An experimental study on the impact resistance of a new three-wave beam steel guardrail
Source abstract
Abstract
It is crucial to examine the impact resistance of W-beam guardrails on both sides of the highway in order to limit the severity of impact incidents and safeguard passengers. Given its importance, this article investigates the impact resistance of the new three-wave steel guardrail. To be specific, the study uses ANSYS to establish the vehicle impact barrier model in which the guardrail is embedded in concrete and soil column. The new accurate model of the three-wave beam guardrail collision stimulates the deformation degree of the guardrail under the impact of vehicles with different masses and speeds. According to the simulation analysis’ findings, the guardrail with the post embedded in the concrete had a maximum displacement of 568.48 mm, which was less than the specification’s maximum dynamic deformation of 750 mm and met the requirements for Grade 8 protection. In contrast, the guardrail with the post embedded in the soil had a maximum displacement of 679.466 mm, which was less than the specification’s maximum dynamic deformation of 750 mm.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Transportation Safety and Impact Analysis · Structural Response to Dynamic Loads · High-Velocity Impact and Material Behavior
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (24)
Show source-provided references
1. Ballistic behaviour of spray formed AA7055 aluminum alloy against tungsten core projectile impact10.1016/j.vacuum.2018.10.073 ↗
2. A new comprehensive model of damage for flexural subassemblies prone to fatigue10.1016/j.compstruc.2021.106639 ↗
3. Fabrication of cellulosic paper containing zeolitic imidazolate framework and its application in removal of anionic dye from aqueous solution10.15376/biores.16.2.2644-2654 ↗
4. Behavior of floating stone columns reinforced with geogrid encasement in model tests10.3389/fmats.2022.980851 ↗
5. Experimental study of predamaged columns strengthened by HPFL and BSP under combined load cases10.1080/15732479.2020.1801768 ↗
6. Experimental investigation on rehabilitation of corroded RC columns with BSP and HPFL under combined loadings10.1061/(asce)st.1943-541x.0002725 ↗
7. Present situation and analysis of occupant risk assessment technology of highway guardrail abroad
8. Microstructure characterization of 7055-T6, 6061-T6511 and 7A52-T6 Al alloys subjected to ballistic impact against heavy tungsten alloy projectile10.1016/j.acme.2019.10.001 ↗
9. Microstructure characteristic of spray formed 7055 Al alloy subjected to ballistic impact by two different steel core projectiles impact10.1016/j.jmrt.2019.10.012 ↗
10. Dual-channel membrane capacitive deionization based on asymmetric ion adsorption for continuous water desalination10.1016/j.elecom.2021.106974 ↗
11. Structural damage detection method based on the complete ensemble empirical mode decomposition with adaptive noise: A model steel truss bridge case study10.1177/14759217211013535 ↗
12. Nicol · 2009
13. New insights into the rapid formation of initial membrane fouling after in-situ cleaning in a membrane bioreactor10.1016/j.procbio.2019.01.004 ↗
14. Effects of NaClO shock on MBR performance under continuous operating conditions10.1039/d0ew00760a ↗
15. Experimental study on circular steel tube-confined reinforced UHPC columns under axial loading10.1016/j.engstruct.2020.111599 ↗
16. Researching status and developing trends of guardrail on highways
17. Influence of freeze-thaw cycles on microstructure and hydraulic conductivity of saline intact loess10.1016/j.coldregions.2020.103183 ↗
18. The alleviation of perceptual blindness during driving in urban areas guided by saccades recommendation10.1109/TITS.2022.3149994 ↗
19. The improvement of road driving safety guided by visual inattentional blindness10.1109/tits.2020.3044927 ↗
20. Fate of NaClO and membrane foulants during in-situ cleaning of membrane bioreactors: Combined effect on thermodynamic properties of sludge10.1016/j.bej.2019.04.016 ↗
21. Degradation of an organic dye by bisulfite catalytically activated with iron manganese oxides: The role of superoxide radicals10.1021/acsomega.0c01257 ↗
22. Analysis of lower cambrian shale gas composition, source and accumulation pattern in different tectonic backgrounds: A case study of weiyuan block in the upper yangtze region and xiuwu basin in the lower yangtze region10.1016/j.fuel.2019.115978 ↗
23. Zheng · 2013
24. Damage evolution modeling for steel structures subjected to combined high cycle fatigue and high-intensity dynamic loadings10.1142/s0219455422400120 ↗