journal article·2021-09-08Open access

Tensile Creep of Cement and Concrete Composites: Monitoring by Means of 2D-Digital Image Correlation

Andina Sprince, Tomass Kozlovskis, Rihards Gailitis, Juozas Valivonis, Kinga Korniejenko, Arnaud Castel

Applied Sciences· Volume 11· Issue 18

Abstract

Creep and shrinkage of Cement and Concrete Composites (CCC) are significant properties that need to be considered to use these materials in practice. Many previous scientific studies revealed CCC creep characteristics under sustained compression and shrinkage, using traditional test methods from design standards. Because of the complexity of experimental procedures, CCC creep in tension has not been studied as close. Furthermore, there is no unified standard that proposes applicable testing methods or specific testing apparatus. This study examines the suitability of 2D—Digital Image Correlation (DIC) to observe the creep deformations of specimens under tension. Ordinary Portland cement (OPC) mortar with 1% polyvinyl alcohol (PVA) fibres has been investigated in the research. Compact tension (CT) specimens 150 × 150 × 12 mm (with a notch) were used. Creep deformations under sustained uniaxial tension (applied loading corresponding to 60% of the ultimate strength) were measured. DIC images were captured using an entry/mid-level DSLR camera. Results show that DIC is suitable for studying uniaxial tensile creep of cement and concrete composites. Deformation of specimens in tension was similar to that measured using the conventional method (using surface-attached gauges).
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Innovative concrete reinforcement materials · Concrete Properties and Behavior · Concrete and Cement Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Civil Engineering, Riga Technical University, LV-1658 Riga, Latvia

Department of Reinforced Concrete Construction structures and Geotechnics, Vilnius Gediminas Technical University, LT-10223 Vilnius, Lithuania

Faculty of Material Engineering and Physics, Cracow University of Technology, 31-864 Cracow, Poland

School of Civil and Environmental Engineering, University of Technology Sydney (UTS), Sydney, NSW 2007, Australia

Funding

Narodowa Agencja Wymiany Akademickiej · State Education Development Agency Republic of Latvia

References (46)

