journal article·2022-04-05Open access

Investigation of the Power Quality Concerns of Input Current in Single-Phase Frequency Step-Down Converter

Naveed Ashraf, Ghulam Abbas, Nasim Ullah, Ahmad Aziz Al-Ahmadi, Ali Raza, Umar Farooq, Mohsin Jamil

Applied Sciences· Volume 12· Issue 7

Abstract

Single-phase direct frequency converters are gaining attraction at the research and academic level as they are rapidly getting space over conventional multistage converters. The converters developed with a rectification and inversion process using a DC-link level are examples of multistage converters with some serious concerns such as an increase in the overall weight, losses, and cost. They also suffer from the low-reliability issue due to the issues involved with DC-link capacitors and problems linked with electromagnetic interference (EMI) caused by high-frequency pulse width modulation (PWM) switching. These problems are addressed with line frequency switching cycloconverters. In these converters, the power quality of the output voltage is improved by governing the amplitude of some selected output pulses or half-cycles. For this purpose, a low-frequency multiple tapping transformer may be used to obtain various voltage levels. However, its use is the main source of increased overall weight, losses, cost, and volume. In transformer eliminated topologies, high-frequency PWM control can be employed to control the magnitude of some selected half cycles of the output voltage. However, this approach may arise some problems related to EMI. In both control techniques, the attention is focused on the power quality of the output voltage only. The concern for the input current is ignored and not yet analyzed. This is one of the critical power quality concerns and requires further investigation. The magnitude control of the output half-cycles causes the variation in the amplitude of some half cycles of the input currents. As a result, all half cycles of the input current become non-symmetric. It generates harmonics that are always of low frequency and cannot be easily filtered out. It results in a high value of the harmonic factor (HF) of the input current. The improvement in the power quality of the output voltages severally degrades the power quality of the input currents. In this research, this problem is investigated with mathematically computed harmonic coefficients with a pulse selective approach. Also, a simple single-phase cycloconverter is introduced to improve the power quality index of the input current. The overall analysis is supported by the results obtained from a Simulink-based environment and a practically constructed prototype.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Multilevel Inverters and Converters · Advanced DC-DC Converters · Induction Heating and Inverter Technology

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Electrical Engineering, The University of Lahore, Lahore 54000, Pakistan

Department of Electrical Engineering, College of Engineering, Taif University, Taif 21944, Saudi Arabia

Department of Electrical Engineering, University of Engineering and Technology, Lahore 54000, Pakistan

Department of Electrical Engineering, University of the Punjab, Lahore 54590, Pakistan

Department of Electrical and Computer Engineering, Faculty of Engineering and Applied Science, Memorial University of Newfoundland, St. John’s, NL A1B3X5, Canada

Funding

Taif University Researchers Supporting Project number (TURSP-2020/121), Taif University, Taif, Saudi Arabia

References (22)

Show source-provided references
1. A Single-Phase AC/DC/AC Converter with Unified Ripple Power Decoupling10.1109/TPEL.2017.2707443 ↗
2. Power Decoupling Control for Capacitance Reduction in Cascaded-H-Bridge-Converter-Based Regenerative Motor Drive Systems10.1109/TPEL.2018.2818719 ↗
3. Chen, Y.C., Chen, L.R., Lai, C.M., Lin, Y.C., and Kuo, T.J. (2020). Development of a DC-Side Direct Current Controlled Active Ripple Filter for Eliminating the Double-Line-Frequency Current Ripple in a Single-Phase DC/AC Conversion System. Energies, 13.10.3390/en13184772 ↗
4. Technical evaluation and practical experience of high-power grinding mill drives in mining applications10.1109/TIA.2005.847321 ↗
5. Current-Source Converter and Cycloconverter Topologies for Industrial Medium-Voltage Drives10.1109/TIE.2008.924175 ↗
6. Modeling and Evaluation of Cycloconverter-Fed Two-Stator-Winding SAG Mill Drive Part I: Modeling Options10.1109/TIA.2014.2375385 ↗
7. A Modified Single-Phase Quasi-Z-Source AC–AC Converter10.1109/TPEL.2011.2157362 ↗
8. A New Class of Single-Phase High-Frequency Isolated Z-Source AC–AC Converters with Reduced Passive Components10.1109/TPEL.2017.2686903 ↗
9. Single-Phase Safe-Commutation Trans-Z-Source AC–AC Converter With Continuous Input Current10.1109/TIE.2017.2764876 ↗
10. Direct Single-Phase AC–AC Converters Based on Series Impedance Networks10.1109/TPEL.2018.2807128 ↗
11. A Single-Phase Buck–Boost Matrix Converter With Only Six Switches and Without Commutation Problem10.1109/TPEL.2016.2553044 ↗
12. Ashraf, N., Izhar, T., Abbas, G., Balas, V.E., Balas, M.M., Lin, T.C., Asad, M.U., Farooq, U., and Gu, J. (2019). A Single-Phase Buck and Boost AC-to-AC Converter with Bipolar Voltage Gain: Analysis, Design, and Implementation. Energies, 12.10.3390/en12071376 ↗
13. Unified Non-Inverting and Inverting PWM AC–AC Converter With Versatile Modes of Operation10.1109/TIE.2016.2615593 ↗
14. Overview of Three-Stage Power Converter Topologies for Medium Frequency-Based Railway Vehicle Traction Systems10.1109/TVT.2019.2895500 ↗
15. Kumar, A., Sadhu, P.K., Mohanta, D.K., and Reddy, M.J.B. (2018). An effective switching algorithm for single phase matrix converter in induction heating applications. Electronics, 7.10.3390/electronics7080149 ↗
16. Ashraf, N., Izhar, T., Abbas, G., Awan, A.B., Alghamdi, A.S., Abo-Khalil, A.G., Sayed, K., Farooq, U., and Balas, V.E. (2020). A New single-phase direct frequency controller having reduced switching count without zero-crossing detector for induction heating system. Electronics, 9.10.3390/electronics9030430 ↗
17. A Compact and Cost Efficient Multiconverter for Multipurpose Applications10.1109/ACCESS.2020.2992986 ↗
18. Ashraf, N., Abbas, G., Abbassi, R., and Jerbi, H. (2021). Power Quality Analysis of the Output Voltage of AC Voltage and Frequency Controllers Realized with Various Voltage Control Techniques. Appl. Sci., 11.10.3390/app11020538 ↗
19. Uddin, M., Biswas, S.P., Islam, M., Anower, M., Kouzani, A.Z., and Mahmud, M.A. (2020). A new generalized step-down single-stage AC/AC power converter. Sustainability, 12.10.3390/su12219181 ↗
20. Islam, T., Fayek, H.H., Rusu, E., and Rahman, F. (2021). Triac Based Novel Single Phase Step-Down Cycloconverter with Reduced THDs for Variable Speed Applications. Appl. Sci., 11.10.3390/app11188688 ↗
21. Ashraf, N., Abbas, G., Ullah, N., Al-Ahmadi, A.A., Yasin, A.R., Awan, A.B., and Jamil, M. (2022). A Transformerless AC-AC Converter with Improved Power Quality Employed to Step-Down Power Frequency at Output. Energies, 15.10.3390/en15020667 ↗
22. Ashraf, N., Abbas, G., Ullah, N., Alahmadi, A.A., Awan, A.B., Zubair, M., and Farooq, U. (2021). A Simple Two-Stage AC-AC Circuit Topology Employed as High-Frequency Controller for Domestic Induction Heating System. Appl. Sci., 11.10.3390/app11188325 ↗