journal article·2010-01

Charge-to-mass ratio and dendrite structure of diesel particulate matter charged by corona discharge

Tomoyuki Kuroki, Motoki Ishidate, Masaaki Okubo, Toshiaki Yamamoto

Carbon· Volume 48· Issue 1
Publisher page

Abstract

Abstract The electric charge of diesel particulate matter (DPM) from a corona discharge device is measured for understanding the electrical characteristics of the DPM; an electrostatic precipitator (ESP) is employed for trapping DPM. Exhaust gas from a diesel engine is sampled by isokinetic sampling, and DPM contained in the gas is charged by negative corona discharge. The charged DPM is collected by a Faraday cup, and its electric charge is measured by a Coulomb meter. In addition, the appearance of the collected DPM is observed using a scanning electron microscope. It is found that when the gas velocity is 0.28 m/s, the maximum charge-to-mass ratio of the DPM is −126 μC/g. The DPM appears to agglomerate into a large particle in the absence of corona discharge; however, the agglomerated DPM forms a dendrite structure in the presence of corona discharge. The dendrite structure causes an increase in the surface area of the agglomerated DPM. Therefore, the oxidation removal of the DPM trapped by the ESP by using ozone and nitrogen dioxide can be enhanced because an oxidation reaction occurs on the surface of the DPM.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aerosol Filtration and Electrostatic Precipitation · Combustion and Detonation Processes · Recycling and Waste Management Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (21)

Show source-provided references
1. Engines and exhaust after treatment systems for future automotive applications10.1016/j.ssi.2006.05.051 ↗
2. Catalytic performance of Pt/MOx loaded over SiC-DPF for soot oxidation10.1016/S0926-3373(02)00296-5 ↗
3. Particle emissions from diesel passenger cars equipped with a particle trap in comparison to other technologies10.1021/es051440z ↗
4. Preparation and characterization of porous cordierite pellets and use as a diesel particulate filter10.1016/j.seppur.2006.11.009 ↗
5. Regeneration of diesel particulate filter using nonthermal plasma without catalyst10.1109/TIA.2004.836126 ↗
6. Low-temperature soot incineration of diesel particulate filter using remote nonthermal plasma induced by a pulsed barrier discharge10.1109/TIA.2004.836129 ↗
7. Ceramic diesel particulate filters10.1111/j.1744-7402.2005.02044.x ↗
8. HRTEM study of diesel soot collected from diesel particulate filters10.1016/j.carbon.2006.08.005 ↗
9. Carbon particulate matter incineration in diesel engine emissions using indirect nonthermal plasma processing10.1016/j.tsf.2006.02.071 ↗
10. Measurements of ion concentration in gasoline and diesel engine exhaust10.1016/j.atmosenv.2003.12.007 ↗
11. Lee JH, Goto Y, Odaka M. Measurement of the diesel exhaust particle reduction effect and particle size distribution in a transient cycle mode with an installed diesel particulate filter (dpf). SAE Technical Paper 2002; 2002-01-1005.10.4271/2002-01-1005 ↗
12. Three-dimensional ionic wind and electrohydrodynamics of tuft/point corona electrostatic precipitator10.1109/TIA.2003.818983 ↗
13. Two-stage-type electrostatic precipitator re-entrainment phenomena under diesel flue gases10.1109/28.753627 ↗
14. Soot particle re-entrainment in a corona discharge reactor10.1299/jsmeb.43.602 ↗
15. Collection efficiency of ultrafine particles by an electrostatic precipitator under dc and pulse operating modes10.1109/28.793383 ↗
16. Collection of ultrafine diesel particulate matter (DPM) in cylindrical single-stage wet electrostatic precipitators10.1021/es060887k ↗
17. Electrostatic precipitation of carbon soot from diesel engine exhaust10.1109/TIA.1983.4504342 ↗
18. Sato S, Kimura M, Aki T, Koyamoto I, Takashima K, Katsura S, et al. Removal of diesel particles using an electrostatic precipitator with a barrier discharge electrode as a dust pocket. In: Proceedings of ESA/IEJ/IEEE-IAS/SFE joint conference on electrostatics 2006. UC Berkeley, California, USA: ESA/IEJ/IEEE-IAS/SFE; 2006. p. 754–62.
19. Effect of electrode shape on discharge current and performance with barrier discharge type electrostatic precipitator10.1016/S0304-3886(02)00177-8 ↗
20. Non-thermal plasma for diesel exhaust treatment10.1016/S0304-3886(02)00165-1 ↗
21. Influence of polarity and rise time of pulse voltage waveforms on diesel particulate matter removal using an uneven dielectric barrier discharge reactor10.1007/s11090-008-9134-2 ↗