journal article·2013-12Open access

An experimental investigation of the enhanced oil recovery and improved performance of drilling fluids using titanium dioxide and fumed silica nanoparticles

Goshtasp Cheraghian, Mahmood Hemmati, Mohsen Masihi, Saeed Bazgir

Abstract

Abstract Nanotechnology has contributed to the technological advances in various industrial biomaterials and renewable energy production over the last decade. Recently, a renewed interest arises in the application of nanotechnology for the upstream petroleum industry such as exploration, drilling and production. In particular, the adding of nanoparticles to injection fluids may drastically benefit enhanced oil recovery, such as changing the properties of the fluid, wettability alternation of rocks, advanced drag reduction, strengthening sand consolidation, reducing the interfacial tension and increasing the mobility of the capillary-trapped oil. The feasibility of these methods depends on many factors such as flow mechanisms in porous media and porous medium properties at microscopic and macroscopic scales. Previous studies have indicated that the oil recovery from porous media may be substantially increased by the injection of miscible fluids. This all sounds great and waterflooding has been used successfully for decades; however, it is important to carefully design and appropriately operate the waterflood. Using nanoparticles in all samples has resulted in recovery increase. Among these applications of the study is nanoenhanced oil recovery which can be applied in many water-wet reservoirs dominated by inhibition mechanism to extract more fluid through really small caliber pores. In these experiments, two nanoparticles dissolved in water are injected into simulated environment, and also, the effect of these nanoparticles in water-base drilling typical fluid have been investigated. Using nanoparticles in all samples has resulted in recovery increase. Finally, considering the experiments, it is demonstrated that flows with nanoparticles and, in particular, titanium dioxide (TiO2) nanoparticles have the highest amount of recovery factors and thus using nanoparticles in waterflooding projects and even some in polymer flooding ones. Also, results of the other tests, regarding each typical drilling costs of each foot and importance of time in the operation, it is possible to replace technically and economically the ordinary addition (here, the widely used sodium hydroxide) with fumed silica nanoparticles in drilling fluid to prevent cement contamination of the drilling fluid. The advantages of nano-TiO2 are possessing suitable thermal transition qualities in the drilling fluid.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Enhanced Oil Recovery Techniques · Hydraulic Fracturing and Reservoir Analysis · Drilling and Well Engineering

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (13)

Show source-provided references
1. Romero-Zerón L: Advances in enhanced oil recovery processes, introduction to enhanced oil recovery (EOR) processes and bioremediation of oil-contaminated sites. Canada: InTech; 2012. 978–953–51–0629–6 978-953-51-0629-610.5772/2053 ↗
2. Kakac S, Pramuanjaroenkij A: Review of convective heat transfer enhancement with nanofluids. Int. J. Heat Mass Transf 2009, 52: 3187–3196. 26 March 26 March 10.1016/j.ijheatmasstransfer.2009.02.00610.1016/j.ijheatmasstransfer.2009.02.006 ↗
3. Alaskar M, Ames M, Connor S, Liu C, Cui Y, Li K, Horne R: Nanoparticle and microparticle flow in porous and fractured media: an experimental study. SPE Annual Technical Conference and Exhibition held in Denver, Colorado, USA. 2011. 30 October - 2 November 30 October - 2 November
4. Engeset B: Project thesis - the use of nanotechnology in the petroleum industry. Norwegian University of Science and Technology: Thesis; 2011.
5. Dong M, Ma S, Liu Q: Enhanced heavy oil recovery through interfacial instability: a study of chemical flooding for Brintnell heavy oil. J. Fuel 2009,88(6):1049–1056. 10.1016/j.fuel.2008.11.01410.1016/j.fuel.2008.11.014 ↗
6. Hongyan W, Xulong C, Jichao Z, Zhang A: Development and application of dilute surfactant-polymer flooding system for Shengli oilfield. J. Pet. Sci. Eng. 2010,65(1?2):45–50.
7. Wu J, He J, Tors?ter O, Zhang Z: Effect of nanoparticles on oil-water flow in a confined nanochannel: a molecular dynamics study. SPE International Oilfield Nanotechnology Conference, 12–14 June, Noordwijk 2012. SPE 156995 SPE 156995
8. Yadali Jamaloei B, Kharrat R: The performance evaluation of viscous-modified surfactant waterflooding in heavy oil reservoirs at varying salinity of injected polymer-contained surfactant solution. Iran. J. Chem. Chem. Eng 2012,31(1):99–111.
9. Yadali Jamaloei B, Kharrat R: Analysis of microscopic displacement mechanisms of dilute surfactant flooding in oil-wet and water-wet porous media. Transp. Porous Media 2010,81(1):1–19. 10.1007/s11242-009-9382-510.1007/s11242-009-9382-5 ↗
10. Yadali Jamaloei B, Kharrat R: The influence of pore geometry on flow instability and microscale displacement mechanisms of dilute surfactant flooding in mixed-wet porous media. J. Porous Media 2011,14(2):91. 10.1615/JPorMedia.v14.i2.1010.1615/JPorMedia.v14.i2.10 ↗
11. Suleimanov B, Ismalov F, Veliyev E: Nanofluid for enhanced oil recovery. J. Pet. Sci. Eng. 2011, 78: 431. 10.1016/j.petrol.2011.06.01410.1016/j.petrol.2011.06.014 ↗
12. Krishnamoortu R: Extracting the benefits of nanotechnology for the oil industry. JPT, Society of Petroleum Engineers 2006, 11: 24–25. November 2006 November 2006
13. Amanullah M, Al-Arfaj M, Al-Abdullatif Z: Preliminary test results of nano-based drilling fluid for oil and gas field application. Amsterdam, The Netherlands: SPE/IADC Drilling Conference and Exhibition; 2011:1–3.