journal article·2018-02

Corrosion performance of ZrN/ZrO 2 multilayer coatings deposited on 304 stainless steel using multi-arc ion plating

Zhefeng Lei, Qingqing Zhang, Xiaodong Zhu, Dayan Ma, Fei Ma, Zhongxiao Song, Yong Qing Fu

Publisher page

Abstract

Coatings of single-layer ZrN, bilayer and multilayer ZrN/ZrO2 were deposited onto 304 stainless steel using a multi-arc ion plating technique, and their corrosion properties were tested in various solutions of 3.5 wt% sodium chloride (NaCl), 10 wt% and 20 wt% hydrochloric (HCl) acids, respectively.Results showed that the single-layer ZrN coating resisted the corrosion in the HCl acid with a concentration of 10 wt%, and the multilayer ZrN/ZrO2 coating acted as an effective protective layer in 20 wt% HCl solution. Polarization curve of the bilayer ZrN/ZrO2 coated specimens showed the lowest corrosion current density in 3.5 wt% NaCl and 20 wt% HCl solutions. However after polarization tests, the bilayer coating showed severe delamination after exposed in air, due to the large coating stress and brittleness of oxide ceramic layer. The multilayer ZrN/ZrO2 coating exhibited similar corrosion potentials and corrosion current densities compared with those of the bilayer coating. However, there was hardly any microscopic failure observed on the surfaces of the multilayer coatings after tested in all chloride solutions, which is attributed to the combined effects including improvement in coating toughness due to the multilayer design and ZrN sub-layer, reduced coating stress, and good corrosion resistance from the ZrO2 sub layer.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Corrosion Behavior and Inhibition · High-Temperature Coating Behaviors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (26)

Show source-provided references
1. Wear protection potential of TiN coatings for 304 stainless steels used in rotating parts during olive oil extraction10.1016/j.surfcoat.2016.07.067 ↗
2. Effect of composition and thickness on corrosion behavior of TiN and ZrN thin films10.1016/0257-8972(93)90285-V ↗
3. Hydrothermal corrosion of TiAlN and CrN PVD films on stainless steel10.1016/j.corsci.2004.08.009 ↗
4. Corrosion behaviors of TiN and Ti-Si-N (with 2.9 at.% and 5.0 at.% Si) coatings by electrochemical impedance spectroscopy10.1016/j.tsf.2016.08.005 ↗
5. Corrosion resistance of zirconium oxynitride coatings deposited via DC unbalanced magnetron sputtering and spray pyrolysis-nitriding10.1016/j.apsusc.2014.11.168 ↗
6. Corrosion resistance and hemocompatibility of multilayered Ti/TiN-coated surgical AISI 316L stainless steel10.1016/j.matlet.2005.06.058 ↗
7. Wear and corrosion resistance of CrN/TiN superlattice coatings deposited by a combined deep oscillation magnetron sputtering and pulsed dc magnetron sputtering10.1016/j.apsusc.2015.05.110 ↗
8. Characterization and performance of AlTiN, AlTiCrN TiN/TiAlN PVD coated carbide tools while turning SS 30410.1080/10426914.2014.984217 ↗
9. Corrosion resistance of ZrNxOy thin films obtained by rf reactive magnetron sputtering10.1016/j.tsf.2004.08.091 ↗
10. Study of Fe2O3-ZrO2 interface of ZrO2 coating grown by hydrothermal process on stainless steel10.1016/j.surfcoat.2014.08.030 ↗
11. Multilayer (TiN, TiAlN) ceramic coatings for nuclear fuel cladding10.1016/j.jnucmat.2016.05.021 ↗
12. CrN/Cr multilayer coating on 316L stainless steel as bipolar plates for proton exchange membrane fuel cells10.1016/j.jpowsour.2011.09.091 ↗
13. Corrosion resistance of ZrO2–TiO2 nanocomposite multilayer thin films coated on carbon steel in hydrochloric acid solution10.1016/j.matchar.2015.08.010 ↗
14. Characterization of yttria-stabilized zirconia thin films grown by pulsed laser deposition (PLD) on various substrates10.1016/j.apsusc.2007.07.194 ↗
15. Thermal barrier coatings produced by chemical vapor deposition10.1016/S1468-6996(03)00048-2 ↗
16. Mechanical properties and impact resistance of multilayered TiAlN/ZrN coatings10.1016/j.surfcoat.2012.03.013 ↗
17. TiN-coated titanium as the bipolar plate for PEMFC by multi-arc ion plating10.1016/j.ijhydene.2011.04.123 ↗
18. Analysis on the corrosion behavior of DC53 tool steel coated by Ti–Al–C–N films via filtered cathodic arc deposition10.1016/j.tsf.2009.03.058 ↗
19. Electrochemical characteristics of steel coated with TiN and TiAlN coatings10.1016/S0010-938X(00)00057-3 ↗
20. Corrosion and wear behaviours of a reactive-sputter-deposited Ta2O5 nanoceramic coating10.1016/j.apsusc.2016.02.014 ↗
21. Corrosion of stainless steel coated with TiN, (TiAl)N and CrN in aqueous environments10.1016/S0010-938X(01)00102-0 ↗
22. Corrosion behavior and microstructure of electrodeposited nano-layered Ni–Cr coatings10.1016/j.tsf.2015.10.046 ↗
23. A study on the corrosion and erosion behavior of electroless nickel and TiAlN/ZrN duplex coatings on ductile iron10.1016/j.apsusc.2014.10.068 ↗
24. Microstructure and oxidation behavior of a Ni+CrAlYSiHfN/AlN multilayer coating fabricated by reactive magnetron sputtering10.1016/j.corsci.2015.12.012 ↗
25. Oxidation resistance of TiAlN/ZrN multilayer coatings10.1016/j.vacuum.2016.02.004 ↗
26. Active, passive and transpassive dissolution of In-718 alloy in acidic solutions10.1016/j.matchemphys.2003.11.025 ↗