journal article·2009-09

Fracture behaviour of Mg-PSZ ceramics: Comparative estimates

George A. Gogotsi

Ceramics International· Volume 35· Issue 7
Publisher page

Abstract

The mechanical behaviour of different Mg-PSZ ceramics is studied. Results of their edge fracture (EF) and single edge V-notch beam (SEVNB) tests are discussed. These inelastic ceramics exhibit nonlinear relations between the fracture load and the distance from the extreme point on the chip scar to the specimen edge. They also possess nonlinearly rising R-lines. It is established that the data points plotted in the EF base diagram fall below the baseline (lower barrier to the onset of fracture). By projecting these data points onto the baseline, fracture toughness values close to those of the matrix are determined. The limitations of conventional procedures for evaluating the mechanical behaviour of these ceramics were found out. It has been demonstrated that the EF test method can be quite adequate for enhancing the reliability of comparative fracture resistance estimates.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Aluminum Alloys Composites Properties · MXene and MAX Phase Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (25)

Show source-provided references
1. Thermal shock resistance and mechanical characterization of materials based on zirconia dioxide10.1007/BF01528077 ↗
2. Toughening of brittle solids by martensitic transformations10.1016/0001-6160(86)90052-0 ↗
3. Ceramic steel?10.1038/258703a0 ↗
4. Fracture toughness of ceramics and ceramic composites10.1016/S0272-8842(02)00230-4 ↗
5. Anderson · 1995
6. Fracture resistance of ceramics: base diagram and R-line10.1007/s11223-006-0039-0 ↗
7. Evaluation of fracture resistance of ceramics: Edge fracture tests10.1016/j.ceramint.2005.09.017 ↗
8. Partially stabilized ZrO2 and its behavior under load
9. Transformation toughening in zirconia-containing ceramics10.1111/j.1151-2916.2000.tb01221.x ↗
10. Influence of heating rate on the thermal strain induced fracture of Mg-PSZ samples
11. J. Kübler, Fracture toughness of ceramics using the SEVNB method, Round Robin VAMAS Report No.37/ ESIS Document D2-99, EMPA, Swiss Federal Laboratories for Materials Testing and Research, Dubendorf, Switzerland, September 1999.
12. Deformation behavior of ceramics10.1016/0955-2219(91)90005-K ↗
13. The use of brittleness measure (χ) to represent mechanical behaviour of ceramics10.1016/0272-8842(89)90025-4 ↗
14. Festigkeitsprobleme von keramischen Werkstoffen
15. ISO 23146, Fine ceramics (advanced ceramics, advanced technical ceramics) – Test methods for fracture toughness of monolithic ceramics – Single-edge V-notch beam (SEVNB) method, ISO, Switzerland, 2008.
16. Fracture barrier estimation by the edge fracture test method10.1016/j.ceramint.2008.10.026 ↗
17. Acoustic emission during micro- and macrocrack growth in Mg-PSZ10.1111/j.1151-2916.1991.tb07810.x ↗
18. Mechanical behaviour of a silicon nitride particulate ceramic composite10.1016/j.ceramint.2008.05.001 ↗
19. Toughening mechanisms for ceramics
20. Critical conditions in zirconia transformation toughening
21. Relationship between fracture toughness and phase assemblage in Mg-PSZ10.1111/j.1151-2916.1994.tb07031.x ↗
22. Relation of transformation temperature to the fracture toughness of transformation-toughened ceramics10.1007/BF01160553 ↗
23. Flaking toughness of advanced ceramics: ancient principle revived in modern times10.1179/mri.2006.10.2.179 ↗
24. Analysis of stress and strain near the end of a crack traversing a plate
25. Crack-growth resistance of microcracking brittle materials10.1111/j.1151-2916.1984.tb18842.x ↗