journal article·1990-07

The Effect of Diaphragm Stiffness on the Quality of Diaphragm Formed Thermoplastic Composite Components

M.R. Monaghan, P.J. Mallon, C.M. O'Bradaigh, R.B. Pipes

Publisher page

Abstract

An experimental autoclave with a forming rate control system and sophisticated data acquisition facilities has been employed for polymeric diaphragm form ing of carbon fibre reinforced polyetheretherketone (PEEK). Central displacement mea surements were recorded using a high temperature linear variable differential transformer (LVDT), while forming into a hemispherical mould. Using this facility the pressure versus displacement relationships were established for Upilex-R, Upilex-S, and Kapton-H and superplastic aluminium (Supral) diaphragms. Both Upilex-S and Kapton-H were found to have similar stiffness values, about eight times greater than Upilex-R, while the Supral is about sixteen times stiffer than Upilex-R. Pressure versus displacement characteristics are reported for (0°) 8 , (0°) 16 , (0°/90°) 2 s , (0°/90°) 4 s and (0°/+45°/-45°/90°) s carbon fibre reinforced PEEK (APC-2) layups, which show that the laminate stiffness at forming tem perature is very low relative to the diaphragm stiffness of Upilex-S, Kapton or Supral. The effect of diaphragm stiffness on squeeze flow is clearly demonstrated as the stiffer di aphragms, Upilex-S and Supral, require higher pressures to complete the forming and consequently cause increased squeeze flow over that shown when using Upilex-R. How ever, it has also been demonstrated that the use of these stiffer diaphragms reduces the risk of laminate buckling. When forming with Upilex-R diaphragms, out of plane buckling was eliminated for a (0°/+45°/-45°/90°), APC-2 layup by reducing the forming rate to 6 mm/mm
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metal Forming Simulation Techniques · Mechanical Behavior of Composites · Nanofabrication and Lithography Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Mechanical Engineering University College Galway Galway, Ireland

Center for Composite Materials Department of Mechanical Engineering University of Delaware Newark, Delaware 19716, USA

References (8)

Show source-provided references
1. 1986
2. Cattanach, J.B. and F.N. Cogswell 1986 "Processing with Aromatic Polymer Composites", in Developments in Reinforced Plastics, 5th ed G Pritchard, ed Applied Science Publishers , pp 1-3810.1007/978-94-009-4179-3_1 ↗
3. 10.1016/0010-4361(88)90542-310.1016/0010-4361(88)90542-3 ↗
4. 10.1016/0956-7143(90)90269-310.1016/0956-7143(90)90269-3 ↗
5. Monaghan, M.R. · 1989
6. O'Bradaigh, C.M. · submitted to Polymer Composites · 1990
7. 10.1016/0010-4361(89)90682-410.1016/0010-4361(89)90682-4 ↗
8. 10.1177/08927057880010040110.1177/089270578800100401 ↗