Effect of Cu doping on the structural and electrochemical properties of lithium-rich Li1.25Mn0.50Ni0.125Co0.125O2 nanopowders as a cathode material
Source abstract
Abstract
Abstract Lithium- manganese-rich oxides are believed to be suitable candidate for cathode materials in the next generation of lithium-ion batteries. However, they have some disadvantages such as low initial coulombic efficiency, low rate capacity, and deficient cyclability. Different approaches such as elemental doping and surface coating have been adopted to overcome these shortcomings. In this study, Cu-doped Li1.25Mn0.50Ni0.125Co0.125O2 was synthesized by sol-gel method. The prepared samples were characterized using thermal analysis, X-ray diffraction, Fourier transform infrared spectroscopy, surface area analysis, and field emission scanning electron microscopy. Galvanostatic charge-discharge measurement and electrochemical impedance spectroscopy were also conducted to investigate the electrochemical performance of the prepared samples. The XRD patterns revealed that all the samples had two phase structures. By doping Cu, the lattice parameters and the volume of the samples changed. The first discharge capacity of the doped samples was found to be lower than that of the undopped sample. In comparison with the pristine material, Cu-doped ones displayed better cycling performance and rate capability. The Li1.25Mn0.50Ni0.125Co0.125-xCuxO2 sample (with x = 0.05), which delivers an initial discharge capacity of 225.2 mAhg−1 at 0.1 C, was found to have the highest capacity retention with the best cycling performance (207.4 mAhg−1), after 50 cycles. The optimum performance of the doped samples could be related to its lower charge transfer resistance and better structural stability.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Battery Materials · Extraction and Separation Processes · Supercapacitor Materials and Fabrication
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (52)
Show source-provided references
1. Advanced electrodes for high power Li-ion batteries10.3390/ma6031028 ↗
2. Preparation and electrochemical performance of Li-rich cathode material Li1.17 [Ni0.17Co0.17Mn0.50] O2 synthesized by solid state method via acetate precursor for Li-ion batteries10.1016/S1452-3981(23)11146-1 ↗
3. Improved electrochemical performance of Li1.2Ni0.2Mn0.6O2 cathode material for lithium ion batteries synthesized by the polyvinyl alcohol assisted sol-gel method10.1016/j.ceramint.2016.11.016 ↗
4. Minimization of the cation mixing in Li1+ x (NMC) 1− xO2 as cathode material10.1016/j.jpowsour.2009.09.029 ↗
5. Synthesis, structure and electrochemical properties of lithium-rich cathode material Li1.2Mn0.6Ni0.2O2 microspheres10.1039/C5RA13504D ↗
6. Review and analysis of nanostructured olivine-based lithium rechargeable batteries: status and trends10.1016/j.jpowsour.2012.12.095 ↗
7. An ingenious design of lamellar Li1.2Mn0.54Ni0.13Co0.13O2 hollow nanosphere cathode for advanced lithium-ion batteries10.1016/j.electacta.2017.09.150 ↗
8. a new approach to improve the electrochemical performance of Li-rich cathode material by precursor pretreatment10.1016/j.jallcom.2016.12.054 ↗
9. High electrochemical performance of lithium-rich Li1.2Mn0.54NixCoyO2 cathode materials for lithium-ion batteries10.1016/j.matlet.2016.08.118 ↗
