Displacement Characteristics of Shallow-Buried Large-Section Loess Tunnel with Different Types of Pre-Supports: A Case Study of New Badaling Tunnel
Source abstract
Abstract
Three-bench seven-step excavation method (TSEM) has been widely used in large-section loess tunnels for high-speed railway in China. As the most commonly applied pre-supports, pipe roofs and leading ductules are broadly used in the ground reinforcement of loess tunnels. Their application is to ensure face stability and prevent tunnel collapse during construction. This study focused on the impacts of the TSEM on the ground surface settlement (GSS), as well as the tunnel displacement characteristics for the high-speed railway tunnels with large cross-sections in loess ground. Furthermore, the reinforcement effects of the two kinds of pre-supports were compared in this study. In-situ tests for a total of 12 sections were conducted to reveal the GSSs and displacement characteristics for the shallow-buried large-section loess tunnels. The monitoring results showed that the excavation process plays a significant role on the GSSs and tunnel displacements. A maximum value was observed for the tunnel displacement rate at the excavation of the upper and middle benches, where the face instability or collapse were prone to occur. The GSS trough curves were deviated to the early excavation side, with no conformation to the Gauss distribution. After a series of comparisons, we concluded that the pre-reinforcement effect of the pipe roof is better than that of the leading ductule for the loess tunnels.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Geotechnical Engineering and Analysis · Geotechnical Engineering and Soil Stabilization · Geotechnical Engineering and Underground Structures
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Key Laboratory for Urban Underground Engineering of Ministry of Education, Beijing Jiaotong University, Beijing 100044, China
Funding
National Natural Science Foundation of China · National Key Research and Development Programs of China
References (23)
Show source-provided references
1. ADECO full-face tunnel excavation of two 260 m (2) tubes in clays with sub-horizontal jet-grouting under minimal urban cover10.1016/j.tust.2010.09.006 ↗
2. The excavation of a circular tunnel in a bedded argillaceous rock (Opalinus Clay): Short-term rock mass response and FDEM numerical analysis10.1016/j.tust.2014.09.014 ↗
3. Displacement characteristics of high-speed railway tunnel construction in loess ground by using multi-step excavation method10.1016/j.tust.2015.10.009 ↗
4. Statistical analysis of influence of cover depth on loess tunnel deformation in NW China
5. Energy-based prediction of volume loss ratio and plastic zone dimension of shallow tunneling10.1016/j.compgeo.2019.103343 ↗
6. A numerical investigation of sinkhole subsidence development over shallow excavations in tectonised weak rocks: The dolaei tunnel’s excavation case10.1007/s10706-017-0202-3 ↗
7. Efficiency assessment of l-profiles and pipe fore-poling pre- support systems in difficult geological conditions: A case study10.12989/sem.2016.57.6.1125 ↗
8. The role of umbrella arch and face bolt as deformation preventing support system in preventing building damages10.1016/j.tust.2010.03.004 ↗
9. 3D numerical modeling of road tunnel stability-The Laliki project/Modelowanie 3D DLA oceny stateczności tunelu drogowego w Lalikach
10. Model testing for pipe-reinforced tunnel heading in a granular soil10.1016/j.tust.2007.04.012 ↗
11. Control of surface settlements with umbrella arch method in second stage excavations of istanbul metro10.1016/j.tust.2007.12.005 ↗
12. Numerical modeling of surface settlements at the transition zone excavated by new austrian tunneling method and umbrella arch method in weak rock10.1007/s12517-012-0530-9 ↗
13. Load transferring mechanism of pipe umbrella support in shallow-buried tunnels10.1016/j.tust.2014.05.018 ↗
14. Homogenization framework for three-dimensional elastoplastic finite element analysis of a grouted pipe-roofing reinforcement method for tunnelling10.1002/nag.402 ↗
15. Hu, X.D., Deng, S.J., and Ren, H. (2016). In situ test study on freezing scheme of freeze-sealing pipe roof applied to the gongbei tunnel in the hong kong-zhuhai-macau bridge. Appl. Sci., 7.10.3390/app7010027 ↗
16. Evaluation of surface settlements in the Istanbul metro in terms of analytical, numerical and direct measurements10.1007/s10064-012-0428-5 ↗
17. Effects of pipe roof support and grouting pre-reinforcement on the track settlement10.1155/2018/6041305 ↗
18. Xie, X.Y., Zhao, M.R., and Shahrour, I. (2019). Experimental study of the behavior of rectangular excavations supported by a pipe roof. Appl. Sci., 9.10.3390/app9102082 ↗
19. Development of an Optimum Forepole Spacing (OFS) determination method for tunnelling in silty clay with a case study10.1016/j.tust.2018.01.012 ↗
20. Numerical modeling of umbrella arch technique to reduce tunnelling induced ground movements10.1007/s12665-019-8302-4 ↗
21. Centrifuge modelling of tunnelling with forepoling
22. Protection of buildings against damages as a result of adjacent large-span tunneling in shallowly buried soft ground10.1061/(ASCE)GT.1943-5606.0000823 ↗
23. Modeling of tunneling-induced ground surface movements using stochastic medium theory10.1016/j.tust.2003.07.002 ↗