journal article·2022-09-25Open access

Evaluation of Viscoelastic Adhesion Strength and Stability of Composite Waterproofing Sheet Using Non-Hardening Viscoelastic Synthetic Polymer-Based Rubber Gel

Junhong Jeon, Kyuhwan Oh, Sooyeon Kim, Bo Jiang, Xingyang He, Sangkeun Oh

Applied Sciences· Volume 12· Issue 19

Abstract

Recently, a non-hardening type synthetic polymerized rubber gel (hereinafter referred to as NHV-SPRG) composite waterproofing sheet has been used on construction site as a new waterproofing technology. In this study, a test method is proposed in which a composite waterproof sheet is attached to an area of 150 mm in length and 100 mm in width on the mortar-based substrate specimen, and subsequently peeled off at 180 ° vertically to measure the “peel load (N)” at 10 points of 10 mm intervals (P1~P10, from 30 mm point to 120 mm point). Value obtained by dividing the average value of the measured peeling load by a width of 100 mm was defined as “viscoelastic adhesion strength (N/mm)”. The viscoelastic adhesive strength evaluated for the NHV-SPRG composite waterproof sheet of 4 types (VG-1, VG-2, VG-3, VG-4) was an average of 1.99 N/mm. To examine the effectiveness of the viscoelastic adhesive strength, the adhesion stability was evaluated based on the peel load’s coefficient of variation, grade of the linear regression line of the peel load, and peel load percent relative range in peel load for each section of the composite waterproofing layer. As a result, the VG-2 type was measured to have the highest viscoelastic adhesive strength, but the VG-1 type was confirmed to have the highest adhesive stability. Considering these results, it is judged that even a product with high adhesion can have varying stability in terms of performance that can affect construction precision. The test method and performance standard value for the viscoelastic adhesion strength proposed as an evaluation index through this study are expected to be used as a quality control standard to secure the on-site adhesion stability of the NHV-SPRG composite waterproof sheet.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Architecture, Graduate School, Seoul National University of Science and Technology, 232 Gongneung-ro, Nowon-gu, Seoul 01811, Korea

Construction Technology Research Institute, Seoul National University of Science and Technology, 232 Gongneung-ro, Nowon-gu, Seoul 01811, Korea

School of Civil Engineering and Environment, Hubei University of Technology, No. 28, Nanli Road, Hong-Shan District, Wuchang, Wuhan 430068, China

School of Architecture, Seoul National University of Science & Technology, 232 Gongneung-ro, Nowon-gu, Seoul 01811, Korea

Funding

Major Technical Innovation Project

References (19)

Show source-provided references
1. Yoo, J.Y., Kim, S.Y., and Oh, S.K. (2020). Waterproofing Performance Grade Proposal through Standard Test Result Comparison of Self Adhesive Rubberized Asphalt Sheet. Appl. Sci., 10.10.3390/app10217857 ↗
2. Influence of Nanomodified Waterproofing Agent on the Performance of Rigid Waterproof Concrete in Underground Engineering10.1155/2022/2966551 ↗
3. Hamada, M., Kishitani, K., Koike, M., and Kariya, H. (2022). Study on Prevention of Breakage in Asphalt Waterproofing, National Research Council Canada.
4. Assessment of the Selection of Asphalt Binder for Full Cross-Section Asphalt Waterproof Layer in High-Speed Railway Ballastless Track10.1061/(ASCE)MT.1943-5533.0003772 ↗
5. A Study on Guidelines and Selection Methods of Adequate Materials for Repair of Water-Leakage Cracks in Concrete Structures
6. Leakage Situation and Main Leakage Areas of Domestic Residential Building Underground Parking Lots
7. Sarnowski, M., Radziszewski, P., Kowalski, K.J., and Król, J.B. (2014, January 28–30). Impact of high process temperature on viscoelastic properties of polymer modified bitumen in waterproofing and bridge pavements. Proceedings of the International Conference on Road and Rail Infrastructure CETRA, Split, Croatia.
8. Rheology Applied to Investigate Roofing Membranes: The Case of an Ecological Alternative
9. Ahn, D.S., Oh, K.H., Park, J.S., and Oh, S.K. (2018). Viscosity and Waterproofing Performance Evaluation of Synthetic Polymerized Rubber Gel (SPRG) after Screw Mixing. Appl. Sci., 8.10.3390/app8101989 ↗
10. Adhesion between a Viscoelastic Material and a Solid Surface10.1021/ma021759t ↗
11. Modelling of Love Waves in Fluid Saturated Porous Viscoelastic Medium resting over an Exponentially Graded Inhomogeneous Half-space Influenced by Gravity
12. A Study on Guidelines for the Repair of Water-Leakage Cracks in Concrete Structures10.5345/JKIC.2010.12.6.097 ↗
13. Oh, S.K. (2022, May 18). Cause Analysis and Leakage Repair Material and Method Selection for Leakage Crack Repair. Construction Management News, 4 March 2012; pp. 74–81. Available online: http://www.ekacem.or.kr/pds/gamribull/2012/201202/%EA%B9%80%EB%A6%AC3-4%EC%9B%94-%EB%B0%A9%EC%88%98%EA%B8%B0%EC%88%A0%EC%9E%90%EB%A3%8C.pdf.
14. Development and Study on the Future Employment of Waterproofing Design Guideline for Leakage Prevention of Residential Underground Structure
15. (2017). Non-Curable Rubber Modified Asphalt Coating for Waterproofing. 91.120.30. (Standard No. JC/T 2428-2017).
16. (2016–2017). International Organization for Standardization Technical Committee 71 Subcommittee 7, ISO TS 16774:2011 Parts 1–6, ISO. Guidelines for the Repair of Water-leakage Cracks in Concrete Structures.
17. Dennis, L. (2022, July 18). Bean, Epoxy-Resin Grouting of Cracks in Concrete; Department of the Army—Final Report; 1985. Available online: https://apps.dtic.mil/dtic/tr/fulltext/u2/a164306.pdf.
18. Korea Land & Housing Corporation (2017). Establishment of Measures to Improve Quality of House Waterproofing Methods for Zero Defects in Quality Management, Public Housing Project Office.
19. Pro, O. (2005, January 5–7). Water Control using polyurethane resins. Proceedings of the 9th International Mine Water Association Congress Proceedings, Oviedo, Spain.