10. Sensitivity and intricacy of cationic substitutions on the first charge/discharge cycle of lithium-rich layered oxide cathodes10.1149/2.1061508jes ↗
11. Combustion synthesis and electrochemical performance of Li [Li0.2Mn0.54Ni0. 13Co0.13] O2 with improved rate capability10.1016/j.jpowsour.2012.11.091 ↗
12. Improved electrochemical performance of Li [Li0.2Mn0.54Ni0.13Co0.13] O2 cathode material by fluorine incorporation10.1016/j.electacta.2013.04.150 ↗
13. Countering the voltage decay in high capacity xLi2MnO3.(1–x) LiMO2 electrodes (M= Mn, Ni, Co) for Li+-Ion batteries10.1149/2.080206jes ↗
14. Synthesis and electrochemical properties of layer-structured 0.5 Li (Ni0.5Mn0.5) O2–0.5 Li (Li1/3Mn2/3) O2 solid mixture10.1016/S0378-7753(03)00804-8 ↗
15. Effect of surface modifications on the layered solid solution cathodes (1− z) Li [Li1/3Mn2/3] O2−(z) Li [Mn0. 5− yNi0. 5− yCo2y] O210.1016/j.ssi.2008.11.002 ↗
16. Synthesis and electrochemical characterization of Mg-doped Li-rich Mn-based cathode material10.1016/j.ceramint.2016.02.128 ↗
17. Enhanced electrochemical performance of Li-rich low-Co Li1. 2Mn0.56Ni0.16Co0.08− xAlxO2 (0≤ x≤ 0.08) as cathode materials10.1007/s40843-016-5097-7 ↗
18. Enhanced electrochemical performance of Ti-doped Li1.2Mn0.54Co0.13Ni0.13O2 for lithium-ion batteries10.1016/j.jpowsour.2016.03.101 ↗
19. Influence of Ru substitution on Li-rich 0.55 Li2MnO3·0.45 LiNi1/3Co1/3Mn1/3O2 cathode for Li-ion batteries10.1016/j.electacta.2012.06.118 ↗
20. Synthesis and properties of mesoporous Zn-doped Li 1.2 Mn 0.54Co0.13Ni0.13O2 as cathode materials by a MOFs-assisted solvothermal method10.1039/C7RA05106A ↗
21. Synthesis and electrochemical study of Zr-doped Li [Li0. 2Mn0. 54Ni0. 13Co0. 13] O2 as cathode material for Li-ion battery10.1016/j.ceramint.2015.08.104 ↗
22. Effect of copper doping on LiMnPO4 prepared via hydrothermal route10.1016/j.jpowsour.2011.03.073 ↗
23. Effect of Cu substitution on structures and electrochemical properties of Li [NiCo1− xCuxMn] 1/3O2 as cathode materials for lithium ion batteries10.1039/C5DT02552D ↗
24. Electronic, structural, and electrochemical properties of LiNixCuyMn2–x–y O4 (0< x< 0.5, 0< y< 0.5) high-voltage spinel materials10.1021/cm200042z ↗
25. Cupric ion substituted LiFePO4/C composites with enhanced electrochemical performance for Li-ion batteries10.1016/j.electacta.2014.07.030 ↗
26. Preparation and electrochemical characterization of flower-like Li1. 2Ni0. 17Co0. 17Mn0. 5O2 microstructure cathode by electrospinning10.1016/j.ceramint.2013.07.114 ↗
27. Nano-Crystalline Li1.2Mn0.6Ni0.2O2 prepared via amorphous complex precursor and its electrochemical performances as cathode material for lithium-ion batteries10.3390/ma9080661 ↗
28. Synthesis and electrochemical performance of lithium-rich cathode material Li [Li0.2Ni0.15Mn0.55Co0.1-xAlx] O210.1016/j.electacta.2016.01.066 ↗
29. Sol–gel preparation of Li-rich layered cathode material for lithium ion battery with polymer polyacrylic acid + citric acid chelators10.1007/s10971-016-3956-9 ↗
30. Improved electrochemical performance of Li [Li 0.2 Mn 0.54 Ni 0.13 Co 0.13] O2 by doping with molybdenum for Lithium battery10.1007/s10008-014-2706-6 ↗
31. Hierarchical microspheres and nanoscale particles: effects of morphology on electrochemical performance of Li1. 2Mn0.54Ni0.13Co0.13O2 cathode material for lithium-ion batteries10.1016/j.ssi.2016.12.021 ↗
