journal article·2016-03

Effect of Fe2O3 content on the electrical resistivity of aluminous porcelain applied to electrical insulators

D.H. Piva, R.H. Piva, J. Venturini, J. Ramon, V. Caldas, M.R. Morelli, C.P. Bergmann

Ceramics International· Volume 42· Issue 4
Publisher page

Abstract

Abstract In general, the presence of Fe 2 O 3 is claimed to reduce the insulating behavior of electrical porcelains, even if a rigorous proof has not yet been reported. The purpose of this study was to evaluate the real influence of Fe 2 O 3 content on the electrical resistivity of a standard aluminous porcelain widely used in insulators. The electrical resistivity for the composition with 3 wt% Fe 2 O 3 was higher than those found for standard aluminous porcelain, which was discussed in terms of the concentration of glassy and mullite phases. A reduction in the electrical resistivity was only observed in porcelain samples containing over 3 wt% Fe 2 O 3 . The presence of hematite phase was considered responsible for this reduction. These results suggest that low-cost raw materials with greater Fe 2 O 3 content should not extensively affect the insulating properties and could therefore be used in manufacturing aluminous electrical porcelain.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Recycling and utilization of industrial and municipal waste in materials production · Concrete and Cement Materials Research · Glass properties and applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. Buchanan · 1986
2. K. Sokolija, International Colloquium: Asset Management of Switching Equipment and New Trends in Switching Technologies, 2003, pp. 86–98
3. Study the flashover voltage for outdoor polymer insulators under desert climatic conditions10.1016/j.ejpe.2012.11.011 ↗
4. Characterizing of corona rings applied to composite insulators10.1016/j.epsr.2012.08.010 ↗
5. Polymer outdoor insulating materials – Part I: comparison of porcelain and polymer electrical insulation10.1109/57.591510 ↗
6. Stress and failure analysis of crimped metal-composite joints used in electrical insulators subjected to bending10.1016/j.compositesa.2009.02.020 ↗
7. Risk assessment of desert pollution on composite high voltage insulators10.1016/j.jare.2013.07.008 ↗
8. Development and characterization of triaxial electrical porcelains from Ugandan ceramic minerals10.1016/j.ceramint.2010.02.006 ↗
9. X-ray diffraction microstructure analysis of mullite, quartz and corundum in porcelain insulators10.1016/j.jeurceramsoc.2004.05.019 ↗
10. Fired porcelain microstructures revisited10.1111/j.1151-2916.1999.tb02282.x ↗
11. Fabrication and microstructure investigation of ultra-high-strength porcelain insulator10.1016/j.jeurceramsoc.2012.04.015 ↗
12. Small-polaron versus band conduction in some transition-metal oxides10.1080/00018737000101071 ↗
13. Electrical resistivity of porcelain in relation to constitution10.1016/S0272-8842(98)00006-6 ↗
14. About the important correlation between microstructure properties and product quality of strength-stressed high-voltage insulators
15. Microstructure properties and product quality of strength stressed high-voltage insulators
16. Effect of TiO2 on the mullite formation and mechanical properties of alumina porcelain10.1016/j.jeurceramsoc.2009.10.009 ↗
17. Improving the microstructural and physical properties of alumina electrical porcelain with Cr2O3, MnO2 and ZnO additives10.1007/BF00365167 ↗
18. Dielectric behaviour of porcelain in relation to constitution10.1016/S0272-8842(00)00029-8 ↗
19. Influence of Fe2O3 content on the dielectric behavior of aluminous porcelain insulators10.1016/j.ceramint.2013.02.071 ↗
20. Characterization of porcelain compositions using two china clays from Cameroon10.1016/j.ceramint.2006.01.025 ↗
21. R. Von Dreele, A. Larson, General structure analysis system (GSAS), Los Alamos National Laboratory Report LAUR 86–748, 2000
23. Accuracy in quantitative phase analysis of mixtures with large amorphous contents. The case of stoneware ceramics and bricks10.1107/S160057671400627X ↗
24. FIZ Karlsruhe, International Crystal Stucture Data (ICSD), Karlsruhe, Germany, 2000.
25. Microstructural development on firing illite and smectite clays compared with that in kaolinite10.1111/j.1551-2916.2005.00390.x ↗
26. Rietveld quantitative analysis of Buen Retiro porcelains
27. Porcelain-raw materials, processing, phase evolution, and mechanical behavior10.1111/j.1151-2916.1998.tb02290.x ↗
28. High-temperature phases developed in some kaolinite–mica–quartz clays
29. Iron incorporation in mullite10.1016/0272-8842(86)90034-9 ↗
30. Role of iron in mullite formation from kaolins by Mössbauer spectroscopy and Rietveld refinement10.1111/j.1151-2916.2003.tb03289.x ↗
31. Kingery · 1976
32. Reuse of ornamental rock-cutting waste in aluminous porcelain10.1016/j.jenvman.2010.10.060 ↗
33. D.C. Sinclair, Boletin de La Sociedad Espanola de Ceramica Y Vidrio, 65, 1995, pp. 55–66
34. Study of zircon or zirconia crystals addition in ceramic glazes by impedance spectroscopy10.1016/j.ceramint.2004.04.003 ↗
35. Predicting processing-sintering-related properties of mullite-alumina ceramic bodies based on Al-rich anodising sludge by impedance spectroscopy10.1016/j.jeurceramsoc.2003.12.026 ↗
36. The importance of phase purity in Ni–BaZr0.85Y0.15O3−δ cermet anodes – novel nitrate-free combustion route and electrochemical study10.1039/C2RA22301E ↗
37. Electroceramics: characterization by impedance spectroscopy10.1002/adma.19900020304 ↗
38. Study of yttria-stabilized zirconia-glass composites by impedance spectroscopy
39. Electric conductivity of glasses in the system Na2O/CaO/SiO2/Fe2O310.1016/j.jnoncrysol.2007.07.014 ↗
40. Thermal and electrical relaxation studies in Li(4+x)TixNb1−xP3O12 (0.0≤x≤1.0) phosphate glasses10.1016/j.solidstatesciences.2010.02.030 ↗
41. Ionic conduction in solids: comparing conductivity and modulus representations with regard to scaling properties10.1103/PhysRevB.63.024301 ↗
42. Study of dielectric behavior and electrical properties of hematite α-Fe2O3 doped with Zn10.2298/SOS1203307N ↗
43. Electrical resistivity of porcelain bodies with natural zeolite addition10.1016/j.ceramint.2009.10.029 ↗