journal article·2017-06-01Open access

Plasma-assisted ALD to functionalize PET: towards new generation flexible gadgets

M Fang, H Zhang, L Sang, H Cao, L Yang, K Ostrikov, I Levchenko, Q Chen

Abstract

Abstract We report a novel, efficient, plasma-enabled technique to significantly enhance the protective barrier properties of alumina films deposited on thin polyethylene terephthalate (PET), which is a potential candidate for use in next-generation flexible gadgets and various portable equipment. Capacitively coupled oxygen plasma pretreatment was proposed and successfully tested to drastically reduce the water vapour transmission rate and water contact angle. The influence of the deposition temperature and in-chamber cooling of the prepared alumina layers on the protective characteristics of coated PET was also studied. We have found that higher deposition temperature improves the water vapour barrier performance of PET coated with atomic layer deposition alumina films. To keep the temperatures at a minimum, oxygen plasma could be efficiently employed to treat PET and thus ensure a strong interfacial interaction between the alumina and PET surfaces. With the assistance of the oxygen plasma treatment technique, alumina coating reduced the water vapour transmission rate of PET to less than 1 mg × m −2 × day −1 without a long post-process cooling. This technique may be suitable for application of virtually any ceramic films at low temperature onto various polymer substrates, which is urgently required for present-day flexible gadgets and other portable equipment including those working in aggressive environments.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Advanced Sensor and Energy Harvesting Materials · Semiconductor materials and devices · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Laboratory of Plasma Physics and Materials, Beijing Institute of Graphic Communication, 102600 Beijing,

Queensland University of Technology

CSIRO-QUT Joint Sustainable Processed and Devices Laboratory, PO Box 218, Lindfield NSW 2070,

Plasma Sources and Applications Centre, National Institute of Education, Nanyang Technological University, 1 Nanyang Walks, 637616,

References (37)

Show source-provided references
1. Highly efficient, mechanically flexible, semi-transparent organic solar cells doctor bladed from non-halogenated solvents10.1002/admt.201600184 ↗
2. Epidermal electronics10.1126/science.1206157 ↗
3. Paper for flexible energy and electronic devices10.1557/mrs.2013.59 ↗
4. The effect of mechanical strain on contract resistance in flexible printed organic thin-film transistors10.1088/2058-8585/1/3/035005 ↗
5. Inkjet printed metal insulator semiconductor diodes for organic and flexible electronic application10.1088/2058-8585/2/1/015003 ↗
6. Flexible electronics10.1126/science.1171230 ↗
7. Fully printed memristors for a self-sustainable recorder of mechanical energy10.1088/2058-8585/1/2/025002 ↗
8. Crystalline Si nanoparticles below crystallization threshold: Effects of collisional heating in non-thermal atmospheric-pressure microplasmas10.1063/1.4872254 ↗
9. Scalable graphene production: perspectives and challenges of plasma applications10.1039/C5NR06537B ↗
10. Low-temperature plasmas in carbon nanostructure synthesis10.1116/1.4821635 ↗
11. The development of fluorous photolithographic materials and their applications to achieve flexible organic electronic devices10.1088/2058-8585/1/2/023001 ↗
12. Gas permeation and lifetime tests on polymer-based barrier coatings10.1117/12.416878 ↗
13. Permeation measurements and modeling of highly defective Al2O3 thin films grown by atomic layer deposition on polymers10.1063/1.3519476 ↗
14. Gas diffusion barriers on polymers using multilayers fabricated by Al2O3 and rapid SiO2 atomic layer deposition10.1021/jp076866+ ↗
15. Oxygen barrier properties of Al2O3 and TiO2 coated LDPE films10.1080/03602559.2014.977426 ↗
16. Antibacterial and barrier properties of oriented polymer films with ZnO thin films applied with atomic layer deposition at low temperature10.1016/j.tsf.2014.03.068 ↗
17. Ultra thin film encapsulation of OLED on plastic substrate10.4218/etrij.05.0905.0006 ↗
18. Gas diffusion barriers on polymers using Al2O3 atomic layer deposition10.1063/1.2168489 ↗
19. Gas diffusion barrier characteristics of Al2O3/alucone films formed using trimethylaluminum, water and ethylene glycol for organic light emitting diode encapsulation10.1016/j.tsf.2013.05.017 ↗
20. Investigation of a steady-state cylindrical magnetron discharge for plasma immersion treatment10.1063/1.1590054 ↗
21. Self-organized carbon connections between catalyst particles on a silicon surface exposed to atmospheric-pressure Ar + CH4 microplasmas10.1016/j.carbon.2009.04.031 ↗
22. Effect of corona pre-treatment on the performance of gas barrier layers applied by atomic layer deposition onto polymer-coated paperboard10.1016/j.apsusc.2010.07.051 ↗
23. Plasma-assisted ALD of an Al2O3 permeation barrier layer on plastic10.1088/1009-0630/14/2/09 ↗
24. Surface and sub-surface reactions during low temperature aluminium oxide atomic layer deposition on fiber-forming polymers10.1039/c0jm00355g ↗
25. Quantitative in situ infrared analysis of reactions between trimethylaluminum and polymers during Al2O3 atomic layer deposition10.1039/c2jm32343e ↗
26. Investigation of sub-nm ALD aluminum oxide films by plasma assisted etch-through10.1016/j.tsf.2007.07.121 ↗
27. Plasma pretreatment of polymer films as a key issue for high barrier food packagings10.1016/S0257-8972(99)00137-1 ↗
28. Nucleation and growth during Al2O3 atomic layer deposition on polymers10.1021/cm050704d ↗
29. Surface chemistry of atomic layer deposition: a case study for the trimethylaluminum/water process10.1063/1.1940727 ↗
30. Measurements of pulsed-power modulated argon plasmas in an inductively coupled plasma source10.1116/1.580095 ↗
31. Low temperature growth of amorphous and polycrystalline silicon films from a modified inductively coupled plasma10.1143/JJAP.36.3714 ↗
32. Annealing of Al2O3 thin films prepared by atomic layer deposition10.1088/0022-3727/40/12/025 ↗
33. Realization of highly-dense Al2O3 gas barrier for top-emitting organic light-emitting diodes by atomic layer deposition10.1039/C5RA21424F ↗
34. Atomic layer deposition thin barrier films for packing
35. Tackling chemical etching and its mechanisms of polyphenolic composites in various reactive low temperature plasmas10.1039/C6RA15923K ↗
36. Effects of bifunctional chain extender on the crystallinity and thermal stability of PET10.4236/msce.2013.16002 ↗
37. Thermal expansion and second-order transition effects in high polymers: III. Time effects10.1063/1.1707730 ↗