32. the effect of polyanion-doping on the structure and electrochemical performance of Li-rich layered oxides as cathode for lithium-ion batteries10.1149/2.1031509jes ↗
33. Synthesis of layered cathode material 0.5 Li2MnO30.5Li2MnO3·0.5LiMn1/3Ni1/3Co1/3O2 by an improved co-precipitation method for lithium-ion battery10.1016/j.jpowsour.2014.01.068 ↗
34. Study of the surface modification of LiNi1/3Co1/3Mn1/3O2 cathode material for lithium ion battery10.1016/j.jpowsour.2011.06.039 ↗
35. Novel composites Li [LixNi0. 34− xMn0. 47Co0. 19] O2 (0.18≤ x≤ 0.21): synthesis and application as high-voltage cathode with improved electrochemical performance for lithium ion batteries10.1016/j.electacta.2012.07.069 ↗
36. Comparative studies of the phase evolution in M-doped LixMn1. 5Ni0. 5O4 (M= Co, Al, Cu and Mg) by in-situ X-ray diffraction10.1016/j.jpowsour.2014.03.122 ↗
37. Enhanced electrochemical performance of Li-rich Li1.2Mn0.52Co0.08Ni0.2O2 cathode materials for Li-ion batteries by vanadium doping10.1016/j.electacta.2016.05.119 ↗
38. Effects of chelating agents on the performance of Li1.2Mn0.54Ni0.13Co0.13O2 as cathode material for Li-ion battery prepared by sol–gel method10.1007/s10971-017-4338-7 ↗
39. Improved electrochemical properties of Li (Ni0.6Mn0. 2Co0.2) O2 by surface coating with Li1.3Al0.3Ti1.7 (PO4)310.1016/j.jpowsour.2015.12.055 ↗
40. Electrochemical performance of Li-rich Li [Li0.2Mn0.56Ni0.17Co0.07] O2 cathode stabilized by metastable Li2SiO3 surface modification for advanced Li-ion batteries10.1016/j.electacta.2018.01.130 ↗
41. Polyimide encapsulated lithium-rich cathode material for high voltage lithium-ion battery10.1021/am504796n ↗
42. Multifunctional ZrF4 nanocoating for improving lithium storage performances in layered Li [Li0. 2Ni0. 17Co0. 07Mn0. 56] O210.1016/j.ssi.2015.11.028 ↗
43. Calcium phosphate growth at electropolished titanium surfaces10.3390/jfb3020327 ↗
44. Synthesis of high voltage (4.9 V) cycling LiNi x Co y Mn 1− x− y O2 cathode materials for lithium rechargeable batteries10.1039/c0cp02258f ↗
45. Retarded phase transition by fluorine doping in Li-rich layered Li1.2Mn0.54Ni0.13Co0.13O2 cathode material10.1016/j.jpowsour.2015.02.085 ↗
46. Synthesis and electrochemical characterization of Zn-doped Li-rich layered Li [Li0.2Mn0.54Ni0.13Co0.13] O2 cathode material10.1016/j.ceramint.2015.05.102 ↗
47. Synthesize and electrochemical characterization of Mg-doped Li-rich layered Li [Li0.2Ni0.2Mn0.6] O2 cathode material10.1016/j.electacta.2013.05.145 ↗
48. Synthesis of spherical Li [Ni (1/3− z)Co(1/3− z)Mn (1/3− z)Mgz] O2 as positive electrode material for lithium-ion battery10.1016/j.electacta.2005.07.026 ↗
49. Microwave synthesis of novel high voltage (4.6 V) high capacity LiCuxCo1− xO2±δ cathode material for lithium rechargeable cells10.1016/j.jpowsour.2010.10.053 ↗
50. Synthesis and characterization of Cu doped LiCoO2 cathode material for lithium batteries using microwave assisted sol-gel synthesis10.4028/www.scientific.net/AMR.584.345 ↗
51. Electrochemical performance of zirconium doped lithium rich layered Li1.2Mn0.54Ni0.13Co0.13O2 oxide with porous hollow structure10.1016/j.jpowsour.2015.09.025 ↗
52. Symmetric cell approach and impedance spectroscopy of high power lithium-ion batteries10.1016/S0378-7753(00)00666-2 ↗