journal article·2020-03Open access

Electronic Structure and Optoelectronic Properties of Bismuth Oxyiodide Robust against Percent‐Level Iodine‐, Oxygen‐, and Bismuth‐Related Surface Defects

Tahmida N. Huq, Lana C. Lee, Lissa Eyre, Weiwei Li, Robert A. Jagt, Chaewon Kim, Sarah Fearn, Vincenzo Pecunia, Felix Deschler, Judith L. MacManus‐Driscoll, Robert L. Z. Hoye

Advanced Functional Materials· Volume 30· Issue 13

Abstract

Abstract In the search for nontoxic alternatives to lead‐halide perovskites, bismuth oxyiodide (BiOI) has emerged as a promising contender. BiOI is air‐stable for over three months, demonstrates promising early‐stage photovoltaic performance and, importantly, is predicted from calculations to tolerate vacancy and antisite defects. Here, whether BiOI tolerates point defects is experimentally investigated. BiOI thin films are annealed at a low temperature of 100 °C under vacuum (25 Pa absolute pressure). There is a relative reduction in the surface atomic fraction of iodine by over 40%, reduction in the surface bismuth fraction by over 5%, and an increase in the surface oxygen fraction by over 45%. Unexpectedly, the Bi 4f7/2 core level position, Fermi level position, and valence band density of states of BiOI are not significantly changed. Further, the charge‐carrier lifetime, photoluminescence intensity, and the performance of the vacuum‐annealed BiOI films in solar cells remain unchanged. The results show BiOI to be electronically and optoelectronically robust to percent‐level changes in surface composition. However, from photoinduced current transient spectroscopy measurements, it is found that the as‐grown BiOI films have deep traps located ≈0.3 and 0.6 eV from the band edge. These traps limit the charge‐carrier lifetimes of BiOI, and future improvements in the performance of BiOI photovoltaics will need to focus on identifying their origin. Nevertheless, these deep traps are three to four orders of magnitude less concentrated than the surface point defects induced through vacuum annealing. The charge‐carrier lifetimes of the BiOI films are also orders of magnitude longer than if these surface defects were recombination active. This work therefore shows BiOI to be robust against processing conditions that lead to percent‐level iodine‐, bismuth‐, and oxygen‐related surface defects. This will simplify and reduce the cost of fabricating BiOI‐based electronic devices, and stands in contrast to the defect‐sensitivity of traditional covalent semiconductors.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Perovskite Materials and Applications · Chalcogenide Semiconductor Thin Films · Advanced Photocatalysis Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Materials Science and Metallurgy University of Cambridge 27 Charles Babbage Road Cambridge CB3 0FS UK

Department of Physics University of Cambridge JJ Thomson Ave Cambridge CB3 0HE UK

Walter Schottky Institute Department of Physics Technical University of Munich Am Coulombwall 4 85748 Garching Germany

Institute of Functional Nano & Soft Materials (FUNSOM) Jiangsu Key Laboratory for Carbon‐Based Functional Materials & Devices Soochow University 199 Ren'ai Road Suzhou 215123 Jiangsu P. R. China

Department of Materials Imperial College London Exhibition Road London SW7 2AZ UK

Funding

Engineering and Physical Sciences Research Council · Isaac Newton Trust · Deutsche Forschungsgemeinschaft · National Natural Science Foundation of China · Natural Science Foundation of Jiangsu Province · Priority Academic Program Development of Jiangsu Higher Education Institutions · Higher Education Discipline Innovation Project · Royal Academy of Engineering

References (61)

