journal article·2021-01

Experimental Study on Burning Characteristics of the Large-Scale Transformer Oil Pool Fire with Different Extinguishing Methods

Chuanping Wu, Tiannian Zhou, Baohui Chen, Yu Liu, Ping Liang

Fire Technology· Volume 57· Issue 1
Publisher page

Abstract

In this study, a 100 m2 steel tank was used to simulate transformer oil fires, with an aim of investigating the burning characteristics of a large-scale pool fire. To recover a real thermal state of transformer oil in operation, a heating system was employed to raise the initial fuel temperature. In total, three fire-extinguishing tests were performed using two delivery methods, i.e., a hand-held fire water branch (FWB) and fire water monitor (FWM) to understand their performance in fighting large-scale pool fires. The extinguishing activities using the FWB method were conducted by four trained firefighters, and the FWM was operated by a trained firefighter. Also, a sequence of bench-scale tests was conducted to investigate the impact of initial fuel temperature on the mass burning rate of transformer oil pool fires. This part is a supplement to the large-scale tests. The results demonstrated that the temperatures adjacent to the tank border were reduced as the vertical height increased. The growth rate of the flame height was enhanced in the development stage when the initial fuel temperature was pre-heated to a higher value. Meanwhile, it was found that the burning rate of transformer oil pool fire occurred a slight increase with the initial fuel temperature was grown according to the bench-scale data, while the impact of initial temperature was limited within the tested temperature range. In addition, it was shown that the FWB and FWM were both effective for fighting a large-scale transformer oil pool fire. However, their efficiency was influenced significantly by the concentration of the extinguishing agents and the application density of delivery. In contrast, the FWM might be a good choice when considering the safety of firefighters, because its delivery range is greater and extinguishing time is shorter as compared to the FWB. Here, it shall be noted that the FWM has also its flipsides. Sometimes, the application of a single FWM is not well to extinguish the corner fire or other fire types, in such cases, the FWM strategy should be to use two or more fire trucks in order to cover the whole accident pool.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fire dynamics and safety research · Fire Detection and Safety Systems · Combustion and Detonation Processes

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (25)

