journal article·1998-03-01

Novel simple and complementary metal-oxide-semiconductor-compatible membrane release design and process for thermal sensors

Stéphane Leclerc, Robert Antaki, John F. Currie

Publisher page

Abstract

A novel approach to the design and fabrication of released membrane thermal sensors has been developed. Its advantages are to facilitate processing over the suspended membranes after their liberation, and to allow the design of 1 μm to 100’s of μm deep cavities under the membrane. It consists in sacrificial etching of a layer up to an open silicon area hidden under the membrane, followed by front-side bulk micromachining of silicon under the membrane, to the depth desired. This approach is compatible to complementary metal-oxide-semiconductor commercial fabrication, and only needs one protective coarse lithography step and a few etching without alignment. This approach may be used in the fabrication of low temperature heated membrane gas sensors and thermal pressure sensors, as of thermal sensors in general, since thermal isolation may be optimized to high values.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Advanced MEMS and NEMS Technologies · Mechanical and Optical Resonators · Advanced Sensor and Energy Harvesting Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Laboratory for the Integration of Sensors and Actuators, Département de Génie Physique, École Polytechnique de Montréal, C.P. 6079, Succursale Centre-ville, Montréal, Québec H3C 3A7, Canada

References (3)

Show source-provided references
1. Sens. Actuators A · 1995 · 46,47 · 143
2. Sens. Actuators A · 1993 · 36 · 6510.1016/0924-4247(93)80142-4 ↗
3. J. Vac. Sci. Technol. A. · 1998 · 16 · 88110.1116/1.581028 ↗