Show source-provided references
1. (2011). CEN. EN 197-1, British Standards Institution. Cement Part 1: Composition, Specifications and Conformity Criteria for Common Cements.
2. Use of cement in concrete according to European standard EN 206-110.1016/j.hbrcj.2012.08.001 ↗
3. (2003). ASTM C125-03, ASTM International. Standard Terminology Relating to Concrete and Concrete Aggregates.
4. ACI (2021, August 27). Aci Ct-18. ACI Concrete Terminology. ACI CT-18. Available online: https://www.concrete.org/store/productdetail.aspx?ItemID=CT18&Format=DOWNLOAD&Language=English&Units=US_Units.
5. Garcia-Lodeiro, I., Palomo, A., and Fernández-Jiménez, A. (2015). An overview of the chemistry of alkali-activated cement-based binders. Handbook of Alkali-Activated Cements, Mortars and Concretes, Elsevier.10.1533/9781782422884.1.19 ↗
6. Alkaline Activation of Different Aluminosilicates as an alternative to Portland Cement: Alkali Activated Cements or Geopolymers10.4067/S0718-50732017000200001 ↗
7. Microscopic features of non-hydraulic calcium silicate cement paste and mortar10.1016/j.cemconres.2017.07.001 ↗
8. Mehta, P.K., and Monteiro, P.J. (2014). Concrete: Microstructure, Properties, and Materials, McGraw-Hill Education.
9. Investigate road performance using polymer modified concrete10.1016/j.matpr.2020.12.290 ↗
10. Testing and modelling the creep of cracked macro-synthetic fibre reinforced concrete (MSFRC) under flexural loading10.1617/s11527-016-0795-7 ↗
11. Modelle zur Vorhersage des Schwindens und Kriechens von Beton: Teil 1: Analyse des Schwindmodells in DIN EN 1992-1-1:2011 und neuer Ansatz im Eurocode 2 prEN 1992-1-1:202010.1002/best.202000082 ↗
12. Reliability of prestressed concrete structures considering creep models10.1080/15732479.2013.835831 ↗
13. Moga, C., Gutiu, S., Danciu, A., and Suciu, M. (July, January 30). Concrete Shrinkage Stresses and Thermal Effects in the Composite Girders According To Eurocodes. Proceedings of the 16th International Multidisciplinary Scientific GeoConference SGEM 2016, Albena, Bulgaria. ISSN 1314-2704.
14. Neville, A.M., Dilger, W.H., Walter, H., and Brooks, J.J. (1983). Creep of Plain and Structural Concrete, Construction Press.
15. Atrushi, D.S. (2003). Tensile and Compressive Creep of Early Age Concrete: Testing and Modelling. [Ph.D. Thesis, The Norwegian University of Science and Technology].
16. Drying shrinkage of alkali activated binders cured at room temperature10.1016/j.conbuildmat.2018.12.223 ↗
17. The Pickett Effect at Early Age and Experiment Separating its Mechanisms in Tension10.1007/BF02533082 ↗
18. Risk of early age cracking in geopolymer concrete due to restrained shrinkage10.1016/j.conbuildmat.2019.116840 ↗
19. Mouton, C.J., and Boshoff, W.P. (2012, January 19–21). Initial study on the tensile creep of cracked steel fibre reinforced concrete. Proceedings of the 8th RILEM International Symposium on Fibre Reinforced Concrete: Challenges and Opportunities (BEFIB 2012), Guimarães, Portugal.
20. Structural phenomenon based theoretical model of concrete tensile behavior at different stress-strain conditions10.1016/j.jobe.2020.101594 ↗
21. Direct dynamic tensile study of concrete materials based on mesoscale model10.1016/j.ijimpeng.2020.103598 ↗
22. Experiments on drying shrinkage and creep of high performance hybrid-fiber-reinforced concrete10.1016/j.cemconcomp.2019.103481 ↗
23. Tensile creep of macro-synthetic fibre reinforced concrete (MSFRC) under uni-axial tensile loading10.1016/j.cemconcomp.2014.08.002 ↗
24. Establishment of fiber factor for rheological and mechanical performance of polyvinyl alcohol (PVA) fiber reinforced mortar10.1016/j.conbuildmat.2020.120347 ↗
25. Tensile stress-crack width law for steel fibre reinforced self-compacting concrete obtained from indirect (splitting) tensile tests10.1016/j.cemconcomp.2014.12.010 ↗
26. Strain rate effects on steel fibre concrete in uniaxial tension10.1016/0262-5075(87)90002-9 ↗
27. Flexural and shear behaviors of steel and synthetic fiber reinforced concretes under quasi-static and pseudo-dynamic loadings10.1016/j.conbuildmat.2019.117659 ↗
28. A novel indirect tensile test method to measure the biaxial tensile strength of concretes and other quasibrittle materials10.1016/j.cemconres.2008.02.002 ↗
29. 3D meso-scale modelling of concrete material in spall tests10.1617/s11527-014-0281-z ↗
30. Direct tension test of concrete
31. Liao, W.C., Chen, P.S., Hung, C.W., and Wagh, S.K. (2020). An innovative test method for tensile strength of concrete by applying the strut-and-tie methodology. Materials, 13.10.3390/ma13122776 ↗
32. Recommendation of RILEM TC 232-TDT: Test methods and design of textile reinforced concrete: Uniaxial tensile test: Test method to determine the load bearing behavior of tensile specimens made of textile reinforced concrete10.1617/s11527-016-0839-z ↗
33. (2012). ISO 9513:2012. Metallic Materials—Calibration of Extensometer Systems Used in Uniaxial Testing. Technical Committee: ISO/TC 164/SC 1 Uniaxial testing: France, International Organization for Standartization.
34. Jones, E.M., and Iadicola, M.A. (2018). A good practices guide for digital image correlation. Int. Digit. Image Correl. Soc., 10.10.32720/idics/gpg.ed1 ↗
35. 3D digital image correlation methods for full-field vibration measurement10.1016/j.ymssp.2010.08.013 ↗
36. Digital image correlation (DIC) for measurement of strains and displacements in coarse, low volume-fraction FRP composites used in civil infrastructure10.1016/j.compstruct.2019.01.024 ↗
37. Application of 2D digital image correlation for displacement and crack width measurement on RC elements
38. lin, Hsu, T.T.C.; Yang, H.C.; Lu, H.J.; Chang, C.C. Image analysis method for crack distribution and width estimation for reinforced concrete structures10.1016/j.autcon.2018.03.012 ↗
39. Vision-based change detection for inspection of tunnel liners10.1016/j.autcon.2018.03.020 ↗
40. GOM Company (2015). GOM Correlate Professional V8 SR1 Manual Basic—Inspection—3D Testing. Manual, 49, 1–127.
41. International Organization for Standartization (2003). ISO 7539-9:2003 Corrosion of Metals and Alloys-Stress Corrosion Cracking-Part 9: Preparation and Use of Pre-Crack Specimens for Tests under Rising Load or Rising Displacement, International Organization for Standartization.
42. ASTM (2016). E647-Standard Test Method for Measurement of Fatigue Crack Growth Rates, ASTM.
43. ASTM (2012). ASTM E399-12-Standard Test Method for Linear-Elastic Plane-Strain Fracture Toughness K Ic of Metallic Materials 1, ASTM.
44. Measurement of R-curve in clay brick blocks using optical measuring technique10.1016/j.engfracmech.2014.04.007 ↗
45. Andina, S., and Kozlovskis, T. (2020). Experimental Methods and Apparatus for Investigation of Cement Composites’ Creep, Shrinkage, and Cracking. Summary, Riga Technical University.
46. Tada, H. (1973). Stress Analysis of Cracks Handbook, ASME Press. [3rd ed.].