journal article·2020-08

Modeling the hygrothermal creep behavior of wood plastic composite (WPC) lumber made from thermally modified wood

Murtada Abass A Alrubaie, Roberto A Lopez-Anido, Douglas J Gardner, Mehdi Tajvidi, Yousoo Han

Publisher page

Abstract

The viscoelastic behavior of an extruded wood plastic composite (WPC) made from thermally modified wood under hygrothermal treatment was studied and modeled. Multiple three-point bending creep/recovery tests were carried out using a dynamic mechanical thermal analyzer (DMTA) equipped with a submersible clamp. WPC specimens with a 15-mm span were subjected to two initial applied stresses; 9% and 14% of the flexural strength in 30 min of creep and 30 min of creep recovery under the combined effects of temperature (25°C, 35°C, and 45°C) and water immersion (saltwater (SW) and distilled water). A dry condition WPC control was used to compare the hygrothermal effects with respect to the control conditions. The WPC material in this article exhibited a linear viscoelastic behavior under the effect of temperature, whereas a nonlinear viscoelastic behavior was observed under immersion conditions. A power law model is considered a useful model to describe the creep behavior of WPC specimens with a 15-mm span in the control and the SW conditions and at 45°C. A power law model was used to describe 180-day creep deflection of WPC lumber beams with an 853-mm span subjected to 12 MPa of the flexural strength in four-point bending at 50% relative humidity and at 21°C. The power law model predicts that the WPC lumber will reach a flexural strain in outer fiber of 1% in approximately 150 years.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Natural Fiber Reinforced Composites · Wood Treatment and Properties · Innovations in Concrete and Construction Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Civil and Environmental Engineering, Advanced Structures and Composites Center, University of Maine, Orono, ME, USA

School of Forest Resources, Advanced Structures and Composites Center, University of Maine, Orono, ME, USA

References (38)

Show source-provided references
1. 10.1201/b1962610.1201/b19626 ↗
2. 10.1177/089270570403822010.1177/0892705704038220 ↗
3. 10.1201/b1629510.1201/b16295 ↗
4. 10.1177/089270571351328310.1177/0892705713513283 ↗
5. 10.1002/pen.2015710.1002/pen.20157 ↗
6. 10.1016/j.compositesa.2011.03.01110.1016/j.compositesa.2011.03.011 ↗
7. Pooler DJ · 2001
8. 10.1002/1097-4628(20010118)79:3<418::AID-APP40>3.0.CO;2-X10.1002/1097-4628(20010118)79:3<418::AID-APP40>3.0.CO;2-X ↗
9. Slaughter AE. Design and fatigue of a structural wood-plastic composite. Master Thesis, Washington State Uuniversity, USA, 2006.
10. Hamel SE. Modeling the time-dependent flexural response of wood-plastic composite materials. PHD Thesis, The University of Wisconsin, Madison, 2011.
11. 10.1061/(ASCE)MT.1943-5533.000013210.1061/(ASCE)MT.1943-5533.0000132 ↗
12. 10.1061/(ASCE)0899-1561(2003)15:6(524)10.1061/(ASCE)0899-1561(2003)15:6(524) ↗
13. Gardner D
14. Davis-Standard Woodtruder Advanced Structures and Composites Center. Orono: University of Maine, 2018, https://composites.umaine.edu/equipment-and-facilities/thermoplastic-composite-extrusion-lab/ (accessed August 2018).
15. ASTM International · 2011
16. ASTM International · 2017
17. ASTM International · 2010
18. ASTM International · 2013
19. MATLAB · 1994
20. 10.1016/S0266-3538(01)00170-110.1016/S0266-3538(01)00170-1 ↗
21. Alrubaie MAA · 2018
22. ASTM International · 2013
23. 10.1002/app.2164810.1002/app.21648 ↗
24. 10.1007/s11043-012-9194-910.1007/s11043-012-9194-9 ↗
25. 10.1016/j.msea.2004.04.02310.1016/j.msea.2004.04.023 ↗
26. 10.1007/s00289-014-1185-310.1007/s00289-014-1185-3 ↗
27. 10.1533/9781845694579.14210.1533/9781845694579.142 ↗
28. 10.1016/0032-3861(89)90176-610.1016/0032-3861(89)90176-6 ↗
29. 10.1016/j.jmrt.2017.06.01010.1016/j.jmrt.2017.06.010 ↗
30. 10.1007/s10856-011-4480-710.1007/s10856-011-4480-7 ↗
31. ASTM International · 2015
32. 10.1061/(ASCE)0899-1561(2006)18:5(626)10.1061/(ASCE)0899-1561(2006)18:5(626) ↗
33. King D, Hamel S. The tensile creep response of a wood-plastic composite in cold regions. In: ISCORD 2013: Planning for Sustainable Cold Regions 2013, pp. 771–778. https://ascelibrary.org/doi/pdf/10.1061/9780784412978.073.10.1061/9780784412978.073 ↗
34. ASTM International · 2010
35. TA Instruments. Dynamic mechanical analysis: basic theory and applications training, http://people.clarkson.edu/∼skrishna/DMA_Basic_Theory_Applications.pdf (accessed August 2018).
36. Timoshenko S, Goodier J. Theory of elasticity, vol. 412. New York: McGraw-Hill Book Company, 1951, p. 108.
37. Dura MJ · 2005
38. 10.1061/(ASCE)MT.1943-5533.000101810.1061/(ASCE)MT.1943-5533.0001018 ↗