Show source-provided references
1. Duarte D (2004) A performace overview about fire risk management in the Brazilian hydroelectric generating plants and transmission network. J Loss Prev Process Ind 17(1):65–7510.1016/j.jlp.2003.09.007 ↗
2. Muñoz M, Arnaldos J, Casal J, Planas E (2004) Analysis of the geometric and radiative characteristics of hydrocarbon pool fires. Combust Flame 139(3):263–27710.1016/j.combustflame.2004.09.001 ↗
3. Munoz M, Planas E, Ferrero F, Casal J (2007) Predicting the emissive power of hydrocarbon pool fires. J Hazard Mater 144(3):725–72910.1016/j.jhazmat.2007.01.121 ↗
4. Leite RM, Centeno FR (2018) Effect of tank diameter on thermal behavior of gasoline and diesel storage tanks fires. J Hazard Mater 342:544–55210.1016/j.jhazmat.2017.08.052 ↗
5. GB2536-90 (1991) Transformer oils, Chinese standard. State Administration for Market Regulation of China
6. Heskestad G, Dobson HP (1997) Pool fires of transformer oil sinking into a rock bed. Fire Saf J 28:33–4610.1016/S0379-7112(96)00063-X ↗
7. Hayasaka H (1996) Unsteady burning rates of small pool fires. Bull Jpn Assoc Fire Sci Eng 45(1.2):19–25
8. Chen B, Lu S, Li C, Kang Q, Lecoustre V (2011) Initial fuel temperature effects on burning rate of pool fire. J Hazard Mater 188:369–37410.1016/j.jhazmat.2011.01.122 ↗
9. Zhang Q, Wang L, Bi Y, Xu D, Zhi H, Qiu P (2015) Experimental investigation of foam spread and extinguishment of the large-scale methanol pool fire. J Hazard Mater 287:87–9210.1016/j.jhazmat.2015.01.017 ↗
10. Zhou T, Chen Q, Wang X, Zhao J, Ding C, Wang J (2018) The burning rate of n-heptane pool fires with constraint effect beneath an arced ceiling. Fuel 233:825–83310.1016/j.fuel.2018.07.001 ↗
11. Chen Q, Liu X, Wang X, Zhao J, Zhou T, Ding C, Wang J (2018) Experimental study of liquid fuel boilover behavior in normal and low pressures. Fire Mater 42(7):843–85810.1002/fam.2640 ↗
12. Arai M, Saito K, Altenkirch RA (1990) A study of boilover in liquid pool fires supported on water part I: effects of a water sublayer on pool fires. Combust Sci Technol 71(1–3):25–4010.1080/00102209008951622 ↗
13. Chatris JM, Planas E, Arnaldos J, Casal J (2001) Effects of thin-layer boilover on hydrocarbon pool fires. Combust Sci Technol 171(1):141–16110.1080/00102200108907862 ↗
14. Kong D, Liu P, Zhang J, Fan M, Tao C (2017) Small scale experiment study on the characteristics of boilover. J Loss Prev Process Ind 48:101–11010.1016/j.jlp.2017.04.008 ↗
15. Babrauskas V (2016) Heat release rates. SFPE handbook of fire protection engineering, vol 26, pp 799–90410.1007/978-1-4939-2565-0_26 ↗
16. Blinov V, Khudyakov G (1961) Diffusion burning of liquids. Army Engineer Research and Development Labs Fort Belvoir VA, Armed Services Technical Information Agency, Arlington Hall Station, Arlington 12, Virginia
17. Hu L (2017) A review of physics and correlations of pool fire behaviour in wind and future challenges. Fire Saf J 91:41–5510.1016/j.firesaf.2017.05.008 ↗
18. Li JS, Chow W (2003) Numerical studies on performance evaluation of tunnel ventilation safety systems. Tunn Undergr Space Technol 18(5):435–45210.1016/S0886-7798(03)00023-3 ↗
19. Lu JZ, Chen B, Wu CP, Liu X, Zhou TJ Tan YJ (2016) A multi-additive suppressant agent-based low-flow and long-distance firefighting approach for suppressing wildfires near electrical transmission lines. J Fire Sci 34(5):1–1810.1177/0734904116659499 ↗
20. Liu J, He Y, Zhou Z, Yuen R, Wang J (2016) Investigation of enclosure effect of pressure chamber on the burning behavior of a hydrocarbon fuel. Appl Therm Eng 101:202–21610.1016/j.applthermaleng.2016.02.123 ↗
21. Lei J, Liu N, Zhang L, Chen H, Shu L, Chen P, Deng Z, Zhu J, Satoh K, de Ris JL (2011) Experimental research on combustion dynamics of medium-scale fire whirl. Proc Combust Inst 33(2):2407–241510.1016/j.proci.2010.06.009 ↗
22. Soma S, Saito K (1991) Reconstruction of fire whirls using scale models. Combust Flame 86(3):269–28410.1016/0010-2180(91)90107-M ↗
23. Sjöström J, Amon F, Appel G, Persson H (2015) Thermal exposure from large scale ethanol fuel pool fires. Fire Saf J 78:229–23710.1016/j.firesaf.2015.09.003 ↗
24. Heskestad G (2016) Fire plumes, flame height, and air entrainment. SFPE handbook of fire protection engineering, pp 396–42810.1007/978-1-4939-2565-0_13 ↗
25. Zukoski EE, Cetegen B, Kubota T (1984) Visible structure of buoyant diffusion flames. In: 20th Symposium international on combustion, vol 20, no. 1 The Combustion Institute, Pennsylvania, pp 361–36610.1016/S0082-0784(85)80522-1 ↗