journal article·2025-11

Pseudo-bulk forming of thin-walled hollow components based on the self-consistency of internal pressure and shell deformation

Nan Xiang, Yan-lei Tian, Yi-quan Shu, Hai-rui Zhang, Tao Huang, Peng-yi Wang, Rui Zhang, Wan-ting Sun, Fei-yang Cheng

Materials & Design· Volume 259
Publisher page

Abstract

No abstract is available for this record. The assistant can identify its topic from the title, but cannot infer the study’s results.

Source: Not provided · Quality: missing

References (21)

Show source-provided references
1. High-efficiency forming processes for complex thin-walled titanium alloys components: state-of-the-art and perspectives
2. Fundamentals and processes of fluid pressure forming technology for complex thin-walled components10.1016/j.eng.2020.08.014 ↗
3. Investigation of tube hydroforming along with stamping of thin-walled tubes in square cross-section dies
4. Tailor layered tube hydroforming for fabricating tubular parts with dissimilar thickness10.1016/j.ijmachtools.2018.11.005 ↗
5. Anisotropic effects in the compression beading of aluminum thin-walled tubes with rubber10.1016/j.tws.2017.08.010 ↗
6. Investigation of failure during rubber pad forming of metallic bipolar plates10.1016/j.tws.2020.106671 ↗
7. Numerical simulation research on UDF flexible roll forming of multi-specification thin-walled circular tubes10.1007/s00170-023-11824-0 ↗
8. Forming thin-walled circular rings with corrugated meridians via quasi-bulk deformation of metal blank and viscous medium10.1016/j.jmatprotec.2016.05.003 ↗
9. Theory of single point incremental forming of tubes10.1016/j.jmatprotec.2020.116659 ↗
10. Multi-directional vs. mono-directional multi-step strategies for single point incremental forming of non-axisymmetric components10.1016/j.jmapro.2020.03.055 ↗
11. Deformation and strengthening analysis of Al-Mg-Si alloy sheet during hot gas forming with synchronous die quenching10.1016/j.jmapro.2020.07.005 ↗
12. Experimental and numerical investigation of the influence of pulsating pressure on hot tube gas forming using oscillating heating10.1007/s00170-018-2228-y ↗
13. Manufacturing of ultra-thin large titanium alloy tube using the novel hot gas pressure-bending process10.1016/j.jmatprotec.2024.118358 ↗
14. Development of a novel approach to middle-tube asymmetric spinning via generic rollers10.1016/j.jmatprotec.2024.118342 ↗
15. The lateral extrusion of copper pipes with a lost core of low temperature melting alloy10.1016/S0924-0136(01)00602-1 ↗
16. Lateral extrusion of A6063 aluminum alloy pipes with a lost core10.1016/S0924-0136(03)00146-8 ↗
17. Role of filling material on defects of thin-walled tube bending process
18. Beer · 1992 · 368
19. Optimized shape calibration process using flexible dies for annular and rectangular corners with small radius of thin-walled shell components10.1007/s00170-022-09759-z ↗
20. Insight into deformation allocation in the multi-pass roll forming of a double-walled brazed tube10.1007/s40436-023-00448-y ↗
21. Microstructures and mechanical properties of Zr–Al binary alloys processed by hot-rolling10.1016/j.msea.2019.138723 ↗