. Park, Y. Do Kim, H. Boo, H. Kim, S. Bae, H. Park, S.J. Tark, and D. Do Kim, Improvement Of Electrical Properties in Screen-Printed Crystalline Silicon Solar Cells by Contact Treatment of the Grid Edge, Met. Mater. Int., 2013, 19(6), p 1333-133810.1007/s12540-013-6032-9 ↗
15. D.K. Schroder, Semiconductor Material and Device Characterization, Wiley, Hoboken, 2006
16. A. Alkhimov, V. Kosarev, and S. Klinkov, The Features of Cold Spray Nozzle Design, J. Thermal Spray Technol., 2001, 10(2), p 375-38110.1361/105996301770349466 ↗
17. R.A. Sinton and A. Cuevas, Contactless Determination of Current-Voltage Characteristics and Minority-Carrier Lifetimes in Semiconductors from Quasi-Steady-State Photoconductance Data, Appl. Phys. Lett., 1996, 69(17), p 2510-251210.1063/1.117723 ↗
18. R.A. Sinton, A. Cuevas, and M. Stuckings, Quasi-Steady-State Photoconductance, a New Method for Solar Cell Material and Device Characterization, Photovoltaic Specialists Conference, 1996. Conference Record of the Twenty Fifth IEEE, 1996, p 457-460.10.1109/PVSC.1996.564042 ↗
19. M.M. Hilali, A. Rohatgi, and B. To, A Review and Understanding Of Screen-Printed Contacts and Selective-Emitter Formation, Proceedings of the 14th Workshop on Crystalline Silicon Solar Cells and Modules, Colorado, USA, 2004, p 80401-3393
20. F. Findik, Recent Developments in Explosive Welding, Mater. Des., 2011, 32(3), p 1081-109310.1016/j.matdes.2010.10.017 ↗
21. G. Schubert, J. Horzel, and S. Ohl, Investigations on the Mechanism Behind the Beneficial Effect of a Forming Gas Anneal on Solar Cells with Silver Thick Film Contacts, Proceedings of the 21st EUPVSEC, Dresden, Germany, 2006, p 1460-1466
22. S.-B. Cho, H.-S. Kim, and J.-Y. Huh, Mechanism Underlying the Beneficial Effect of Forming Gas Annealing on Screen-Printed Ag Contacts of Crystalline Si Solar Cells, Acta Mater., 2014, 70, p 1-710.1016/j.actamat.2014.02.023 ↗