Printed multilayer conformal x-band antenna array
Source abstract
Abstract
Abstract This manuscript presents the design and fabrication process of an additively manufactured multilayer antenna. The antenna reported herein is an x-band 32 element patch array and is fabricated on a multi-curved surface that is typical of what one might find on an airborne platform. In this design all of the substrate materials and conductive elements (except the ground plane) are fully printed including the via fills. Peak gain for the antenna is greater than 15 dBi at 10.4 GHz and showed close adherence to modeling results.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Antenna Design and Analysis · Advanced Antenna and Metasurface Technologies · Energy Harvesting in Wireless Networks
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
KBRwyle, 2601 Mission Point Blvd, Suite 300, Beavercreek, OH 45431,
Defense Engineering Corporation, 4027 Colonel Glenn Hwy, Beavercreek, OH 45431,
Air Force Research Laboratory, Sensors Directorate, Wright-Patterson AFB, OH 45433,
References (14)
Show source-provided references
1. Integrating stereolithography and direct print technologies for 3D structural electronics fabrication10.1108/13552541211212113 ↗
2. 3D printing multifunctionality: structures with electronics10.1007/s00170-014-5717-7 ↗
3. The status, challenges, and future of additive manufacturing in engineering10.1016/j.cad.2015.04.001 ↗
4. Novel low profile wideband monopole antenna for avionics applications10.1109/TAP.2013.2277615 ↗
5. A broadband blade dipole antenna for UAV applications10.1109/APS.2016.7696595 ↗
6. Fabrication of an X-band conformal antenna array on an additively manufactured substrate10.1109/APS.2015.7304691 ↗
7. 3D printed metalized-polymer UWB high-gain Vivaldi antennas
8. Manufacturing ultra-high-frequency radio frequency identification tag antennas by multilayer printings10.1243/09544062JMES1610 ↗
9. Optimization and fabrication by 3D printing of a volcano smoke antenna for UWB applications
10. Effects of extreme surface roughness on 3D printed horn antenna10.1049/el.2013.1528 ↗
11. Demonstration of RF and microwave passive circuits through 3D printing and selective metalization10.1109/TCPMT.2017.2651645 ↗
12. Measurement of the intrinsic properties of materials by time-domain techniques10.1109/TIM.1970.4313932 ↗
13. Automatic measurement of complex dielectric constant and permeability at microwave frequencies10.1109/PROC.1974.9382 ↗
14. Incorporation of active RF circuit elements into additively manufactured substrates10.1109/APS.2015.7304692 ↗