Show source-provided references
1. NREL “Best Research‐Cell Efficiency Chart ” can be found underhttps://www.nrel.gov/pv/assets/pdfs/best‐research‐cell‐efficiencies.20190703.pdf(accessed: November2019).
2. 10.1039/C9EE00751B10.1039/C9EE00751B ↗
3. 10.1038/nphoton.2014.13410.1038/nphoton.2014.134 ↗
4. 10.1038/s41578-019-0097-010.1038/s41578-019-0097-0 ↗
5. 10.1021/acsenergylett.9b0057110.1021/acsenergylett.9b00571 ↗
6. 10.1038/nphys335710.1038/nphys3357 ↗
7. 10.1063/1.505216410.1063/1.5052164 ↗
8. 10.1038/srep3933310.1038/srep39333 ↗
9. 10.1002/anie.20140974010.1002/anie.201409740 ↗
10. 10.1002/ange.20140974010.1002/ange.201409740 ↗
11. 10.1021/acs.chemmater.6b0549610.1021/acs.chemmater.6b05496 ↗
12. 10.1021/acsnano.7b0273410.1021/acsnano.7b02734 ↗
13. 10.1039/C6EE03201J10.1039/C6EE03201J ↗
14. 10.1039/C8EE00124C10.1039/C8EE00124C ↗
15. 10.1016/j.joule.2019.05.01410.1016/j.joule.2019.05.014 ↗
16. 10.1126/science.aan230110.1126/science.aan2301 ↗
17. 10.1039/C7EE00303J10.1039/C7EE00303J ↗
18. 10.1063/1.502948410.1063/1.5029484 ↗
19. 10.1039/C5TC03109E10.1039/C5TC03109E ↗
20. 10.1021/acsenergylett.7b0023910.1021/acsenergylett.7b00239 ↗
21. Jin H. · Mater. Horiz. · 2020
22. 10.1103/PhysRevApplied.2.03400710.1103/PhysRevApplied.2.034007 ↗
23. 10.1021/acsami.8b1550310.1021/acsami.8b15503 ↗
24. 10.1021/acsami.9b0496310.1021/acsami.9b04963 ↗
25. 10.1021/acsenergylett.6b0019610.1021/acsenergylett.6b00196 ↗
26. 10.1038/srep1807110.1038/srep18071 ↗
27. 10.1021/acsami.7b1108310.1021/acsami.7b11083 ↗
28. Zhang S. B. · Phys. Rev. Lett. · 1997 · 78 · 40594
29. 10.1080/1364281890820592610.1080/13642818908205926 ↗
30. 10.1038/nmat457210.1038/nmat4572 ↗
31. 10.1038/srep1872110.1038/srep18721 ↗
32. U.S. Geological Survey · Mineral Commodity Summaries · 2019 · 2019
33. 10.1557/mrc.2015.2610.1557/mrc.2015.26 ↗
34. 10.1021/acs.chemmater.8b0150510.1021/acs.chemmater.8b01505 ↗
35. 10.1039/C6CC06475B10.1039/C6CC06475B ↗
36. 10.1021/acs.chemmater.8b0067610.1021/acs.chemmater.8b00676 ↗
37. 10.1002/chem.20150505510.1002/chem.201505055 ↗
38. 10.1038/nchem.60910.1038/nchem.609 ↗
39. 10.1002/adma.20170217610.1002/adma.201702176 ↗
40. 10.1063/1.481348610.1063/1.4813486 ↗
41. 10.1021/acsenergylett.8b0118210.1021/acsenergylett.8b01182 ↗
42. 10.1021/acsaem.9b0083810.1021/acsaem.9b00838 ↗
43. 10.1063/1.494015710.1063/1.4940157 ↗
44. 10.1002/zaac.1997623121910.1002/zaac.19976231219 ↗
45. 10.1002/sca.495019010110.1002/sca.4950190101 ↗
46. 10.1107/S056773947600155110.1107/S0567739476001551 ↗
47. Klimakov A. M. · Russ. J. Inorg. Chem. · 1974 · 19 · 1394
48. 10.1021/nn303106310.1021/nn3031063 ↗
49. 10.1039/C6SC00389C10.1039/C6SC00389C ↗
50. 10.1557/jmr.2018.20110.1557/jmr.2018.201 ↗
51. 10.1103/PhysRevB.73.23510410.1103/PhysRevB.73.235104 ↗
52. 10.1016/j.nima.2006.01.11510.1016/j.nima.2006.01.115 ↗
53. 10.1088/0022-3727/46/30/30510310.1088/0022-3727/46/30/305103 ↗
54. 10.1063/1.34136110.1063/1.341361 ↗
55. 10.1143/JJAP.22.62910.1143/JJAP.22.629 ↗
56. If the trap density capture cross section and thermal velocity are 1016cm−3 10−11cm2 and 107cm s−1 respectively then we would have a Shockley–Read–Hall lifetime of 1 ps. This is much smaller than the lifetime we measured in Figure 2d and it may be that we are overestimating the capture cross section in the PICTS measurements by assuming it to not change with temperature. Nevertheless if we assume the capture cross section and thermal velocity to remain the same increasing the trap density by four orders of magnitude would decrease the lifetime by four orders of magnitude well below the lifetimes present in BiOI.
57. 10.1039/C8NJ05538F10.1039/C8NJ05538F ↗
58. 10.1002/adfm.20190012910.1002/adfm.201900129 ↗
59. 10.1002/admi.20180046410.1002/admi.201800464 ↗
60. 10.1088/0022-3727/19/1/01210.1088/0022-3727/19/1/012 ↗
61. 10.1021/am400326t10.1021/am400326t ↗