journal article·2025

Influence of Entry Strategy on Cutting Tool Wear and Surface Roughness of Sae D2 Steel During Face Milling

Marcio Silva de Macedo, José Josimar de Oliveira, Francisco de Assis Toti, Luciana Sgarbi Rossino, Marcos Dorigão Manfrinato

Materials Research· Volume 28· Issue suppl 1
Publisher page

Abstract

When machining metallic materials, especially when face milling tool steel, annealing heat treatment is recommended for good machinability. The entry strategy of the cutting tool into the material plays a fundamental role in the tool. This study evaluated the direct and rolling entry strategies in the face milling of annealed SAE D2 steel, under dry conditions. The tests were performed at a 3-axis vertical machining center with programming developed in CAM. The rolling strategy resulted in a greater volume of material removed compared to the direct entry, for a stipulated wear of 0.3 mm. The average roughness (Ra) was similar between the strategies. The progressive flank and rake surface wear were evaluated by scanning electron microscopy (SEM) and energy dispersive X-ray (EDS), identifying adhesion as the predominant wear mechanism.
Source: crossref · Quality: baseline

Research context

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Faculdade de Tecnologia de Sorocaba, Brasil

References (15)

Show source-provided references
1. Groover MP · 2017 · 1
2. Groover MP · 2017 · 2
3. A relação entre a produtividade e a competitividade: estudo de caso aplicado a um processo de usinagem
4. Sustainable assessment of a milling manufacturing process based on economic tool life and energy modeling10.1007/s40430-023-04189-8 ↗
5. Investigation of cutting conditions on tool life in shoulder milling of Ti6Al4V using PVD coated micro-grain carbide insert based on design of experiments10.1016/j.heliyon.2020.e04217 ↗
6. Childs T · 2000
7. Machado AR · 2015
8. Prediction of tool wear rate and tool wear during dry orthogonal cutting of inconel 71810.3390/met13071225 ↗
9. Cutter path strategies in high-speed rough milling of hardened steel10.1016/j.matdes.2004.09.021 ↗
10. Analysis of machining strategies for peripheral milling10.1016/j.proeng.2013.08.193 ↗
11. Surface roughness evaluation in thin EN AW-6086-T6 alloy plates after face milling process with different strategies10.3390/ma14113036 ↗
12. The influence of the manufacturing strategy on the production of molds and dies10.1016/j.jmatprotec.2006.03.098 ↗
13. 2023
14. 2022
15. 2022