Influence of the aggregate on the electrical conductivity of Portland cement concretes
Source abstract
Abstract
Abstract The electrical conductivity and compressive strength of several high-performance Portland concretes with different amounts of crushed aggregate and sand have been measured at early age in isothermal conditions (20 °C). The total aggregate volume fraction varied from 0 (plain paste) to 0.75 and a constant weight ratio (1.2) between crushed aggregate and sand was used. The w/c ratio was 0.37 and microsilica (in slurry form) and a superplasticizer in water solution were used. The time taken before the electrical conductivity began to drop correlated very well with the induction period. The drop of conductivity was slightly delayed by the aggregate. The analysis of the electrical data, by means of different numerical and analytical models [hard core soft shell model (HCSS), differential effective medium theory (DEMT), Lu–Torquato, Maxwell], allowed an estimate of the properties of the interfacial transition zone (ITZ). In particular, an ITZ thickness of about 9 μm and an ITZ to bulk conductivity ratio of ∼2.5 were found. The existence of a percolating pathway through the interfacial regions was found by both electrical measurement and modeling when the aggregate volume fractions exceeded 60%. Finally, a new relationship among electrical conductivity, compressive strength, and aggregate amount was derived.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Rock Mechanics and Modeling
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (30)
Show source-provided references
1. A. van Beek, Dielectric properties of young concrete-non-destructive dielectric sensor for monitoring the strength development of young concrete, PhD Thesis, Delft University of Technology, Delft, 2000.
2. Radio wave heating of concrete10.1016/S0008-8846(96)85003-4 ↗
3. Maturazione a microonde di materiali cementizi a elevate prestazioni
4. Metodi elettrici nella tecnologia di malte e calcestruzzi
5. Alexander · 1968 · vol. III · 152
6. Water-cement ratio versus strength: another look
7. Beziehung zwischen wasserzementwert, normfestigkeit des zements (DIN 1164) und betondruckfestigkeit
8. Quantitative characterization of the transition zone in high strength concretes10.1680/adcr.1988.1.4.230 ↗
9. Flat-aggregate Portland cement paste interfaces: I. Electrical conductivity models10.1016/0008-8846(91)90101-M ↗
10. Permeability of the cement-aggregate interface: influence of the type of cement, water/cement ratio and superplasticizer
11. The percolation of pore space in the cement paste/aggregate interfacial zone of concrete10.1016/0008-8846(95)00185-9 ↗
12. Water permeability and chloride ion diffusion in Portland cement mortars: relationship to sand content and critical pore diameter10.1016/0008-8846(95)00069-O ↗
13. Effect of the interfacial transition zone on the conductivity of Portland cement mortars10.1111/j.1151-2916.2000.tb01344.x ↗
14. Electrical properties of fluidified Portland cement mixes in the early stage of hydration10.1016/S0008-8846(00)00282-9 ↗
15. Utilization of impedance spectroscopy for studying the retarding effect of a superplasticizer on the setting of cement10.1016/S0008-8846(98)00110-0 ↗
16. K. van Breugel, Simulation of hydration and formation of structure in hardening cement-based materials, PhD Thesis (revised edition), Technical University Delft, 1997.
17. E.A.B. Koenders, Simulation of volume changes in hardening cement-based materials, PhD Thesis, Technical University Delft, 1997.
18. Computer modelling of the interfacial transition zone in concrete
19. Multi-scale analytical/numerical theory of the diffusivity of concrete10.1016/S1065-7355(98)00010-8 ↗
20. A hard core/soft shell microstructural model for studying percolation and transport in three-dimensional composite media NIST
21. A study of the differential scheme for composite materials10.1016/0020-7225(77)90058-1 ↗
22. Interfacial transport in porous media: application to D.C. electrical conductivity of mortars10.1063/1.360591 ↗
23. Nearest-surface distribution functions for polydispersed particle systems10.1103/PhysRevA.45.5530 ↗
24. Advancements in modelling the development of microstructure in cement pastes
25. A. Princigallo, Doctorate dissertation, Politechnic of Milan, Milano, 2002.
26. Correlating the deviation point between external and total chemical shrinkage with setting time and other characteristics of hydrating cement paste
27. The electrical conductance of liquid-fluidized beds of spheres10.1016/0009-2509(76)80034-6 ↗
28. On the conductivity and void fraction of gas dispersions in electrolyte solutions10.1007/BF00726089 ↗
29. Percolation and pore structure inmortars and concrete10.1016/0008-8846(94)90079-5 ↗
30. Multi-scale modeling of the diffusivity of mortar and concrete